b. 50ΩΣ 14 Ω 30 Ω m 3ΩΣ 20 Ω b {2Ω 30 Ω w 27 Ω 12 Ω Μ {24 Ω

Q: Find the equivalent resistance of the circuit below. 260 m b m 36 12 3 1802 www 60 100

A: Given- Resistances values = 36 ohm, 6 ohm, 10 ohm, 18 ohm, 26 ohm To find- Equivalent resistance =?

Q: The forward-path transfer function of a unity-feedback control system is 1000 G(s) s(s² + 105s +600)…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A d.c. shunt generator has a full load output of 10 kW at a terminal voltage of 240 V. The armature…

A: We have an shunt generator which has,   Full load output = 10 KW Voltage (V) = 240 V Armature…

Q: d.c. shunt motor

A:

Q: Q1. Multiple Choice Questions (MCQ): 1. In a horn antenna, with increase in aperture, the…

A: Given here a multiple choice questions and asked to answer those questions.

Q: An ideal DC/DC step-down converter is supplied by a direct voltage of 40V and operates in continuous…

A: Given data, Direct voltage applied Vs=40 V. Switching frequency, fs=20 kHz On state time, Ton=20 μs

Q: 2. Series RC Given: Complete the table below t 0 Ιτ 2T = E -120V = R 1kQ C 1000μF ER Ec

A:

Q: A 50 - resistor operates at room temperature (25°C). How much noise power does it provide to a…

A: It is given that: R=50 ΩT=25°C=25+273=298 KBandwidth for AM radio channel=B1=10 KHz=10×103…

Q: a) For the network of Fig. 1, determine the range of R₁, and I that will result in VRI being…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 1) For each of the transfer functions below, plot the poles and zeros on a s-plane. Find the damping…

A: Damping ratio ε :It is the measure of the decay of oscillations from one bounce to the next.  It is…

Q: Q1: In Matched filter, given the below input signal x(t), N, 10 Joul, find SNR. 3 2 1 x(t) 2 8 9 10

A:

Q: PRACTICE EXERCISE 4.2 Three identical small spheres of mass m are suspended from a common point by…

A: Given: P is the common point, Fe = the force exerted by the other 2 spheres, mg = the force exerted…

Q: Calculate the harmonic distortion component for an output signal having a fundamental amplitude of 3…

A:

Q: Calculate the efficiency of a class B amplifier for a supply voltage of VCC = 20 V with peak output…

A:

Q: 1) Find the inverse Laplace transform of the ff: 10(s+2) s(s+1)(s+10) (a) G(s) (b) G(s) = = 10s(s+…

A:

Q: (5) If Sxx (@) is a psd of the WSS random process X(t), then XX 1 2π [Sxx (@do = A{E[X² (1)]} = R₁x…

A:

Q: In the network given in figure use nodal analysis to determine (a) the voltage at nodes 1 and 2, (b)…

A: In this question,  We need to determine the voltage across the nodes as shown the circuit using the…

Q: Solve the required requirements and show your complete solution Il = 20mA 3.3v R1 =? ww 2.2v 12 =?…

A:

Q: 1. 2. Connect 3.5-V (rms) ac source across the circuit as shown. 1 Vc = E 3.5 Vrms 500 Hz 0° lc = 2.…

A: Here: E=3.5 Vrms f=500Hz R=10 ohm C=1 micro F Current through C=? Voltage Across C=?

Q: a) Design the Colpitts oscillator using JFET. let gm = 30 mA/V the circuit to oscillate at fo = 750…

A:

Q: Q1. Multiple Choice Questions (MCQ): 1. For a horn antenna, in which flaring is done only in one…

A: 1) For a horn antenna , in which flaring is done only in one direction is Sectoral antenna.…

Q: The Transfer function T(S)

A:

Q: coil of power factor 0.4 is in series with a 50-μF capacitor. The p.d. across the coil is equa to…

A:

Q: Assume that the input voltage is 10.4V. The current through the mA. (Write feedback resistor when…

