Calculate drift current density in 1.5 mm long slab of intrinsic Si at room temperature under applied voltage 10V? Assume carrier mobility of 1100 cm2 V-1 s-1.

Q: 15 In the circuit shown, determine the current flowing through the resistor R1. * R2 1K R1 5V D2 1K

A: The solution is given below

Q: Qʻ: Fill in the following blanks with suitable words : 1. Conductivity of a material depends on: and…

A:

Q: If a silicon diode's relationship between voltage and current is given by the approximation   What…

A:

Q: At 300 K, for a diode curret of 1 mA, a certain germanium diode requires a forward bias of 0.1435 V,…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: 5 نقاط Q3/B: Assume an ideal diode model for all the diodes in the circuit below. calculate voltages…

A: The given circuit is All the diodes are given as ideal diodes.

Q: Why Ge material has a lower...... Answer follow image. Answer must correct and show all step.

A: Built in voltage given by  Vbi = (kT/q)loge(NaNd/ni2) ni is intrinsic concentration

Q: A diode is tested at the presence of dc+ac source, where the diode's average current level (dc…

A:

Q: Please explain temperature dependence of carrier concentration on metals and semiconductors…

A: In metal the carrier concentration is almost temperature independent because metal have a large…

Q: Suppose a drift current density of 2000 A/cm2 exists in the neutral region on the p-type side of a…

A: Given data, The value of drift current density (J) = 2000 A/cm2.

Q: 2.4 A M-volt forward voltage is applied to a silicon diode in series with a load of 3 k2. Draw the…

A: Dc load line:- The dc load line is the characteristics of diode voltage vs diode current.…

Q: e donor conentration and the electron mobility.

A: NOTE- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: 4. Define the continuity equation, then discuss the relaxation time in dielectric and conducting…

A: Continuity Equation: Continuity equation states that if charge is moving out of a differential…

Q: If a 480 ?F capacitor is added to the output in Figure 2.1, calculate the following: i. Vripple. ii.…

A: From the shown figure 2.1 above, first, determine the secondary voltage VS, Now, the output voltage…

Q: a) Given a Si p-n junction diode. Write three separate equations for the current densities due to…

A: As per the our policy i am attempting first question. a) i)Current density due to diffusion is given…

Q: The ratio of hole diffusion current to the electron diffusion current crossing the junction of an…

A: Given Data:The ratio of the hole diffusion current to the electron diffusion current is given as The…

Q: k) An n-type silicon of 1-micron length and cross-sectional area of 100 µm² has a voltage of 2 V…

A:

Q: 4. a. Make a sketch of a pn junction and use it to explain why there is an electric field throughout…

A: The above question is related to a p-n junction diode and its built-in electric field.

Q: A photo-diode which has an input of a change in light intensity, the output form is Select one:  a.…

A: A photo - diode is a semiconductor device that is used to convert light energy into electrical…

Q: specimen of slconis -2mm Long und has ucress Section area of o04mm2 one Valt imp ressed acvoss the…

A:

Q: 24 A 30-volt forward voltage is applied to a silicon diode in series with a load of 3 kn. Draw the…

A: GIVEN DATA  Diode cut in voltage-0.7 in case of Silicon Load resistance -30 kilo ohm

Q: A copper wire with (32.3m) Long, Fhe cress-setoonal area (5 mm?) and the resistance is C120 r) at…

A: Given, Length of copper wire (l) = 32.3 m Cross sectional area (A) = 5 square mm At 0°C , resistance…

Q: The ratio of hole diffusion current to the electron diffusion current crossing the junction of an…

A:

Q: Q?: Fill in the following blanks with suitable words : 1. Conductivity of a material depends on: and…

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.…

Q: What is the value of reverse recovery charge developed in diode having the rate of fall of diode…

A: First we will draw current waveform and than we will derive expression for charge.

Q: Assume that the conductivity of a pure semiconductor at an applied electric field of 450 mV/m is…

A: The data given in the question are: E=450mV/m, σ=2.75×1013/Ω-cm, vd(e)=0.135m/s, vd(holes)=0.048m/s…

Q: Q1: D1 D2 For the circuit on the right, a. Graph the output voltage vo against the input voltage V1.…

A: Diode: A diode has generally two terminals P terminal and N-terminal.  Forward Biased Condition/…

Q: H.W: Determine v, and the required PIV rating of each diode for the configuration of Figure below…

A:

Q: ) The figure below shows the electron and hole concentration in a silicon region. The electron and…

A:

Q: (1-5) The mobilites of free electrons and holes in pure Germanium are 0.33 and 0.18m/v-s…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: The diode shown in Figure T9.2 is ideal. Determine the state of the diode and the values of vx and…

A: Assume that the diode is in forward biased  Apply KCL at node vx,…

Q: 1. A silicon p-n junction has the hole and electron resistivity are 0.001 2.m, 0.004 22.m…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: A practical silicon-based solar cell is constructed from a n+ p junction. a. Explain briefly the…

A: Here in this question they are interested in the calculation of PN junction solar cell.   Here the…

Q: 1. Conductivity of a material depends on: and 2. can break the bonds in semiconductor crystals and…

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again.

Q: A. Why does the conductivity of a semiconductor and some insulators change with impurity content?…

A: A - The conductivity of a semiconductor and some insulators changes with impurity content due to a…

Q: A semiconductor junction diode, we can say that: a) The diode is composed of two types of crystal,…

A: I am giving the points which illustrate the correct answer.

Q: a. Find DC resistance of a diode, if voltage applied across a Silicon diode at room temperature…

A:

Q: 1. A silicon p-n junction has the hole and clectron resistivity are 0.001 2m, 0.004 2.m respectively…

A: "According to the Company's policy we will provide solution of only the first part as the second…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.