CLEARANCE FITS INTERFERENCE FITS CLEARANCE AND INTERFERENCE FITS ØK XX 0.7500 ±.0020. T E+ 1.5018 1.5024 T -Ø .9997 .9993 Ø 1.0005 1.0000 1.2510 1.2500 1.5010 1.5000 XX LB -ØJ C-7492 .7484 XX DØ 7500 .7512 +.0010 G 1.2500 -.0000 1.2475 H 1.2469 XX Complete this chart from the information given above. TOLERANCE ON HOLE TOLERANCE ON SHAFT MINIMUM CLEARANCE MAXIMUM CLEARANCE A B Complete this chart from the information given above. C D TOLERANCE ON PART TOLERANCE ON SLOT MINIMUM INTERFERENCE MAXIMUM INTERFERENCE E F QI. DIMENSION SHAFT (J) TO HAVE A TOLERANCE OF .0012 AND A MINIMUM CLEARANCE OF .0025. Q2. DIMENSION BUSHING (K) TO HAVE A TOLERANCE OF .0010 AND A MAXIMUM INTERFERENCE OF .0016. Q3. DIMENSION SHAFT (J) TO HAVE A TOLERANCE OF .0012 AND A MINIMUM CLEARANCE OF .0014. Q4. DIMENSION BUSHING (K) TO HAVE A TOLERANCE OF .0008 AND A MAXIMUM INTERFERENCE OF .0022. Complete this chart from the information given above. G H ΟΙ Q2. Q3 Q4 J K CLEARANCE FITS (RUNNING OR SLIDING) CLEARANCE- A B 01.50 RC2 SLIDING FIT CLEARANCE- ध TRANSITION FITS (LOCATIONAL) CLEARANCE INTERFERENCE FITS (FORCE OR SHRINK) INTERFERENCE- TM Ø1.25 LC2 LOCATIONAL- ØE -Ø2.00 T CLEARANCE T Τρ TRANSITION- LT3 LOCATIONAL- TRANSITION нт Ø -Ø1.25 T G INTERFERENCE- LN2 LOCATIONAL 01.00. D INTERFERENCE -Ø 1.50 ØN ØJ T IK Complete this chart using the proper limit and fit tables. FNI FORCE FIT INTERFERENCE- 02.00 CO DIA LC2 LT3 LN2 FN4 SHRINK FIT ØE RC5 RUNNING FIT ØF FIT ØA RC2 Complete this chart using the proper limit and fit tables. ØB ØG Complete this chart using the proper limit and fit tables. ОС ØD ØH FIT ØL ØM ØN ØJ FNI RC5 ØK FN4 ØP

a) Three blocks A, B, and C and a grooved block D have dimensions a, b, c, and d as follows:       a= 1.500 ± 0.001 in        b= 2.000 ± 0.003 in         c= 3.000 ±  0.004 in        d= 6.520 ± 0.010 in Determine the mean gap ￣w and its tolerance. Determine the mean size of d that will assure that w ≥ 0.010 in. b) A 1-in-diameter rod, 3 ft long, of unknown material is found in a machine shop. A variety of inexpensive nondestructive tests are readily available to help determine the material, as described below with results in bracket: i. Visual inspection. (Dark gray, rough surface finish, moderate scale) ii. Check if it is attracted to a magnet. (Yes) iii. Measure Weight. (7.95lbf) iv. Inexpensive bending deflection test: Clamp one end in a vise, leaving 24 in cantilevered. (5/16in) v. Brinell hardness test. (HB = 200)

drawing is attached for reference

On attached drawing 11A017 ,What is the length of the dovetail slot?   All abbreviations are standard