A: We need to find out current through feedback register for given circuit

Q: A three-phase induction motor is supplied from a 50 Hz supply and runs at 1200 rev/min when the slip…

A:

Q: Two impedance Z1 = (10+j7) Qand Z2= (6-j4) № are connected in parallel and this combination takes 10…

A:

Q: Given vectors: Ā= αāx + āy +4āz B = - 3āx + ßāy − 6āz C = 5āx - 2y + yāz *** Determine a, p, and y…

A: We need to find out value of unknown for given vector for given conditions

Q: Use the tables to find the z transforms of the following j. 2n k. (-3) 1. sin(nπ/2)

A: Z transform can be unilateral and bilateral.The Bilateral Z transform is known as two sided Z…

Q: A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the…

A:

Q: solve this please and thank u

A: Signal is given here the amplitude of squre wave is considered as one and the complex exponential…

Q: Q2. True or False Questions: 1. Hydrometeor Attenuation is a reduction in signal amplitude caused by…

A:

Q: How many digits is the Octal System capable of having?

A: Numbers can be represented using various number system. Four basic number systems are - Decimal…

Q: Consider the difference equation Y(n)+ y(n-1)-6Y(n-2) = 8u(n) determine the complementary solution…

A:

Q: 4. A Si p-n junction diode with a built-in potential of 0.75 V at 300 K and the depletion region in…

A: Given, Built-in potential VB=0.75V, Temperature T=300K Depletion region at p side WP=100×Depletion…

Q: If the base kVA is 25,000 then a 5000 KVA alternator with 8% reactance will have Select one: OaA 4%…

A: Given, Base kVA, SBnew=25000 kVA. Alternator kVA, SBold=5000 kVA. Reactance, Xold=8%.

Q: Q4. The skin depth of a certain non magnetic conducting material is 3 um at 2 GHz. Determine the…

A:

Q: Two wattmeter's connected to measure three phase power for star connected loads read 10kW and 5kW.…

A:

Q: How; find Exsol/Eis ei Ⓒ R₁ D 20000000 L с AMA R₂ 12 + Rs lo 1

A:

Q: A 50 Hz, 22 kV generator is corrected to a power system. The system inductance (L) and capacitance…

A:

Q: VI 5 ΚΩ B A 10 ΚΩ с mim mm 2 ΚΩ · 1 ΚΩ 8 ΚΩ V₂ a) Find the closed loop voltage gain, ACL b) Given v₁…

A:

Q: What is the effect in the overall capacitance, stored charge and energy of a network of identical…

A:

Q: A pure element is connected across an AC signal. CH1 and CH2 measures the voltage and current…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A 2-wire d.c. distributor 300 metres long is uniformly loaded with 4A/metre. Resistance of single…

A: We have a DC 2-wire distributor which is, Length of distributor (l) = 300 meter Current (i) = 4 A /…

Q: Q1/ To Design parallel adder that add two numbers A (5-bit) and B (7-bit) must using None of them O…

A: Given data, Parallel adder to add is of, A (5-bits) B (7-bits)

Q: Q/ Desgin parallel adder to add 5 numbers (4 bit) must use? 2(4bit Parallel ader) + 21 8 bit…

A: A Parallel Adder is a digital circuit that efficiently adds 1-bit or more binary numbers. Parallel…

Q: The (110) plane - calculate the surface density of atoms using the value of a from Task 2 and enter…

A:

Q: The cross-sectional area of a transformer limb is 80 cm2 and the volume of the transformer core is…

A: Given parameters are: The cross-sectional area of a transformer limb,Ac=80cm2=80×10-4m2 The volume…

Q: A balanced star connected load of (8+j 6)Ω per phase in connected to a balanced 3-phase 400 V supply…

A:

Q: 2. If 1 micro-W signal is input to an amplifier which outputs 10 mW, what is the normal gain

A: Given: An amplifier has, Input signal power, Pin=1 μW. Output signal power, P0=10 mW.

Q: MCQ: Power of machine when work done is 30 J in a time interval 5 seconds will be 120 W 125 W

A: Given data, Work done W = 30 J, Time interval, t=5 sec.