avdcceieration using an inclined plan Eplaeee 8) During vibrating spring experiment data table is given. Plot Force (y-axis) vs change in L(x-axis) and determine the slope Trial 1 Change in L in meters 0.50 0.80 1.40 1.90 Force (N) 1.5 3.0 4.5 6.0 4 t untor mins 20 of enerax and aluminum can gains 10 J energy. What is the

Q: Which of the following definitions describes a physical hazard?   A) The most commonly thought of…

A: Physical hazards are the situations of reasons that can cause harm to human life , with or without…

Q: Frem the tensile stress-strain behavier For the brass specimen ,0 the diameter is 12-8 mm Calcalate…

A: Modulus of elasticity, =stressσstrainε=200-150 MPa0.1-0.064=1388.88 Pa

Q: GIVEN) The length of a wire is increased by 1 mm on the application of a certain load. In a wire of…

A:

Q: 1. Explain what is happening at the tensile strength for a metal from a physical standpoint in 1-3…

A: Tensile strength:  The resistance of steel to breaking under tensile tension is known as tensile…

Q: A specimen of a 4340 steel alloy with a plane strain fracture toughness of 54.8 MPa/m (50 ksi/in )…

A:

Q: In part (b), do I need to take over the relative permittivity of AIR, that mean C new =…

A:

Q: QI/ The table below shows the values of stress amplitude and life cycles : Fatigue strength SE (Mpa)…

A:

Q: 1.) A round hollow steel shaft has an inside diameter of 20mm, and transmits 10 kW at 1740 rpm.…

A:

Q: 1) Determine the largest weight W that can be supported by two wires shown in Fig. below. The stress…

A: Draw the free body and force diagram as below. As given, The stress on both wires,…

Q: Net force-a person pushing on a wall would equal 0 net force 19. Draw a Free Body Diagram of your…

A:

Q: 5.9 A composite spring has two steel springs connected in series. One of the springs has a mean coil…

A: a) It is given that the energy stored in both the springs are same, So, U1=U2 32 P12R13n1G54=32…

Q: What can be said about the curves in the stress-strain graph given below Strain A Polymer A isa soft…

A:

Q: nee

A: Given: Fatigue testing is 150 MPa

Q: The figure presents the stress as a function of the common strain for a ductile metal under a given…

A: Given,  the graph of stress-strain of a ductile metal To find which are true.

Q: Find the modulus of elasticity of a cast iron rod of diameter 20 mm and length 250 mm subjected to a…

A: Diameter of rod = 20 mm So, radius, r = 10 mm = 10-2 m Length of rod, L = 250 mm = 0.25 m Tensile…

Q: embankment at points A surface.

A: Given as,

Q: A sample of metal is subjected to a force which increases to a maximum value and then decreases back…

A:

Q: 5 A tensile force is applied on a rod axially of 18 mm in diameter that is deformed elastically.…

A:

Q: Which

A: D

Q: QUESTION 6

A: Answer            C. Elastic limit

Q: 1. Choose the correc a. f has a local ma b. f has a local ma c. f has a local ma d. f does not have…

A: Given: Graph between derivative of f and x To Find: (a) local maximum value (b) concavity statement

Q: In Buckling test: find Fc for the steel rod with dimensions (b-4.0 mm, h-2.0mm), its E =200 Mpa, and…

A: Given that, the rod is fixed E=200 MPa=200 N/mm2L=25 cm=750 mmb=4.0 mmh=2.0 mm The formula to…

Q: Find modulus of elasticity of a brass rod of length 200 mm which is subjected to a tensile stress of…

A: Given :- length of rod = 200 mm stress = 275 MPa extension of rod =0.55mm therefore strain =…

Q: Stress/MPa O 1200 3000 800 600 400 % 该 t 0.5 15 Stra/ O Figure 1: Stress vs strain plot for a…

A: Given: Stress vs strain

Q: Describe how longitudinal stability is achieved for Bell helicopters

A:

Q: Drawa FBD of node B and using jolent method at B determine the forces in members BA and Bc. Note…

A: Answer..

Q: Sample Problem 4/2: Calculate the forces induced in members KL, CL, and CB by the 20- ton load on…

A:

Q: 444 N A uniform bar AB is resting in a horizontal position on smooth inclines as shown below.…

A:

Q: QUESTION 17 (a) Calculate reactions at A and B in beam shown in Figure Q17 (b) Determine the…

A: Since the system is in the equilibrium, therefore the net moment at point A will be zero. Therefore…

Q: In which of the following condition particle can not be defined as in equilibrium state? a. none of…

A:

Q: 5An instrument spring made of phosphor bronze strip has a length of 400 mm, a width of 0.7 mm and a…

A: The required torque to do so can be calculated  by the  using concept of modulus of rigidity  (G)…

Q: 1. A propeller 1 f t in diameter rotates at 1200 rpm in water and absorbs 2 hp. Find the power…

A: "As per the guidelines i solved the first question alone". 1. The power is converted in watts. P=2…

Q: A Ti-6AI-25n-4Zr-6Mo titanium alloy subjected to a stress of 20 ksi. How long can the alloy be used…

A:

Q: 1. A polycrystalline cylindrical rod 120 mm long and having a diameter of 10 mm is to be deformed…

A: Given data: The  length of rod is l=120 mm. The diameter of rod is d=10 mm. Tensile force in rod is…

Q: An empirical pressure-density relationship for water is given as Pa 2 - 2001x - 2000 (Here, su Pu…

A: To determine: The bulk modulus of elasticity at 3 atmospheric pressure.  Note: 1 atmospheric…

Q: Ms Bowen is curious about what type of tape is the strongest and decides to develop an experiment to…

A: In experimental research, the independent variable and dependent variable are key components that…

Q: ) What is luminescence? Briefly discuss the mechanism of LED with a neat sketch.

A:

Q: Describe dynamical method (Maxwell's vibrating needle method) of determination of modulus of…

A: We have to explain the method (dynamical) of determination of modulus of rigidity of maxwell's…