b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator connected through a three phase transmission line to a Y-connected load. The transmission line has an impedance of 0.06 + j0.12 2 per phase, and the load has an impedance of 12 + j9 2 per phase. For this simple power system below;

b) A 208-V three-phase power system consists of an ideal 208-V Y- connected three-phase generator connected through a three phase transmission line to a Y-connected load. The transmission line has an impedance of 0.06 + j0.12 2 per phase, and the load has an impedance of 12 + j9 2 per phase. For this simple power system below;

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.41P

See similar textbooks

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
Q2) A 13.2-kV single-phase generator supplies power to a load through a transmission line. The load's impedance is Ztoad 500 236.87° ohm , and the transmission line's impedance is Zine = 60 253.1° ohm. To reduce transmission line losses to 0.0103 of its losses without using the transformers design and use two transformers T1 between the generator and the transmission line and T2 between the transmission line and the load.
A 3-phase generator possesses a synchronous reactance of 60 and the excitation (induced) voltage Eo is 3 KV per phase. Calculate line-to-neutral voltage E for a resistive load of 82 and draw the phasor diagram.
A 3-phase generator possesses a synchronous reactance of 62 (line reactance between the source and the load) and the excitation voltage Eo = 3KV (source) per phase. Calculate the line-to-neutral voltage ELoad for a balanced resistive load of 8. Also, draw a phasor diagram between three-phase source and load voltages.
two generators supplying a load. Generator I has a no-load frequency of 62.5 Hz and a slope Sp1 of I MW/Hz. Generator 2 has a no-load frequency of 62.0 Hz and a slope sp2 of I MW/Hz. The two generators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. (a) At what frequency is this system operating, and how much power is supplied by each of the two generators? (b) Suppose an additional I-MW load were attached to this power system. What would the new system frequency be, and how much power would Gl and G2 supply now? Generator 1 VT V2 Generator 2 VTí KVAR KVAR
Two SGs are supplying a load by Pwad with 0.9 PF lagging. Gi has a no-load frequency of 54H2, and a slope Spi=1.1MW/Hz. G2 has a no-load frequency of 51HZ, and a slope Spz=1.1MW/Hz. If the system frequency is 50HZ: 1. How much power is supplied by each generator? 2. What is the load power Pload? 3. Draw the house-diagram for this system. 4. Find the system frequency, if the governor set points on G1 are decreased by 1Hz.
Draw a complete equivalent circuit of one phase only of a synchronous generator. Then draw the phasor diagram for a unity power factor. Assume the phase resistance is ignored
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020°, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.332Z –120° A (C) 0.9962-120° A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
a syn A: A sylienfonotus generator of 100 MVA, 22 kV, and 0.25 pu transient reactance supplies a motor of 50 MVA, 22 kV, and 0.2 pu transient reactance. The motor is drawing 40 MW at 0.8 power factor leading and terminal voltage of 21.9 kV. The line connecting them has a reactance of 0.05 pu on a base of 100 MVA. Find the transient currents in the generator, the motor, and the fault when a 3-ph fault occurs at the motor terminals. Take SB = 100 MVA, VB = 22 kV, and use the internal voltages %3D %3D of the machines method.
Q2) A 13.2-kV single-phase generator supplies power to a load through a transmission line. The load's impedance is Zload = 500 236.87° ohm, and the transmission line's impedance is Zline = 60 253.1° ohm. To reduce transmission line losses to 0.0103 of its losses without using the transformers design and use two transformers T1 between the generator and the transmission line and T2 between the transmission line and the load.
A three-phase synchronous generator is being used as a source of power for a farm in a remote area of Sindh. The apparent power rating of this generator is 100 KVA and the line to line voltage is 3000 V at 50 Hz. The configuration is star. When the terminals of the alternator are short-circuited, and a field current of 40 A is applied, a short circuit current of 200 A flows where when the terminals are open-circuited, with the same field current 1040 V are measured across the terminals. Calculate the voltage regulation for fully loaded conditions having the PF of both 0.8 leading as well as lagging. Use phasor diagrams. The effective armature resistance of this generator is 0.2 ohms. (Hint: Synchronous Impedance = (O.C Voltage/phase) / (S.C Current/phase))
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through 3-phase transmission line as shown in Figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are E-1020 V, E₂102-90° V. E,= 10/120 V. The positive sequence component of the load current le (a) 1.3102-107 A (c) 0.9962-120° A ő 11.00 000 non voo 1.00 voo 1.00 000 pon voo 3.00 voo (b) 0.3322-120° A (d) 3.510-81" A