! + Both ends ofa Gm long melel rod ane keptat atemperotune of 240°C at x-0 md 120°C ot x = 4m.the conductivityThe diame ler of the bar is 02m,Cafficiant is 400 w Im'c, t he ambient tempeatuneis 20°c nd the heat tensfer to the enuinanmentis by conueetion. Coe fficiant i's 1o wm2.Find the tempea tenes of Ti, T2,cnd T3 at these thneenodes ushg the finite differen ce method by sdecding 3nodes inside the bor:

The convective heat transfer coefficient is h=10 W/m2.K The thermal conductivity is k=400 W/m°C. The…

+ Both ends of a 4m long metal rod are kept at a temperature of 240°C at x = 0 and 120°C ot x = 4m. The diameter of the bar is 0.2m, the conductivity Coefficient is 400 W/m°c, the ambient temperature is 20°C and the heat transfer to the environment is by convection. Coefficient is 10 w/m 2. 로 Find the temperatures of T₁, T2, and T3 at these three nodes using the finite difference method by selecting 3 nodes inside the bor.

+ Both ends of a 4m long metal rod are kept at a temperature of 240°C at x = 0 and 120°C ot x = 4m. The diameter of the bar is 0.2m, the conductivity Coefficient is 400 W/m°c, the ambient temperature is 20°C and the heat transfer to the environment is by convection. Coefficient is 10 w/m 2. 로 Find the temperatures of T₁, T2, and T3 at these three nodes using the finite difference method by selecting 3 nodes inside the bor.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If drawn on an x-y plane what would it look like?
I didn't understand how you find the angle Alpha = 21.63
Answer the attached file
Show all work and steps please
Q1. The part shown below will be turned in two machining steps. In the first step a length of (50 + 50) = 100 mm will be reduced from Ø100 mm to Ø80 mm and in the second step a length of 50 mm will be reduced from Ø80 mm to Ø60 mm. Calculate the required total machining time T with the following cutting conditions: Cutting speed V=80 m/min, Feed is f=0.8 mm/rev, Depth of cut 3 mm per pass. Ø100 Ø80 Ø60 50 50
are you sure it's not c?, can you show with diagrams
Q1 (a) Figure Q1(a) shows a gear system. Find (i) The relationship between the number of the gear teeth N1 & N2 and the radius rl & r2 (ii) The distance travelled along the surface of each gear (iii) The work done of each gear
Write the formula for Macaulay Functions?
Can some one please help to solve this question following the directions and showing neat work and formulas. PLEASE AND THANK YOU!!!