Calculate the current through the 80-ohm load resistor RL. The source voltage is 80 volts. The resistances are all in ohms.If the resistance are in ohms, what is the current through RL? CALCULATE THE CURRENT THROUGHTHE 80 OH MTHE SOURE VOLTAGE Is Bo V.THE RESISTANCELOAD RESISTOR RARE ALL IM OHMS40~8040 243403802802400IF RESIS TANCES ARE IH OH MSWHATIs THE CURRENTTHROUGH

Answered: Image /qna-images/answer/63721567-e019-46ca-bf13-3e9e55cf4bcc.jpg

Answered: Calculate the current through the…

Calculate the current through the 80-ohm load resistor RL. The source voltage is 80 volts. The resistances are all in ohms. If the resistance are in ohms, what is the current through RL?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A voltage divider consists of a 3000 – ohm, a 5000 – ohm, and 10000 – ohm resistor in series and the…

A: Given Voltage divider with series current Is=15 mA The resistors 3000 Ω,5000 Ω and 10000 Ω are…

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

Q: What is the corrosion current when the circuit resistance is 0.25ohms and the potential difference…

A: In this questionWe need to determine the current in the corrosion if voltage across the circuit is…

Q: We want to make a resistivity measurement. How should we connect the probes of the multimeter? Drag…

A: a multimeter is a portable device that can be used to take various electrical measurements like,…

Q: In the figure the current in resistance 6 is ig = 1.34 A and the resistances are R, = R, = R3 = 1.62…

A: Given data: i6=1.34 AR1=R2=R3=1.62 ΩR6=3.17 ΩR4=15.4 ΩR5=8.87 Ω The circuit is given as:

Q: 16 Determine the current at LED, D2. (assume LED forward voltage is 2.1 volts) * R2 1K 5V D1 R1 D2

A: The solution is given below

Q: Refer to Figure D. Determine the total current of the entire circuit. a. 1.0 A b. 0.5 A c. 0.2…

A: In this question we will find total current....

Q: Three resistors, 1902.50 and 14 0 are connected in parallel in a circuit. What is the equivalent…

A: Given data, Resistances are given R1=19 Ω, R2=5 Ω, R3=14 Ω.

Q: A 120-A current flows into two parallel resistors having resistances of 15-ohm and 28-ohm. Find the…

A: If current flows into two parallel resistors having resistances, so find current in resistor by…

Q: solve the actual value of each resistor using kirchhoff's law

Q: Draw the voltage tripler circuit and explain its operation. Explain the difference between voltage…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: What is the power dissipated by the 0.500-ohm load resistor that is connected to a 12.0-V emf with…

A: First we will find out voltage across load resistance.then We will find out power across load .

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Headlamp voltage=12 V Fishing boat power system voltage=24 V Headlamp rating=50W The power across…

Q: In cross circuits, how do i know the resistances are in parallel or in series connection?

A: The solution is given below

Q: Determine the values of the currents for max current and min curent in the voltage regulator Zener…

A: Zener Diode Basics:Zener diodes are used for voltage regulation. They maintain a practically…

Q: what us the resistance of teb 240- resistors connected in series? in parallel?

Q: Two resistance are in the series R1= 25 ohm and R2 = 56 ohm . Then determine the equivalent…

Q: 1. Voltage Dividers a. describe how a voltage divider works. b. Explain, using an example, why…

A: The voltage divider circuit is used to divide the voltage to control the other part of the circuit…

Q: A voltmeter that reads 0-100 volts has a 200-division on its scale that can be read up to…

Q: 5 Choose the reason for a huge Loading effect, during the current measurement using an ammeter. a.…

A: In most of the ammeters an accurate and very low value resistor is used as a sensing element. This…

Q: State Kirchoff's current Law. O None of these sum of all powers in a circuit O sum of all emfs in a…

A: Kirchhoff's Laws: Kirchhoff's current law, Kirchhoff's voltage law Kirchhoff's current law:…

Q: 20v 33 Ohms 10 Ohms 22 ohms VR33=. VR10=. Vr22=. IR33=, IR 10=. Ir22= PRa3. PR10". PR22".

