Answered: Capacitors draw leading Current that…

Capacitors draw leading Current that neutralizes the lagging reactive components in the Electrical Equipment or System when used in Power Factor Improvement. Select one: O True False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Related questions

Q: A coil of 0.5 H inductance and 8 ohms resistance is connected in series with a capacitor across a…

A: The solution is given below

Q: Assume zero initial stored energy in each reactive element in the circuit given below IH 1F: Vo a)…

Q: R1 1000 V1 C1 =1µF 12Vpk 1kHz 0° Find the capacitor's reactance Xc, impedance Z, the circuit's…

A: To find the capacitive reactance and total impedance and current and voltage across the resistor

Q: 1A (b) (a) A * N * 220V C 1 kQ 3 uF 50 Hz (c)V R a.) What is the generic name of the circuit given…

Q: An impedance coil having a resistance of 25 ohms and an inductance of 20 mH is connected in parallel…

A: The solution is given below

Q: 3. A 100 µF capacitor, a 4.0 H inductor and a 35 Qresistor are connected in series with an…

Q: 1. A pure 20 mH inductor is connected to a 30 V, 50 Hz supply. Calculate (a) the reactance at this…

A: Given, L=20 mHf=50 Hz Reactance (X) =j 2×π×f×L X=j 2×π×f×L =j 2×π×50×20×10-3 Ω=j 6.28 Ω

Q: 10.Determine the dc value and peak value of the load voltages for the circuit given Fig.5 4:1 IDEAL…

A: For the given circuit: The transformer ratio is 4:1. The peak voltage at the output terminal of the…

Q: Q/ when connected to a 120V (rms), 60HZ power line , a load absorbs 4Kw at a lagging power factor of…

Q: A 20 non-reactive resistor is connected in series with a coil of inductance 80 mH and negligible…

A: According to our rules , we will answer only the first three parts of the question. If you want…

Q: In the circuit given below; Since E = 5827 Volts, C1 = 257 µF www m P) Equivalent capacity, www. Q)…

Q: 2 A voltage e(t) = 100sin 314t is applied to a series circuit consisting of 10ohms resistance, 0.0…

A: In this question series RLC circuit is given....We have to find out expression for current , phase…

Q: . For the circuit shown, what is the reactance of the capacitor? (Ohms) 2. What is the real power…

Q: A coil consists of a resistance of 100 N and an inductance of 200 mH. If an alternating voltage, v,…

A: Given: Coil resistance = 100 Ω Coil inductance = 200 mH Alternating current, v=200 sin(500t) Sol, a)…

Q: Determine the size of capacitor in uf necessary to increase the power factor to 0.90 if the load has…

A: It is asked to determine the size of the capacitor in μF, that is required to increase the power…

Q: A 127 uf capacitor is connected to a 125V 50 cycle source . Calculate (a) the capacitive reactance…

Q: An industrial load absorbs 200 kVA at power factor inductive of o.5 at 2500 V rms 50 Hz. Find the…

A: Explanation: cosφ1 = Load power factor without capacitor, cosφ2 = Load power factor with capacitor…

Q: 18. A 40 µF capacitor in series with a coil of resistance 80 and inductance 80 mH is connected to a…

Q: A coil of inductance 318.3 mH and neg[1]ligible resistance is connected in series with a 200…

A: Given that The coil has inductance L=318.3 mH and negligible resistance RC=0 ohm. Series resistor…

Q: In distribution systems, fixed capacitors are usually sized for minimum base-load conditions. Select…

A: Distribution system

Q: (+2 100 90 80 70 R1 Mwmn 50 Q 10mH V1 220 Vrms 60 Hz 0° Capacitance Real Power (UF) (Watts) 60…

A: The given circuit is shown below. A table is shown below. Write an essay on average power and…

Q: In the outage replacement rate method, the repair rate is zero. Select one: True O False The…

A: We are answering all the questions. Solution of first question: Given statement is in outage…

Q: Short Problem: Given a parallel RLC circuit comprised of the following element 60.08-ohm resistor,…

Q: A circuit has a 8 kW active power (P) with 0.7 power factor, lagging. 1. Draw the power triangle of…

A: To feed more active power and less distortion, the High power factor concept is used. To improve the…

Q: What is the maximum current delivered to a circuit containing a 2.80 µF capacitor when it is…

A: Given: Circuit capacitance, C=2.80 μF

Q: The small range wind turbine have direct drive generators, direct current output, aero elastic…

Q: R L 10 Q ll V sine The frequency of the voltage source is 5000 rad/sec. The impedance &f the…

A: In this question, We need to determine the value of capacitance C for the unity power factor? We…

Q: A resistor of 6 ohms and an unknown impedance coil in series draws 12 A from a 120 V, 60 Hz line. If…

A: Power consumed by resistor = current2 × resistance . Impedance of the coil= voltage/ current through…

Q: 3. A coil of resistance 60N and inductance 318.4 mH is connected in parallel with a 15 µF capacitor…

