Calculate the applied forward-bias voltage across a diode if the diode current is 50A. (T=25°C, Is = 1pA, n=1) 0.8107 V    0.3107 V    0.7103 V    0.7108 V

Q: in a balanced, 3 phase, positive sequence, grounded neutral source, supplies power to a balanced wye…

A: In this question we need to find the value of the reactance per phase of the delta load in ohms

Q: R₁ www L, 3 i. =-6 mA R₁ = 78 102 R₂ = 14 k L₁= 23 mH L₂=8 mH A B Answer t=0 For the circuit shown…

A:

Q: Question #2 Find VO using Thevenin's theorem. Find Zth and Vth and then find VO. w L=2 ohm, (1/ w c)…

A: In this question We need to determine the thevenin equivalent circuit and also draw phasor diagram…

Q: D) E) Consider a mechanical translational system having mass M-2kg, damping coefficient B=12 Nt per…

A: We need to select correct option for given statement regarding damping and convolution .

Q: A) Consider a mechanical translational system having mass M-2kg, damping coefficient B=24Nt per…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: 11. How many root locus branches exist between s= -2 and s= -3 for the given system. K(s+2)(8+3)…

A:

Q: For the following voltage and current phasors, calculate the complex power, apparent power, real…

A:

Q: iv) Generate the simulate received signal by adding the transmitted signal x(n) and the noise signal…

A: Given: To do: To generate the above signal with the help of signals computed in previous questions.…

Q: A balanced, three-phase, positive sequence, with grounded neutral source, supplies power to a…

A: The given problem is from sinusoidal and phasor.  The detailed solution is given in the next step

Q: 3. Determine the value of R₁ to ensure the diode will regulate at 5.1V @ IZT-49mA. VIN 8 V 10 R www…

A:

Q: Example 2 In the previous example, find the value of T for which the system is stable. From the…

A: We need to find out the value of unknown for a stable system .

Q: 1) An 8x1 multiplexer has inputs A, B, and C connected to the selection inputs S2, S1, and 50,…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: Q3) For the closed-loop discrete-time system below, where K is a control gain to be chosen. R(z)…

A:

Q: B) C) Consider a series connection of R=2 Ohms, C=3F, a switch, and a voltage source, E=12 Volts.…

A:

Q: The inputs w, x, y, and z of the multiplexer circuit below are wired such that the circuit…

A:

Q: R 'Using the circuit below: + V с Where R=10ks, C = 10pF, and Vo = 10V Write the expression for v(1)…

A: In this question We need to determine expression of voltage v(t) and time constant and time takes…

Q: 2) Find Vat in the network 2. 2ov 1-2 2-2 Tmm Vab WIN 452 lov Network 2 25V 15V

A: We need to find out voltage for given circuit. First we will find out the current and then we will…

Q: (2+2j) Ω

A:

Q: 6.. The phase voltage of a 3-phase voltage source is 120 V. It is supplied to a star connected load…

A:

Q: Required Information Consider the following signals. z (t) = 2sinc() sinc() Determine the numerical…

A:

Q: Derive the average and RMS output voltage for three phase half controlled rectifier with RLE Load or…

A:

Q: What is switch Debouncing ? List two correct this problem. or more ways.

A:

Q: Use the superposition principle to obtain vx in the circuit given in the figure. Let vs = 50 sin…

A: For the given circuit we need to find voltage vx using superposition theorem.

Q: 1 In the circuit of Fig. 1, calculate: (a) iL(0¹), vc (0*), VR(0¹) (b) dvc(0+) dt (c) iL(0), vc (0),…

A: It is given that:

Q: 1. A 5-KHz audio tone is used to modulate a 50-MHZ carrier causing a frequency deviation of 20 KHz.…

A:

Q: 2. The voltage of the circuit below is v(t) = 120e−400t cos(300t) + 80e−400t sin(300t) V. The…

A: It is given that: Vt=120e−400t cos(300t) + 80e−400t sin(300t) VC=200 mF

Q: Refer the following D flip flop, draw the output waveform of Q. PRE=Preset,CLR=Clear, CLK-Clock CLK…

A:

Q: A portion of a spherical surface defined by r = 1,0 ≤0 ≤, 30° ≤ ≤ 50° has a vector magnetic…

A:

Q: 19H.W. D Determine I, and I₂ for the network 1. 2 12 V 12V 3, 382 356.2 network 1

A: Given: Circuit diagram :

Q: 3. Fill the below table with the correct terminal connection to have a CB amplifier: Connection…

A:

Q: 1. Find the total capacitance of the circuit below. 7μF 2.5mF HI 75μµF 150F 20μF | 20pH 23μF

A:

Q: For a transmission line, the voltage wave on it has the form of v(z, t) = 15 sin(10ºt + 2) (V).…

A: Given, The transmission line having voltage wave on it has the form of V(z,t) = 15 sin(106t +πz) V…

Q: Calcule la potencia disipada por la resistencia de 8.02 en el circuito ilustrado en la figura de…

A: Given data, Circuit diagram is given as,

Q: Determine the current i, for the circuit shown in Figure below. 4 ΚΩ a www b φωτο 18 V 8 ΚΩ 4 ΚΩ 8…

A:

Q: Use mesh analysis to determine the two mesh currents labeled in circuit shown.orm of bei

A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…

Q: 3. Suppose a pure, two-pole system has been identified to have a damping ratio of 0.7, a damped…

A:

Q: - what gate A B I ?

A:

Q: ن هر 2 2 | io(t) 60 -۸۸۸ 40 منام = 0 (02 2A 31202 5

A:

Q: The steps given below will be applied on the Boolean function F(A,B,C,D)- II (3,7,11,14,15) a) Fill…

A: The given problem is from digital electronics.  The detailed solution is given in the next step

Q: Consider a 90-degree hybrid (port 3 is isolated) with its ports connected as shown below. Derive the…

A: According to the question, for the given figure as shown below We need to calculate the S-matrix.

Q: Convert - 3510 to tuzo's complement,

A:

Q: design a combinational logic circuit with three input variables that will produce 1 output when more…

A: It is given that: Three input variables that will produce 1 output when more than one input variable…

Q: balanced, three-phase, positive sequence source, supplies power to a balanced delta-connected load.…

A: The question is from 3 phase circuits. The question is about finding line voltage.

Q: R₁ x$ 1=0 C ww R₂ R₁ For the circuit shown above, the switch has been open for a long time, and then…

A: here we need to find the voltage across the in capacitor at t=∞.

Q: F(A,B,C,D,E) = A'B' + ABCD + A'C' B' + D'E' + AB'C'DE + A'CE' +C

A:

Q: 5. A 20-KVA 220-V 60-Hz Y-connected 3-phase salient-pole synchronous generator supplies rated load…

A: Given: In this question, the given details are, A 20 kVA, 220 V,60 Hz Y-connected 3-phase…

Q: 1) Explain how doping a pure silicon crystal with donor impurity atoms makes more charge  carriers…

A: Donor impurities are elements that have five electrons in their outer shell. When pure silicon is…

Q: The Thevenin voltage for the circuit is A) 5.0 V B) 10 V C) 6.67 V D) 8.33 V

A: Given data, Circuit diagram is given as,

Q: +9 ان I' 1.25F 252 IF 0.8H ₂ Determine the hybrid parameters @h₁ h₂ h₁₂ @h₂₂ ot (W = 1 (rad/sec)).

A:

Q: 4. Evaluate the voltages at all nodes and the currents through all branches. State the DC mode of…

A: