A balanced, three-phase, positive sequence, with grounded neutral source, supplies power to a balanced delta connected load. For the system, additional information are as follows: Vbn = 214 cis 185 degrees volts; and Ica = 7.9 cis138 degrees amperes What is the angle of the total apparent power in degrees? (Place negative sign for capacitive reactive power.)

A balanced, three-phase, positive sequence, with grounded neutral source, supplies power to a balanced delta connected load. For the system, additional information are as follows: Vbn = 214 cis 185 degrees volts; and Ica = 7.9 cis138 degrees amperes What is the angle of the total apparent power in degrees? (Place negative sign for capacitive reactive power.)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13MCQ

See similar textbooks

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
The total reactive power consumed by the three-phase load(in VAr) is??
A synchronous generator has been synchronized to an infinite grid of 13.8 kV and 60 Hz. The generator prime mover C/C is such that the no-load frequency is 62.5 Hz and the power slope is 1 MW/Hz. The AVR C/C (The reactive power against the terminal voltage C/C) is such that the zero reactive power voltage is 14.6 kV, while the slope is 0.4 MVAR/kV. Calculate: (a) the kVA loading of the generator and its power factor. (b) the settings of the prime mover and AVR such that the generator delivers 3 MW at 0.85 lagging power factor.
Single phasing happens when one phase of a three phase source becomes unavailable. True False
A 50 cycles, 3 phase alternator with grounded neutral has inductance of 1.6 mH per phase and is connected to busbar through a circuit breaker. The capacitance to earth between the alternator and circuit breaker is 0.003 uF per phase. The circuit breaker opens when rms value of current is 7500 A. Determine the following: i) Maximum rate of rise of restriking voltage. 1) Time for maximum rate of rise of restriking voltage. in) Frequency of oscillations
A 3 phase 200 MVA capacitor bank is to be switched off (disconnected) the grid that operates at 13.8kV (3-phase) at 60 Hz. The capacitor is connected in a WYE configuration, therefore the voltage across each phase is VLN=7.97KV. A restrike occurs at the zero crossing of the current. Determine the magnitude of voltage across the capacitor after the restrike. b. 0.05 mSec after the first restrike the arc extinguishes, which leaves a 1st charge trapped. Another restrike occurs again 3/8 of a cycle after the first restrike and is quickly extinguished. Identify the magnitude of voltage trapped across the capacitor after the а. second restrike.
QUESTION 1 Two magnetically-connected circuits have the following characteristics: . A series-opposing connection of coils (dot convention). The primary side is connected to a voltage source that has a magnitude of 230 V and a phase angle of 45 degrees. . The primary-side inductive reactance is jXL1 - j8 Ohm. . The secondary side is connected to a resistive load of 10 Ohm. . The secondary side inductive reactance is jXL1 =j5 Ohm. . The mutual inductive reactance is jM=j1 Ohm. The magnitude of the voltage across the resistive load is:
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm i, i,R, R, jX m १ (1-s) R, S How many times the rated current will the inrush current be when the ASM is started directly? O 4.3763 O 2.6455 O 6.3414 7.1534 O 5.2280 O 8.0815 O 3.7473 O 1.2558
3 X 0.1 1 2 XL = 0.2 to Eato oto O X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. (2 Marks) b) Find the bus voltages and line currents during the fault. (2 Marks)
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1480 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm i, i, R, R, eee R, (1-s) m S How many times the rated current will the inrush current be when the ASM is started directly? O 6.3414 O 1.2558 5.2280 O 3.7473 O 7.1534 4.3763 O 2.6455 8.0815