CE - 4510 HOMEVNORIK # O 40" 1) tes - SO00 psi CHECK Asmn & Et >0.005 FIND Mn 下 3° z8.s" 27 6-#10

Q: A) Only adding a wide surface load of great pressure (e.g. embankment). B) Only drilling a vertical ...

A: To Determine: The following separate, unrelated actions cause consolidation settlement in the clay l...

Q: 3,6 m 2.7 m 2400 N B C D 2.7 m 1.5 m F E 4.8 m

A:

Q: The railroad I-beam has dimensions as shown below. In reviewing these old designs, you have been ask...

A:

Q: A cylinder 10 cm in diameter is floating in water, it weighs 900 grams and is placed in a big cylind...

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of understandin...

Q: A cylindrical tank having a diameter of 40 cm in diameter and 20 cm height floats in mercury in a ve...

A:

Q: Show that Reynold’s Number is a dimensionless parameter. Describe the dye/ ink patterns created by e...

A:

Q: The couple-moment Mc in the system shown is 7500 kip-in, counterclockwise, 10 kip and the length of ...

A:

Q: A dynamical system is described by the following equations x + ax = 5a, x(0) = 3 and X(0) = 1 with a...

A: Given data : a=0.76 s= 0.66 x(0)= 3 x(0) = 1

Q: 275 kN/m 1.5m, 3m 3m

A:

Q: A simple curve has a radius of 220 m and angle of intersection of 128°. The curve is to be shifted b...

A:

Q: y Pg = 30 kN - 3 m- 4 m - 3 m – E В D Cp= 40 kN • m %3D

A: Draw SFD and BMD

Q: Knowing that the allowable stress (both in compression and tension) in section ABD is 80 MPa, determ...

A:

Q: Four pulleys are attached to the 50-mm-diameter aluminum shaft. If torques are applied to the pulle...

A: To determine the angle of rotation of pulley D relative to A.   Given, Diameter of the shaft (d) = 5...

Q: Draw HGL and EGL for the pipe shown in fig. Then Calculate the rate of flow through this pipeline an...

A:

Q: 45. Which paint contains polystyrene as a base? A. O Synthetic rubber B. O Enamel C. O Aluminium D. ...

A: Brief concept introduction- Paint- It is a chemical substance. It is used to coat the outer surface ...

Q: Question 4 1.0 metre Ye16RN/n Ground Water Table D= 37 degrees 2.5 metres Ysat = 18.39 kN/m Assume t...

A:

Q: Chapter 5, Reserve Problem 026 A solid aluminum [E = 70 GPa; a = 22.5 x 10 6/°C] rod (1) is connecte...

A: Given, T1=30°T2=45° For solid aluminiumE=70 GPaα=22.5×10-6/°C For solid bronzeE=100 GPaα=16.9×10-6/°...

Q: For the truss shown, determine the maximum axial stress experienced. 2.5P В 30° 1.5P 4m 45% A

A:

Q: The acceleration of a particle is defined by the relation a = -k/x. It has been experimentally deter...

A:

Q: 2.19 Determine the change in the kinematic viscosity of air that is heated from 10°C to 70°C. Assume...

A: Given data,  Standard atmospheric pressure.  Temperature 1 = 10 °C Temperature 2 = 70 °C   To find o...

Q: 4. Consider a standard flexural strength specimen of length L, width a, and depth a. Assume center p...

A:

Q: What is the maximum weight W D that the system could support if 150 mm 35° the maximum force that a ...

A:

Q: . Assume wall height to be 3.0 m openings at: a. common area Doors (0.9x2.1), windows (1.2x1.2) b. t...

A:

Q: Describe why effective stress is important when evaluating soil behavior. Please provide at least on...

A: Effective stress is the stress transmitted through grain to grain at the point of contact through so...

Q: 8. Rehabilitation of structures may be required due to several reasons. Choose the correct reason.

A: To find: Which is correct option for above case.

Q: Find the valu of 'X' if the width of the roadway is 6m for cut and 4.8m for fill. Side slope is 1:1....

A: Data given Side slope = 1:1 Width of road way for cut = 6m Width of road way for fill = 4.8 m Soluti...

Q: 1 KN/m SKN 2 KN M 2KN.m 1m 0. 7m 0,7m 1-2m |0um Cros seclion I 0,6cm Find O max in Mhis beam in MPa ...

A:

Q: A rectangular concrete beam of width 120 mm and depth 200 mm is prestressed by pre-tensioning to a f...

A:

Q: 41. Which of the below is a pigment imparting brown colour? A. O Raw Sienna B. O Soot C. O Burnt Sie...

A:

Q: 45. Which paint contains polystyrene as a base? A. O Synthetic rubber B. O Enamel C. O Aluminium D. ...

A: (D) Emulsion Emulsion paint contains polystrene as a base. Emulsion paints are durable and can retai...

Q: Enrichment Activities. 1. It is required to lay a simple curve along the stretch of a proposed road ...

A:

Q: L = 40cm- D, - 6mmo {0 y = 16cm x= 35cm h= 12cm d 10ст %3D

A:

Q: Explain and relate (as far as you can and to the best of your knowledge) if the turbidity data you g...

A: Step: 1 Turbidity: - It is defined as the amount of cloudiness in the fluid due to suspended solid ...

Q: 51. The structural concrete slab panels can be repaired by A. O Internal bonding B. O External bondi...

A:

Q: 50. Maintaining prestressed concrete structures of various types in a fit and serviceable condition ...

A: Maintaining prestressed concrete structures of various types in a fit and serviceable condition is p...

Q: A force of P = 10 kips is applied at end C of the rod ABC shown below. Knowing that E = 20,000 ksi, ...

A:

Q: Determine the internal forces for members BC, CF and CG. 2 kN 2 m VB 2 m C 2 m D A SN kN 3 m F E

A:

Q: 2. A yield measure with a volume of 0.248 ft has a weight of 7.69 lb. When filled with a sample of t...

A:

Q: Problem: Draw the shear and moment diagram of the given beam. 100 kN 75 kN - m 3 m- m- 3 m m-

A: Given data in question  Point load Concentrated load Cantilever beam  Dimensions  To find out  SFD B...

Q: Situation 5: A solid shaft is partially inserted in a hollow shaft where it snuggly fits and is rigi...

A:

Q: 9.13 Figure (a) shows the cross section of a column that uses a structural shape known as W8 X 67 (w...

A: To determine the dimension of the rectangular section which must have the moment of inertia values a...

Q: At station 6+240 the center height of the road is 2.4m fill while at 6+300 is 1.8m cut. The ground m...

A:

Q: A prismatic cantilever prestressed concrete beam of span length, L = 1.5 m has one straight tendon p...

A: This question is related to the Prestressed Concrete from Design of concrete structure.

Q: 41. Which of the below is a pigment imparting brown colour?

A: To find: Which pigment impart brown colour.

Q: An area of 150 km × 110 km is to be surveyed using photogrammetry. From the data given below, calcul...

A:

Q: 60m Om 0.39m

A:

Q: Assume that 4-18mm diameter rivets join the plates that are each 120mm wide. The allowable stresses ...

A:

Q: *8-28. Determine the slope and the displacement at C. EI is constant. Use the moment-area theorems. ...

A:

Q: Find the centroid of the given shape. (1,4) (3,4) (-2,2) (-2,0) 1 (3,0)

A: Divide the section in 2 parts as shown 

Q: Design the positive moment of the beam shown below, determine the number of 20mm diameter bars and t...

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.