Bromine monochloride decomposes to form chlorine and bromine. 2BrCI(g) → Cl2(g) + Br2(g) At a certain temperature, the equilibrium constant for the reaction is 11.1, and the equilibrium mixture contains 4.00 mol Cl2. How many moles of Br, and BrCl are present in the equilibrium mixture? Assume that initially only pure BrCl existed and that the container has a volume of 1.0 L.

Q: Given the Ksp for Ag2CrO4 is equal to 1.20 x 10-12, calculate the percent error in your…

A: The Ksp  for Ag2CrO4 = 1.20 x10^-12  The average Ksp of Ag2CrO4 is found to be 1.1x10^-12

Q: A sample (50 mL) of a bottled water was added to a 100 mL volumetric flask and then diluted to the…

A: The dilution takes place twice. First the original sample (50 mL) is diluted to 100 mL stock…

Q: Which of the following given statements is false? 1. The electrical conductivity of water is…

A: The question is of true - false. Here out of four options one option is false. Question 1st is based…

Q: Required Concentration of Reagent 1.37 mM NaCl 27 mM KCI 100 mM Na₂HPO4 18 mM KH₂PO4 Molecular…

A:

Q: Data: (make sure to include appropriate units) Unknown number 1.509g Trial 1 Trial 2 0.51ml 1.15ml…

A: • In a balanced chemical reaction the reactants react and products form in the molar ratio of their…

Q: Determine the moisture content of the crystalline solid that weighs 4.8756g after staying in the…

A: In the given question we have to calculate the moisture content in the solid. given data:  wet…

Q: 5. Why is decantation rather than filtration the preferred method of separating the salt from the…

A:

Q: A concentration of toxic metals in plant tissue is often found by combusting the material in a…

A: The 0.5124 g sample of leaves was finally filtered into a 50 mL volumetric flask and brought to…

Q: Which method would you use for quantitative analysis of O3, NOx, CO, alkanes? Explain their…

A:

Q: Newly produced beer must be checked to see if it meets predetermined standards. The percentage of…

A: The percentage of ethanol in the volume of beer is calculated by the formula: % of ethanol=Volume of…

Q: How to prepare the solutions listed below Solution 1) 25 mL 7 M sulfuric acid and the respective…

A: Molarity (M) is the number of moles of solute present in per liter of the solution.  Its unit is…

Q: Two white crystalline samples were left on the bench after an experiment. To help identify | them,…

A:

Q: MW= 618.06 g/mol MW= 618.06 g/mol MW= 590.00 g/mol MW= 646.14 g/mol

A: The average molecular weight will be 618.07 g/mol.

Q: Calculate the ionic stegth of  0.1121 M AgNO3+0.0950M MgCl2 + 0.1040 M Al Cl3

A: The equation is given belowThe concentrations are[Ag+]= 0.1121M[NO3]=0.1121M

Q: Part C: Determination of the alcohol content of unknown liquor Stretien Volume (mL) Sample ТИШТИНА…

A: The objective of this question is to determine the alcohol content of an unknown liquor sample using…

Q: Can you calculate the limiting reagent, theoretical yield and% Reaction Yield shown using reaction…

A: The given datas are : moles of benzaldehyde = 0.0293  moles of acetone = 0.0135

Q: What if the second was parts per million instead of parts per billion?

A: (b) mass of Fe2+ = 2.443 mass of ground water = 1762 kgFormula to calculate concentration in ppm…

Q: In the reaction series below, write down the appropriate reagents that can be used where there are…

A: The reaction  is completed in the diagram below.

Q: what sources occur in a experimental error in a reaction of sodium bicarbonate with hydrochloric…

A: the solution is shown below.

