choose the right answer and show your solution 5. THREE CAPACITORS HAVING THE SAME CAPACITANCE (C = 200microFARAD) ARE CONNECTED IN SERIES WITH A 9 VOLTS BATTERY.FIND THE TOTAL CAPACITANCE. a.) 66.67microFARAD b.) NONE OF THE CHOICES c.) 76.67microFARAD d.) 15000 FARAD NOTE : DON'T ANSWER NO. 5 7. WHAT ARE THE VALUES OF VOLTAGES ACROSS EACH CAPACITORS? (IN ITEM NUMBER 5) * a.) 9 VOLTS V2 = 6 VOLTS V3 = 3 VOLTS b.) NONE OF THE CHOICE c.) V1 3 VOLTS V2 = 3 VOLTS V3 = 3 VOLT d.) 3 VOLTS V2 = 6 VOLTS V3 = 9 VOLTS

Q: A transmission line that has a resistance per unit length of 5.40 x 10-40 /m is to be used to transm...

A:  Transmission line- Transmission Lines are the connection between the Generation busbar and the Dist...

Q: Determine the capacitor voltage in Volts (V), power in milliwatts (mW), and stored energy in microjo...

A: In this question,  At time t= 0 switch is open.  Find the voltage across the capacitor and power and...

Q: C1 L1 4.3µ 7.7m =>f = 23 kHz V1 C2 R1 6.8k 5.9µ AC 0.84 0 R2 140

A: Given, We have AC circuit. We have to find the required values. Please find the below attachments fo...

Q: 12. Determine the optimum frequency of operation of an antenna if it has -3 dB frequencies of 350 MH...

A:

Q: Design 0-9  counter with JK flip-flp  a) Draw the state diagram b) Draw the state table c) Draw t...

A: 0-9 counter means it is UP counter. Some points regarding up counter: (1JK flip-flop used different ...

Q: Determine the currents I,, I2, and Ip2 for the circuit below (assume practical diodes):

A:

Q: Ro Rs -1 V Figure P5.43

A: Finding The Source Voltage Vs 

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and b if R...

A:

Q: 1.63 Analyze the circuit of Fig. P1.63, and show that it gives v, = |v,]. Hint: investigate the case...

A:

Q: Explain why a ripple counter's maximum frequency limitation decreases as more FFs are added to the c...

A:

Q: Point charges 1 mC and -2 mC are located at (3, 2, - 1) and (-1,-1, 4), respectively. Calculate the ...

A:

Q: 2. Use superposition to find vo.

A:

Q: 1. One of the complicated parts of solving for the input impedance is the hyperbolic tangent of the ...

A:

Q: Q1. (b) A single-phase, 120 V, 60 Hz universal motor is operating at 1800 rpm and its armature curre...

A:

Q: Consider the RC filter circuit to the right. a) What are VR and Vc if the emf frequency is 10 kHz? b...

A:

Q: 2. Write simultaneous Laplace-transformed loop equations for the electrical net- works of Figure P1....

A:

Q: 8. Determine the truth table of the digital eircuit shown in the figure below and explain its operat...

A: We need to find out logic Operation of given circuit

Q: (b) The second circuit is an active filter. If Z, is a capacitor C, and Z, is a parallel RC circuit,...

A:

Q: A 3-phase, 400v, y-connected induction motor has an equivalent t-circuit consisting of r1=1w, x1=20 ...

A:

Q: Comment briefly on the relationship between input and output power at varying excitation levels and ...

A: Answer - It is an very important topic that we should know about the synchronous machine infinite bu...

Q: 3. A three-phase 60 Hz Wye connected, 2,000-kVA, 2,300-V alternator give a short circuit-test curren...

A: The solution is given below 

Q: An AC voltage of the form Av = 65 sin 330t where Av is in volts and t is in seconds, is applied to a...

A:

Q: Find the approximate collector current in the given transistor circuit. (B = 10 +V8B = 10 V +Vcc = 1...

A:

Q: solve for I1 and I2 given R1=R2=1k ohms, V1=5V, and V2=9V

A: This question belongs to circuit theory . It is based on the concept of kirchhoff's voltage law .  H...

Q: Ax = 2 N, Ay = -8 N , Az = 5 N Find: a) 4 ; b) A, ; and c) Au

A:

Q: Draw the on-load phasor diagram of the transformer and mention the parameters.

A:

Q: R + R R R-Ar R vo Find the expression for the gain, = f(R, Ar), using an ideal op amp model. vs

A:

Q: 1. Thevenin equivalent circuit. а D44 24V (+ Figure 1: a. Find VTH. b. Find Rth •

A:

Q: 3. Tristate buffers can also be used for bi-directional bus operation. This is the ability to transm...

A: Control system: In a system when the output quality is controlled by varying the input quality, the ...

Q: . When using superposition, what is the ideal internal resistance of a voltage source? The Thevenin ...

A: De activated sources can be replaced by their internal resistances in super position theorem.    

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals b and d if R1...

A: While calculating the equivalent resistance of the circuit, The resistance which is connected at ope...

Q: series circuit consists of a resistance of 10 ohms and a reactance of 5 ohms. Find the equivalent va...

A: We need to find out conductance and susceptance

Q: A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is located at P2(9, -5...

A: In this question, A point charge Q1 = 46 nC is located at P1(1,-4, -5) while a charge Q2= 31 nC is l...

Q: Make a Common Emitter Amplifier with Voltage Divider Bias  with:

A:

Q: 1. Simplify the following function using K-map A) F(w,x,y,z) = E (1,4,5,6,12,13,14) B) F(w,x,y,z) = ...

A:

Q: Discuss the effect of the sensor position in the pt326 controller on the open-loop system response (...

A: The process contained in the pt326 involves air that is drawn from the atmosphere by a centrifugal b...

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45° A

A: Given, Two magnitudes with angles , We have to draw the phasors. Please find the below attachment fo...

Q: Jx, 0<x<π, f(x) = Problem 4: 10, π<x< 2π;

A:

Q: (*- z) if 0 <rS 2r, f(x) = f(r +27) otherwise. Find its Fourier series.

A: We need to find Fourier series coefficient for given signal

Q: Find the power in the 10 A source. Find the power dissipated by 20-ohm resistor. Find the po...

A: The given circuit diagram is shown below:

Q: An unbalanced, three-phase, delta-connected load, is supplied by an alternator three-phase system gi...

A:

Q: Three unequal single-phase loads are

A: Given-Voltage rating= 230 VoltsFirst load takes connected across 1 and 2= 106A with 0.78 pf laggingS...

Q: Find Thevenin's Equivalent Circuit Relative to A and Band Max Power Transfer 2 mA 12V 2 k2 8 mA 1 ka...

A: The solution is given below 

Q: D5.49 The NMOS transistors in the circuit of Fig. P5.49 have V, = 0.4 V, µ„Cox=400 µA/V², 2 = 0, and...

A:

Q: 6. Draw a NAND circuit to implement the complement of the following function F(w,x,y,z) = E (0,1,2,3...

A:

Q: A 250v shunt motor giving 14.92kw at 1000r.p.m Takes an armature aurvrent of 75a The amature resista...

A:

Q: Answer the question B, no need to answer A

A: Answer -        

Q: 3. If all initial conditions of the networks of Figure P1.3 are zero, find v(t), t 2 0. 12 8 10 (a) ...

A:

Q: 5) A balanced Y-Y four-wire system has phase voltages Van = 120 20°, Vbn = 1202-120 , Ven = 120 Z120...

A:

Q: The deep wel pump motor is 50hp, 3-phase, 4- poles, 230volts, 60hz induction mator operating at 0.90...

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.