Can you remove adsorbed water by oven drying at 105°C, explain.

Climate: Avg. Temperature is 3.2°C July 2.5% high is 22.8°C, J Degree Days is 5000 Inside Air Temp. is 20°C Wall Construction, Inside to Out: ● · . Qigihar House in Heilongjiang Province, China Heat Loss Problems, BSCI 2101 . 1. January 2.5% low is -26.0°C 15mm Gypsum Plaster, Sand Aggregate X Concrete Block, rectangular core, Sand and Gravel 2 core, 200mm 15mm Cement Plaster, Sand Aggregate All 4 walls measure the same, 8m wide by 7m tall. The house is heated with electricity at a cost of $0.10/kWh 4. Calculate the January heating cost for the building. 1. Calculate the RSI-total for the walls using the tabular method demonstrated in class, and the temperature drop through each element for the January 2.5% temperature. 2. Calculate the rate of heat flow through the wall again for the January 2.5% temperature. 3. Plot the temperature profile approximately to scale through a vertical cross-section of the wall. 5. Calculate the annual heating cost for the building. 用国 8m 6. Now add 2"…

One common issue with air strippers is scaling due to hardness in the water. Please design an excess lime pre-treatment step to remove the water hardness (determine the softening chemical addition rates [mass/hour] of Ca(OH)2 and Na2CO3) if the water chemistry is as follows [CO2] = 5 mg/l, [Ca2+] = 50 mg/L, [Mg2+] = 6.1 mg/L, [Na+] = 23 mg/L, [Alkalinity] = 150 mg/L and [SO42-] = 24 mg/L

Subject is properties of behavior

Subject is properties of behavior

Detail explainatory solution required

5-18. The solubility product of calcium fluoride (CaF2) is 3.45 x 10-" at 25°C. Will a fluoride concentration of 1.0 mg/L be soluble in a water containing 200 mg/L of calcium?

Please upload your full solution to the following problem. Determine the dosage and daily consumption of powdered activated carbon (PAC) required for trichloroethylene (TCE) removal given the following design specifications: 6 SUL Influent concentration = 1 mg/L TCE Carbon type: Calgon Filtrasorb 400 (12 x 40 mesh); pb = 450 g/L Freundlich parameters for TCE • Freundlich capacity parameter K = 55.9 (mg/g)(L/mg)¹/n • Freundlich intensity parameter 1/n = 0.48 Treatment objective = 0.005 mg/L TCE Flow rate = 378.5 L/min (100 gal/min) Assume that no other solutes compete with TCE for adsorption onto the PAC, and that the PAC is saturated at the treatment objective.