Q: A chemist prepares a solution of zinc nitrate by measuring out 78. umol of zinc nitrate into a 100.…

A: Given: The number of micromoles of zinc nitrate present = 78 μmol The volume of the solution = 100…

Q: You created a standard curve and calculated the slope to be 66.41. After synthesizing your copper…

A: Given, Slope= 66.41  weight of copper = 0.052 grams  Absorbance = 0.29 By applying Beer's law to…

Q: Find out the vitamin C content. Put vitamin C in sulfuric acid and then rinse with water, 250cm3.…

A: Iodometry is a titration technique in which iodine is indirectly liberated during the reaction which…

Q: The data below apply to questions 13 - 18. A sample is believed to consist of Epsom Salt, MgSO47H2O.…

A:

Q: Exactly 1.00 grams of granular table salt was dissolved in deionized water up to 500 mL. An aliquot…

A:

Q: A patient's blood pressure read as 130/85 mm Hg.  Express both numbers in terms of pounds per square…

A: A patient's blood pressure read as 130/85 mm Hg. 760 mm/Hg = 14.7 psi

Q: polymerize [org]

A: The given polymer is shown below.We have to determine the monomer structure.

Q: Give correct detailed Solution with explanation needed..show work..don't give Handwritten…

A: The objective of the question is to write a balanced chemical equation for the reaction of nitrogen…

Q: lon exchange is used to remove water hardness of a well water, which has a total hardness of 450…

A: Given data : Inlet water hardness = 450 mg/L Water hardness after treatment(due to leakage) = 15…

Q: The molarity of a solution is determined by four separate titrations or replicates, where the…

A: Given, Data set  of molarity value determined by four separate titration or replicates ,…

Q: 6. A 190 lb worker in a factory received an exposure to AB which has a molecular weight (MW) of 278…

A: 1 lb = 0.454 kg Given, Total urine excreted - 2060 mL Concentration of A in urine - 1.28 ng/mL MW of…

Q: 5ml of water is used to extract NO ‐1 from A wet soil sample weighing 10 grams. Another sample of…

A: IMPORTANT POINTS. The language of the question is a little ambiguous because of which the question…

Q: suppose 490.82 mg of dibenzalacetone was used to recrystalize. at the end, the recovered crystals…

A: Percentage recovery is defined as the ratio of amount of substance actually collected to the amount…

Q: You dissolve 14 g of solution? Show your work. Mg(NO3)2 in water and dilute to 750 mL. What is the…

A:

Q: (a) Consider a pesticide being sprayed onto agricultural land by a farmer. Describe the movement…

A:

Q: 3.Corev was synthesizing a chemical in the laboratory. He used different purification techniques to…

A: Since you have asked multiple questions, we will solve the first one for you. For remaining…

Q: Kerosene has a specific weight of γ_k = 51.1 lb/ft³ and benzene has a specific weight of γ_b = 56.2…

A: Density of substance is calculated by dividing mass with volume.

Q: Calculate the theoretical percentage of water in calcium nitrate tetrahydrate and show your work.

A:

Q: Devise a dilution scheme to make a dilution factor (DF) of 4.2 x 104. Don’t worry about making…

A: A serial dilution is any dilution in which the concentration decreases by the same factor in each…

Q: If in the reaction between 3A + B reacts to form a product. The concentration of A taken is 5.0…

A:

Q: Question 4. In the course material you have been introduced to multiple charging for electrospray…

A: The objective of this question is to determine the mass and structure of molecules, including…

Q: 3) "For one smalt bass which could have been bought at any trustworthy market for sixty-five cents,…

A: The author says " Some poor little kitten fish offspring of a catfish whose mother's milk is not yet…

Q: c) S03(g) +. _H20(g)

A: When  sulphur trioxide is treated with water then the reaction is done which is known as hydrolysis…

Micelles and Biological Membrane

Micelles are the type of lipid molecules that organize themselves in spherical shape in aqueous solutions. The production of the micelle is a reply to the amphipathic behavior of fatty acids. It means that they consist of both hydrophobic regions and hydrophilic regions. In micelles, polar head groups (hydrophilic groups) produce an outer layer associated with water whereas nonpolar tails (hydrophobic groups) are organized in the interior.