B/A gas cylinder holds 0.1 mole of O2 at 150 °C and pressure of 30 atm. The gas is expands adiabatically until the pressure is halved. What are the final pressure, volume and temperature? A- How much work is done during the process. B-Represent the process on P-V diagram. Take; y = 1.365

Q: Iron ore is wet-milled, the mill produces a pulp at a rate of 1.54 t/hr. The mill product has a…

A: Mill Characteristics:Mill product rate (Q) = 1.54 t/hrLiquid-to-solids ratio (L/S) of mill product =…

Q: 12. Consider the phase diagram below. The end points A and B are at 31 wt% Ni and 42 wt% Ni. At the…

A: Given,

Q: 1. [Biofilter] A biofilter has been chosen for eliminating odour problems around a process plant.…

A:

Q: Consider a sample of disc-shaped (cylindrical) particles with circular cross-section of varying…

A: A disc-shaped with a circular cross-section of varying diameter D is given.Thickness is the same in…

Q: Design of Absorption Tower A mixture of gas containing 90.5% mole % Hydrogen peroxide (H₂O2) and…

A: It is given that,the fraction of methanol recovered is mole fraction of methanol in the gas mixture…

Q: Calculate the mass reduction (in kilograms) attained if aluminum (density = 2.70 Mg/m³) is used in…

A:

Q: Q2: An oil water capillary pressure experiment on a core sample gives the following results: Pc,o/w…

A: An oil-water capillary pressure experiment data is given as:sample is taken from  above oil-water…

Q: Problem 5 What is the heat effect when sufficient SO3() at 25°C is reacted with H₂O at 25°C to give…

A: It is given that  is being reacted with water at temperature  to form of at .The basis of solution…

Q: For a single component system at vapor liquid equilibrium, we know that: dG¹ = -s¹dT + VLdpsat : 0…

A: Given,

Q: A preliminary design has been made for a plant to produce 10,000 metric tons per year. the major…

A: This kind of project would require extensive information on the price of each of the major equipment…

Q: A heat pump is required for a single-family 2-story, 3-person, 30 ft x 30 ft x 18 ft (L x W x H),…

A: It is given that a heat pump is required for a family. The following data is given:indoor…

Q: Using the Redlich-Qwong equation for methane gas at 13.8 MPaa and 305 K with a volume of 71.0 L The…

A:

Q: how to obtain   opeerating line from component balance and boil up ratio

A: The segment of a distillation column located below the feed point in which the concentration of the…

Q: Explain the concept of chemical equilibrium and its importance in chemical reactions.

A: When both the forward and reverse reactions in a chemical reaction occur at the same pace and there…

Q: Consider a sample of cylindrical particles with circular cross-section of diameter D and with…

A: Here D represents the diameter of the particle, L1 is the length of Coarse particle, L2 is the…

Q: Draw another schematic drawing as well as show dead zones

A: A reactor dead zone is a poorly mixed area that affects the effective volume and overall efficiency…

Q: a) Calculate the pressure exerted by 5 kg of Carbon dioxide gas placed in a 2000-liter vessel at a…

A:

Q: 12.33. The solubility of nonpolar gases in liquid water is typically very low. Consider nitrogen in…

A: The objective of the question is to understand the solubility of nonpolar gases in liquid water,…

Q: In a diving-chamber experiment, a human subject breathed a mixture of U₂ and He while small areas of…

A:

Q: What are (list and explain) some of the relationships between atomic scale and macro scale…

A: Understanding these relationships between atomic scale features and macro scale properties is…

Q: Helping you with the tables of thermodynamic properties (table of water and table of Refrigerant…

A: Given table is,SubstanceT(oC)P (kPa)v (m3/Kg)u (kJ/Kg)h (kJ/kg)ConditionQuality (X)Saturated…

Q: A heat pump cycle is used to maintain the interior of a building at 15°C. At steady state, the heat…

A:

Q: Suppose that exactly half of the annular volume between concentric, horizontal cylinders is filled…

A: Assuming steady, fully developed flow, determine Vy(y) in the liquid in terms of (At this point,…

