B-6-15. Determine the values of K, T₁, and T2 of the system shown in Figure 1 so that the dominant closed-loop poles have the damping ratio = 0.5 and the undamped natural frequency w₁ = 3 rad/sec. R T₁s + 1 K T2s+1 Figure 1. 10 s(s + 1)

Please help in all parts I will give Upvote

Perform an AC analysis for the following circuit. Show the waveform measured at the OUTPUT from 10 Hz to 100 kHz. +A V2 + V3 12 12 -V- Inverting Amplifier Circuit +Vin V1 R1 100 SINE(0 2 500) R2 200 -V+ U1 LT1028 OUTPUT

Questions: Draw output waveform for the following circuits if sinusoidal signal of 6V peak-to-peak with zero offset is applied at the input. Consider reference voltage VR = +2V R. VR Consider Zener voltage 2.5V Dz * R VR = -3V v,(f) 22

The parameters in the circuit shown in Figure-4 are Vp 0.7 V, Vi=2.3 V, and Vzz = 5.6 V. Find and plot Vo versus Vi over the range of -10 Vi+10 V (Hint: You can consider input signal as sine wave of amplitude of +10 V and -10 V). Note: please solve within 30 minutes. Avoid plagiarism.

Videos Set Notation (soluti... Required documents Sign in C In t - Final In the following circuit schematic, assume, Vs = +10 V R1 = 5 kQ R2 = 10 kQ R3 = 100 kQ C = 55 nF Calculate the output frequency in Hz. (Course Learning Outcome 61 R2 Vouti VEE 12V VCC 12V RI Your Answer: R3 LM318D -12V VEE LM318D 12V VOC Vout?

The serial data-input waveform (Data in) and data-select inputs (S0 and S1) are shown in Figure Determine the data-output waveforms from D0 through D3.

4. Design a clipper circuit which limits input signals to +3V and -2V. This means that the output signal should not rise above 3V and should not fall below -2V. Assume Vs has amplitude of 5V and a frequency of 1 kHz, Verify your design by computer simulation on a computer.

a circuit design for AB' + AC' + AD' + BCD   Thank you!

if anyone can help me with this plz