Q: A coil of resistance 8 ohm's and inductance 150 mH, is connected in series with a 100 µ F capacitor,…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: 4. A coil of resistance 10 Qand inductance 0.1 H is connected in series with a 150-uF capacitor…

A: The solution is given below

Q: A 3- phase , 50 Hz, 400 motor develops 100 H.P. ( 74.6 kW ), the power factor being 0.75 lagging and…

Q: Ex. 15] When connected to a 120 V (rms), 60 Hz power line, a load absorbs 4 kW at a lagging power…

A: Given, Voltage, V= 120 V (rms) Frequency, f= 60 Hz Active power, P= 4 kW Power factor, cosϕ1=0.8…

Q: 5. (Post Test 2 material) For the following circuit with v, (t) = 10 cos (1000t + 5°), determine %3D…

A: Active Power(P): The power which is deployed and absorbed by the electric circuit to do some useful…

Q: A:(T)The increase in voltage at the line end is dependent on the value of the operating capacitance…

Q: From the circuit below, calculate the DC quantity lĘ:

A: BJT (bipolar junction transistor)A transistor having a three terminal made up of semiconductor…

Q: Capacitor bank are widely employed in distribution systems for achieve power and energy loss…

A: Capacitance bank is installed because it inject reactive power into the system and reduce the power…

Q: A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

Q: A coil of inductance 636.6 mH and negligible resistance is connected in series with a 100 Ohm…

A: Inductive reactance(XL) =2×pi×frequency ×inductance Impedance =R+jXL Current =supply…

Q: A 20 non-reactive resistor is connected in series with a coil of inductance 80 mH and negligible…

A: Since there are multiple sub-parts uploaded within the same question,thus solving the first three…

Q: Data: e1=11e0, e2=11e0, e3=5e0, €4=6€0 and e5=7e0 Calculate: a) E,D, and P in all media; b) The…

A: capacitance= (permitivity)(Area)/(distance between plates) TOTAL ENERGY STORED = 0.5* CAPACITANCE *…

Q: In the circuit given below, w mw m E = 527 Volt, C1 = 57 µF, C2 = 57 µF, C3 = 57 µF, F) Equivalent…

A: The solution can be achieved as follows.

Q: When an inductive coil is connected across a 250-V, 50-Hz supply, and the curent is found to be 10 A…

A: Impedance = voltage/ current. Power dissipated by the resistance = (current)2×resistance.

Q: A supply of 250 V, 80 Hz is connected across an inductive load and the power consumed is 2 kW, when…

Q: 11.48 Determine the complex power for the following cases: (a) P = 269 W, Q = 150 VAR (capacitive)…

Q: Determine the size of capacitor in uf necessary to increase the power factor to 0.90 if the load has…

A: (a) Given data, SL=200 KVA, VL=480 V, cosϕ1=0.70, Rline=0.03 Ω, f = 60 Hz Active power is given by,…

Q: A resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor is connected in parallel to a…

A: The solution is given below

Concept explainers

RTD (Resistance Temperature Detector)

A resistance temperature detector is a passive electronic device or a sensor. The name itself suggests that it is related to resistance, temperature, and detection. Similarly, its resistance changes when there is a temperature change; the resistance increases when the temperature of the RTD device increases or vice-versa. It is also known as a resistance thermometer. Its working is similar to the thermocouple.

Question

Please

Capacitors draw leading Current that neutralizes the lagging reactive components in the Electrical
Equipment or System when used in Power Factor Improvement.
Select one:
O True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following:a. Circulating currentb. Voltage across the resistorc. Voltage across the capacitord. Real power supplied by the source
In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. a)Find the average power spent by the load circuit? b) How much of the average power calculated in a) by the resistance in the load circuit and how muchspent by the capacitor? Comment on the results obtained?
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
What is reactive power, and how does it affect the efficiency and stability of an electrical grid?
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.
The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10 ohm. The duty cycle is 0.4 the voltage drop across the switch may be taken as zero, Calculate : (a) Average and RMS value of output voltage. (b) Average and RMS value of output current.
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
Generate a conclusion on this following statements: Determine and analyze the voltage regulation characteristics of the alternator with resistive, capacitive, and inductive loading.
QUESTION 1 Two magnetically-connected circuits have the following characteristics: . A series-opposing connection of coils (dot convention). The primary side is connected to a voltage source that has a magnitude of 230 V and a phase angle of 45 degrees. . The primary-side inductive reactance is jXL1 - j8 Ohm. . The secondary side is connected to a resistive load of 10 Ohm. . The secondary side inductive reactance is jXL1 =j5 Ohm. . The mutual inductive reactance is jM=j1 Ohm. The magnitude of the voltage across the resistive load is:
8 = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four poles machine? a Q3: What does happen if we have a two-phase two poles machine? Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali K....p. . --
Combination circuit what is PT? RT? IT? Voltage Across each load?