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

Q: In this lab, you will be using resistors of various nominal values. What are the 5-band colour codes…

A: Given resistor values are: 100 Ohm220 Ohm 390 Ohm 560 Ohm 1000 Ohm

Q: The circuits terminal voltage is 16.7V and then resistors A&B are in parallel. The resistance of…

A: Basic electrical circuit problem is solved as shown below.

Q: Three resistors of 5, 10, and 15 ohms respectively are connected in series with a 24V source…

A: In this question we will find current through 5 ohm..

Q: for part c what is the actual calculation?

Q: Write down the steps on how to Parallel Resistors Current Division

Q: Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the…

A: Given, C1=6 μFC2=10 μFC3=15 μFV=200 V

Q: What happens to the terminal voltage of the 12.0-V emf with an internal resistance of 0.150 ohm that…

A: The emf is maximum voltage delivered by cell when no current flow through the circuit. Terminal…

Q: A 10 Q2 resistor is connected in series to a parallel combination of a 60 resistor and a 20 resistor…

A: Given data, R1=10ohm R2=60ohm R3=20ohm V=220V

Q: いトこ2.25)

Q: The current enters to the positive terminal of a device is i(t) = et amps, and the voltage across…

A: Given, Current, it=e-4t A Voltage, vt=3didt vt=3ddte-4t=-12e-4t V Time, t = 0 to 2 sec

Q: O For the voltage -divider bias confguration in Figure I, determine: 016V a) Ise b) Ice 33.9k LICQ…

Q: (b) How is the total voltage across the two series elements R, and R₂ related to the applied voltage…

A: In this question, we need to determine the relation between total voltage across the two series…

Q: A voltmeter indicates that the value of a voltage crossing a load resistance is 5.00 V, this…

Q: 15 Determine the voltage across resistor R2. (assume Zener voltage is 3 volts) * R2 1K R1 10V D2 1K

Q: A 0 – 150 voltmeter has a resistance of 2000-ohms per volt. It is desired to change this voltmeter…

Q: a 12 volt source with an internal resistance of 1.2 ohm is connected across a wire wire wound…

Question

Calculate the current through the 80-ohm load resistor R_L. The source voltage is 80 volts. The resistances are all in ohms.

If the resistance are in ohms, what is the current through R_L?

CALCULATE THE CURRENT THROUGH
THE 80 OH M
THE SOURE VOLTAGE Is Bo V.
THE RESISTANCE
LOAD RESISTOR R
ARE ALL IM OHMS
40~
80
40 2
43
403
802
802
400
IF RESIS TANCES ARE IH OH MS
WHAT
Is THE CURRENT
THROUGH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is the advantage of using the voltage divider technique in determining the voltage across a resistor from a series of resistors, compared to using Ohm’s law.
Qqqq
Kindly answer all of the questions please, I will rate you with like/upvote. Please answer all of the questions. Thank you so much.
For a certain power shpply, the no load and full load voltage are 22 V and 18 V respectively. What will be the load regulation?
In step 3, what is the potential difference across D2 after the jumper wire is connected
Three 4 – ohm resistors are connected in parallel from a 24 – volt source. Find the current flowing in one of the resistors.
There is an RL circuit with a switch 2-volt battery, a .15 H inductor, and a 60-ohm resistor. How long after the switch is closed would there be 10 milliamps in the circuit?
What is the theory and things to observe in voltage dividers e.g the purpose and how to do it
Question: The current in the 8.00 ohm resistor below is 0.84 A a.) Find the current in the 20-ohm resistor and in the 9-ohm resistor. b.) Find the equivalent resistance across the circuit.
Question 4 on for > 0 as shown in Figure 1 below. What is the power? A 20te The independent current source in the circuit generates zero current for < 0 and a pulse of O a g0re-10: b. 301 e101 W -101 900e -10t o. 130te W. O d.1201 e -10z -10t 600te W
Three wires are connected at a branch point. One wire carries a positive current of 13 A into the branch point, and a second wire carries a positive current of 3 A away from the branch point. Find the current carried by the third wire into the branch point.
What resistance must be connected in series with a 100-N resistor for the 100-0 resistor to produce heat at the rate of 30 W when the combination is connected to a 120-V source?