Q: An incompressible Newtonian fluid is contained between two long concentric cylinders of radii ÀR (^<…

A: It is given that,incompressible Newtonian fluid,the flow is fully developed flow,steady state…

Q: A-B in an existing tubular reactor consisting of 50 parallel tubes 40 ft long with a 0.75-inch.…

A:

Q: Q1// Calculate change in standard enthalpy of formation AH (Fe203) and Standard Enthalpy of…

A: Calculating the standard enthalpy of formation:

Q: Q1/ A / A frictionless piston cylinder arrangement containing fluid 200 kJ of heat is transferred…

A:

Q: insulation °C). The respective 1- The 2- The

A:

Q: The manometer pictured has been filled with 2 different fluids and is open to the atmosphere on both…

A: A manometer is a pressure measuring and indicating instrument. Manometers are classified into two…

Q: 14.8. Knudsen flow in a membrane. A porous-glass membrane, with an average pore diameter of 40 Å, is…

A: Given,

Q: Describe the physical,chemical and biological components of leachate

A: The objective of the question is to understand the physical, chemical, and biological components of…

Q: Agitated Vessel advantages

A: Agitated vessel advantages

Q: Explain the concept of fluid flow and its significance in chemical engineering processes.

A: The study of fluids, which includes liquids and gases, is known as fluid flow. Fluids may flow and…

Q: Water is pumped at the rate of 1400 gpm through a centrifugal pump operating at a speed of 1750 rpm.…

A:

Q: 1. [Flow equalisation, effect of equalisation on BOD mass loading rate]. Consider the volumet…

A:

Q: sider a U-tube whose arms are open to the atmo one arm and light oil (poil = 790 kg/m³) from the…

A:

Q: The following three dialysis units are set up to purify urea from the raffinate stream. For these…

A: The following parameters are given,,Total area, Permeability, Number of stages for scenario 1,

Q: An experiment on the growth rate of certain organism requires an environment of humid air enriched…

A: It is given that, there are three input streams to produce an output stream of desired composition,…

Q: What is the best arrangement for double pipe heat exchanger used in chemical process and design…

A: Double pipe heat exchanger is the equipment used in chemical industries, food industries for removal…

Q: Below is shown the results for a series of cake filtration experiments on two types of waste sludges…

A: Correct. The higher slope (1.27) for Type B implies a greater increase in specific cake resistance…

Q: Suppose that exactly half of the annular volume between concentric, horizontal cylinders is filled…

A:

Q: DRAW 2D SCHEMATIC WITH A DETAIL A first order irreversible reaction is conducted in an 800 L…

A: A first-order irreversible reaction is conducted in a continuous stirred tank…

Q: 4. Steam enters a throttling valve (i.e. Joule-Thomson expansion) at 350 °C and 2 MPa, and leaves…

A: Steam inlet temperature = 350oCSteam inlet pressure = 2 MPaSteam outlet temperature = 300oCSteam…

Q: Exercises: 1) A rigid tank contains 50 kg of saturated liquid water at 90°C. Determine the pressure…

A: Amount of saturated liquid in tank = 50 KgTemperature of saturated liquid = 90oC

Q: 35 heat transfer area

A:

Q: A tank contains a two-phase liquid-vapor mixture of Refrigerant 22 at 7 bar. The mass of saturated…

A:

Q: 4. Please consider 500 gm of Ag (the system) that was heated from 27 °C to 127 °C (the process). a.…

A: We may divide the procedure into two parts to determine the quantity of heat delivered to the gas…

Q: 7.4 A normally consolidated clay is consolidated under a triaxial chamber con- fining pressure of…

A: It is given that normally consolidated clay is consolidated under a triaxial chamber .Confining…

Q: Ex) Air at 0 C and 1 atm flows at a velocity of 6 m/s across a rectangular plate at a uniform…

A:

Q: 2 1.Selectivity by Diffusion. The Thiele modulus for a spherical catalyst of radius a is p² = ka²/D…

A: The objective of the question is to derive the effectiveness factor for a spherical catalyst and…