b)You have been contracted to design a memory system for acomputer. Assuming the processor has 20 address lines, determine thenumber of 16 KB memories that can be placed (without overlapping) inthe memory space of a processor.Determine the sampling rate for an analog telephone signaltransmitted across a single channel of a T1 line with a data rate of 256Kbps (kilobits per second), assuming that a single sample is converted toa 16-bit integer.c)

b.)26= 64 memories Explanation:- Given:- Number of address lines in the processor=20 Number of 16KB…

b) You have been contracted to design a memory system for a computer. Assuming the processor has 20 address lines, determine the number of 16 KB memories that can be placed (without overlapping) i the memory space of a processor. c) Determine the sampling rate for an analog telephone signal transmitted across a single channel of a T1 line with a data rate of 256

b) You have been contracted to design a memory system for a computer. Assuming the processor has 20 address lines, determine the number of 16 KB memories that can be placed (without overlapping) i the memory space of a processor. c) Determine the sampling rate for an analog telephone signal transmitted across a single channel of a T1 line with a data rate of 256

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

A large endian byte addressed memory system with eight distinct memory modules is included in a computer system. Each memory module has 134217728 cells and is 32 bits wide. a) What is the 32-bit memory address of cell 1048578 in module 3 if the memory uses high order interleaving? b) What is the 32-bit memory address of byte 1048575 inside module 2 if the memory uses high order interleaving? c) What is the 32-bit memory address of cell 511 inside module 1 if the high order interleaved memory utilises little endian storage order instead of big endian storage order?
Q: The ENIAC was a decimal machine, where a register was represented by a ring of 10 vacuum tubes. At any time, only one vacuum tube was in the ON state, representing one of the 10 digits. Assuming that ENIAC had the capability to have multiple vacuum tubes in the ON and OFF state simultaneously, Compare how Little’s and Amdahl’s law will work on it? Note: this question is related from computer architecture subject kindly solved this correctly and completly.
Assume that in the system of the preceding problem, a memory cycle takes 750 ns. To what value could we reduce the clocking rate of the bus without effect on the attain- able data transfer rate?
Translate the below C code into RISC-V architecture, assuming that the values of i and j are placed in registers x23 and x24 respectively. The base address of array B is in register x30, and the base address of array C is in register x31. C[7] = B[i+j];
The addresses assigned to the four registen of the 110 interface of Fig. 11-2 are fqual to the binary equivalent ol U. 13, 14, and 15. Show the external circuit that must be connected between an &-bit 110 address from the CPU and the CS, RSI, and RSO Inputs olthe Interface.
3. If we have an 8 bit microcontroller that has 4kB of instruction memory starting at address 0x0000, and 2kB of data memory immediately above that, what is the next available byte in our address map?
translate c code in risc-v 32 bit assembly instructions, then convert to machine code(hex) variables a, b, and c are stored in a1, a2, and a3, respectively. Use register a1 for all intermediate values. C code: a=b+c-64; here's what i have so far addi a1,a2,a3 addi a1,a3,-64
3. Given the data 0X123456789ABC and the starting location (lowest address) of data memory (0x018) to store this data in an 8-bit MCU, please show the memory maps for both endian systems.
A computer employs RAM chips of 512 x 4 and ROM chips of 256 x 8. The computer system needs 1KB of RAM, and 512 x 8 ROM and an interface unit with 256 registers each. A memory-mapped I/O configuration is used. The two higher -order bits of the address bus are assigned 00 for RAM, O1 for ROM, and 10 for interface. a) How many lines must be decoded for chip select? Specify the size of the decoder b) Draw a memory-address map for the system and Give the address range in hexadecimal for RAM, ROM c) Develop a chip layout for the above said specifications.
Suppose a DRAM memory has 4 K rows in its array of bit cells, its refreshing period is 64 ms and 4 clock cycles are needed to access each row. What is the time needed to refresh the memory if clock rate is 133 MHz? What fraction of the memory's time is spent performing refreshes?
Consider the RAM16X8 of SAP-1 whose contents are given (in hexadecimal) as following. Address (Hex) 8-bit Contents (In Hex) 0x0 0x0A 0x1 0x1B 0x2 0x1C 0x3 0x1D 0x4 0x2E 0x5 0x2F 0x6 0xCF 0x7 0xFF 0x8 0x00 0x9 0x01 0xA 0x07 0xB 0x01 0xC 0x02 0xD 0x02 0xE 0x01 0xF 0x01 Let's consider the first 8 memory locations are reserved for Instructions and remaining memory locations contain data operands. You are requested to present in Binary and Hexadecimal, the output of the program stored in memory.
The ENIAC was a decimal machine, where a register was represented by a ring of 10 vacuum tubes. At any time, only one vacuum tube was in the ON state, representing one of the 10 digits. Assuming that ENIAC had the capability to have multiple vacuum tubes in the ON and OFF state simultaneously, Compare how Little’s and Amdahl’s law will work on it?