Twosignals a(t) = 12 cos(20t) cos(2000t)andb(t) = 38(t) +%3D800 sinc(100t) cos(2000nt) are summed up and passed through a LTI filter with animpulse response of h(t) = 100 sinc(100t) e1900t to produce the output signaly(t).a) Sketch the magnitude spectrums of the signals |A(f)\, |B(f)\, \H(f)| and [Y(f)|.b) Using the graph of |Y (f)\, find the expression of y(t).%3D

Answered: Image /qna-images/answer/043799ce-9cdb-4a78-a903-a017691284be.jpg

b(t) = 38(t) + signals 800 sinc(100t) cos(2000t) are summed up and passed through a LTI filter with an impulse response of h(t) = 100 sinc(100t) el1900t to produce the output signal y(t). a) Sketch the magnitude spectrums of the signals |A(f)\, \B(f)\, |H(f)| and |Y(f)|. b) Using the graph of |Y(f)\, find the expression of y(t). Two a(t) = 12 cos(20xt) cos(2000rt) and

b(t) = 38(t) + signals 800 sinc(100t) cos(2000t) are summed up and passed through a LTI filter with an impulse response of h(t) = 100 sinc(100t) el1900t to produce the output signal y(t). a) Sketch the magnitude spectrums of the signals |A(f)\, \B(f)\, |H(f)| and |Y(f)|. b) Using the graph of |Y(f)\, find the expression of y(t). Two a(t) = 12 cos(20xt) cos(2000rt) and

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Consider a step down converter supplied by a DC power source of magnitude Vs = 100 V. The switching period is 0.2 ms. The load is resistive with R-5 Ohms. An LC filter is used to regulate the output with L- 5 mH and C-200 uF. The switch is ideal. The average output voltage is Va= 50V. The ripple current of the inductor delta (1) and the ripple voltage of filter capacitor delta (V) are respectively equal to: Select one: O a. 1A, 0.125V O b. 0.9A, 0.1V O c. 0.96A, 0.12V O d. None of these
What is output signal when a signal x(t)=cos(2*pi*40*t) is sampled with a sampling frequency of 20HZ? a) cos(pi*n) b) cos(2*pi*n) c) cos(4*pi*n) d) cos(8*pi*n)
The value of DC offset that must be applied to the rectangular signal to obtain the signal shown below is (where the original signal is symmetric on x-axis): CHI SV O a -15 CH2 0V b. -7.5V O C. -6V Od. -3V Clear my choice 2 ms
Determine the transfer function from Uin to Uut! b) Set up amplitude and phase function! c) Assume that we connect 10V (DC) as input voltage at time t-0. How much voltage is then above C2 after a long time?
A signal with bandwidth 100HZ is over sampled by 40% then the cutoff frequency of the low pass reconstruction filter to recover this signal is. fc= Hz
Write short notes on magnitude comparator.
An rf pulse 10rect(t/0.01)*cos(2000*pi*t) is fed to an ideal bandpass filter of center frequency 1 kHz and bandwidth 200 Hz. Obtain the output and plot the same within reasonable time interval.
A continuous time signal is given by: x(t) = A cos(8000t) cos (2000nt) %3D The signal is sampled with a sample period of 3 x 10-4 seconds. Can we recover the signal from the sampled version using an appropriate low pass filter?
2) You are asked to design a DSB-SC modulator to generate a modulated signal km(t) cos wc t, where m(t) is a signal band-limited to B Hz. Figure below shows a DSB-SC modulator available in the stock room. The carrier generator available generates not cos wc t, but cos3 wc t. M(f) km(t)cos³ w̟t m(t) A Filter b f -B В cos wct a) Sketch the signal spectra at points a and b.(a:1,b:8) b) Is it possible to realize a DSB-SC modulator as in the figure above? (If yes) what kind of filter should be used? Comment on the bandwidth of the filter and the minimum and/or maximum frequencies that the filter should allow to pass. c) What is the minimum usable value of wc?
Given the discrete time signal x[n] = cos((πn)/3) what are two different contiuous time signals that would produce the sequence when the sample frequency is 120Hz. Choose one on the image below
What is lag compensator? Draw its circuit diagram and derive the expression for the transfer function of lag compensator
Explain what we mean when we say that two filters are cascaded.