Calculate the total power dissipation in the circuit in Figure 8-2. 64.5 mW 182 mW 9.12 mW 45.6 mW

Q: A RC circuit has a reactance magnitude of 820 ohm and 10 V AC voltage. What is the resistance…

A: In any circuit, the magnitude of the total impedance is the ratio of voltage supplied to the circuit…

Q: 1) In capacitors, the time constant determines the discharge rate.   True or False 2) AC currents…

A: (1) in capacitors, the time constant determines the charging rate. Hence given statement is FALSE.…

Q: method of voltage control can be used for controlling voltages at all levels.

A: The correct answer is SERIES CAPACITORS

Q: 1. An 8-bit register contains the number 10000110. The serial number 11011011is applied to the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The electrodynamic instrument can be used as a voltmeter by connecting a large inductive with…

A: The given statement is a false statement.

Q: Vcc RB RC Q1 NPN +88 8 Volts VC

A:

Q: 4. Explain the three-level PWM by drawing waveforms.

A: Pulse width modulation(PWM): PWM is a powerful technique for controlling Analog circuits with a…

Q: Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with…

A: Two parallel wires made of copper are placed in air.  Total inductance L= 0.9uH/m What is the…

Q: What are the types of semicondoctors available

A: The objective of the question is to identify and describe the different types of semiconductors…

Q: Q1 R3 R1 R2 VC VCC

A:

Q: Vcc RB RC Q1 NPN +88 8 Volts VC

A:

Q: (c) Measure the voltages of the resistor and capacitor and calculate the current using Ohm's Law…

A: Given:A circuit, we need to find:(c) Measure the voltages of the resistor and capacitor and…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: Series-Parallel Circuit For the following circuit, determine: a) The total resistance RT b) The…

A:

Q: You are required to run a test on 250 kV metal-oxide surge arrester in high-voltage laboratory. The…

A: The arrester which uses Zinc oxide (ZnO) as a resistor material such type of material is called…

Q: 1. Find the average value of current when the curren that are equidistant are 4A, 5A and 6A.

A: It is given that:

Q: Sine-wave www 1.0 k generator 1.0 kHz 1.0 V Voltage across R1, VR Total current, I Voltage across L,…

A: In the given questions, we need to calculate the calculated and measured value of voltage across…

Q: The inductive circuit has  ___________________ value of reactive power. a-Both positive and…

A:

Q: State the three rules for series circuits

A: Three rules of series circuit are as follows:

Q: 3.) Find the percent overshoot, settling time and peak time for T(s) == 0.04 $240.002s +0.04

A: We need to find out  peak time and peak overshoot and settling time .

Q: a resistor and and capacitor are connected in parallel to a 277 v 60 hz power source. the resistor…

A:

Q: in wind turbine, high watt range machines are used for and

A: It is asked what is the purpose to use high watt range machines in wind turbine. Generators…

Q: what is the effect on indiced voltage of adding more turns of a wire to a coil

A: The induced voltage is produced as an electromagnetic induction.  Electromagnetic induction is the…

Q: Question 1 What would be the maximum current through the resistor? Express your answer in amperes…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: For the converter shown below, determine the magnitude of current ripple value, Aa | in mA. V dc Vdc…

A: Given data Vdc=55 VdcD=55%fsw=15 kHzR=2.0 ΩL=1.0 mHea=35 Vdc We have to determine the magnitude of…

Q: The following forward converter (for questions 8-12) has the following parameters. Vin=40V,…

A: Given Vin=40 VV0=10 VP0=50 WD=40%=0.4NP=16

Q: Compute the amount of capacitance needed to correct  the power factor to 90%

A:

Q: Determine the waveform on the load: a) If this were a resistance b) If this were a capacitor

A: a) for resistive load

Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 6.946 ohms R2 = 9…

A:

Q: What is the approximate value of the total resistance. R2 RS R11 4 kOhm 4 kOhm 5 kOhm R128 kOhm R310…

A: In this question,  We need to calculate the equivalent resistance.  We know if two resistances R1…

Q: What is the impedance of the circuit shown in the figure.

A: capacitive reactance=-jXc Inductive reactance =jXL Given Xc= 2 ohms            XL= 6 Ohms…

Q: The voltage across the resistor in series RL when suddenly supplied by a DC source is? a. zero O b.…

A:

Q: 3. Sketch the current waveform for the circuit in Figure below. The diac has a breakover potential…

A: Given data: The breakover potential, VB=20 V. The holding current, IH=20 mA. The given circuit…

Q: The switch in the circuit of Figure 2 has been in position a for a long time. At t=0 the switch…

A:

Q: How can i find the total impedance in this circuit

A: In the circuit, resistance , inductance and capacitor Reactance are consist.  find the total…

Q: How much resistance must be inserted in series with a 0.96-H inductance to limit the current to 0.25…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…