Assume that the contents of 8086 microprocessor registers are: DS= 3300H, CS=1033H, SS= 1614H, SP= 1200H, and IP= 3400H. If the stack memory located at physical memory location 26130H, does the segment cover this range? If not, what changes need to be made?
Q: Given an input energy from sunlight of 1000 kWh, solar panels can generate about 170 kWh of…
A: The efficiency of the solar panel is, ηsolar=PoutPinPout=170 kWhPin=1000…
Q: Question 1 Find the convolution by the graphical method for x(k) Lul 1 234 -2-1 5 67 h(K) 4 5 6 7 8
A:
Q: Question 41 What is the typical single-mode fiber core size for 1310 nm and 1550 nm connections? Og…
A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…
Q: A 3-phase, Y-connected syn. generator supplies current of 10 A having phase angle of 20° lagging at…
A:
Q: Q1) For the circuit shown in fig.(*), the supply voltage is v(t) = 50+ 40 sin(wt) + 30 sin(3wt-30) +…
A: In this question we need to find a power factor of the given circuit.
Q: The direction of the field pattern in going and outgoing produced by a current flowing through a…
A: Single conductor Transmission line is a method of transmitting electrical power or signals using…
Q: Problem 2 Find VR (t) for all time t. 4 V ΖΩ F: t=0 I t=0 7. 2 H ww VR202
A: In the above given question they have mentioned a second order system which consists of inductor,…
Q: A load of 240 + j 120 is connected to a source of 480 V with a phase angle of 30o, through a…
A:
Q: Calculate the resonant frequency of the network show below. imm www R2 Az 2 46
A:
Q: Design synchronous 3-bit up counter with the following sequence 0, 1, 3, 4, 5, 7, 0 by using J-K…
A:
Q: Find the overall susceptance across terminal a-b when Vs = -2 sin(4t + 310°) V. ΖΩ 4 H ΖΩ a mm ww Vs…
A: In this question we will find overall susceptance across terminal ab in given question...
Q: Example 4.6: A varactor has a maximum capacitance of 80 pF and is used in a tuned circuit with a 100…
A:
Q: A // water treatment plant is used to process 30000 m²/d. The rapid mixing tank is to have a…
A: Given data, The Volume of the tank is 30000 m3/d Detention time is 1 min The value of the G is…
Q: Find the output waveshape in the following figure. Consider, silicon diode barrier potential 0.7V…
A: In this question, We need to draw the output voltage waveform. Assume forward bias voltage of si…
Q: 0.3/₁. A-in scott connection: 1- Draw the connection diagram. 2- Prove that when the load is balance…
A:
Q: multiplexer
A:
Q: Q6/ (Practical part) 1- Write the steps to solve the thevenin circuit with suitable diagrams and…
A:
Q: Q1) For the circuit shown in fig.(*), find the average power consumed in the 2 2 resistor if: v(t) =…
A:
Q: This is the answer plz write white page
A:
Q: How is a current of 10A shared by three circuits in parallel, the impedance of which are 2-j5),…
A:
Q: HW# 07 Q. Use the below PAL device to realize the logic functions f₁and f2 given by the following…
A: The Given Truthtable is x y t P1 P2 0 0 0 0 1 0 0 1 1 1 0 1 0 1 0 0 1 1 0 1 1 0 0 1 0…
Q: Resistance of 800 2 has a conductance of O125 millisiemens O 1.25 millisiemens O 12.5 millisiemens…
A: In this question we need to choose a correct option.
Q: A 20 KVA, 2200/220 V, 50 Hz, single phase transformer gave the following Test O.C. 220 V, 4.2 A, 148…
A: To calculate voltage regulation we need to find equivalent resistance and reactance of transformer…
Q: What will be the equivalent resistance between the terminal a & b for the below given electrical…
A: Given circuit,
Q: 5. Determine the total propagation delay from each input to each output for each circuit in Fig.…
A: Given gates diagram : (a) 74FXX (b). 74HCXX
Q: A. The i(t) though a 24 mH inductor is shown in Fig. 2.2a. Find and plot v(t) and the energy stored…
A: The voltage across the inductor can be calculated by using the general expression and the waveform…
Q: In an AC Motor, what is the function of a slip ring commutator?
A: We will refer the concept of slip ring commutator
Q: Find vo(t) using nodal analysis. 5 sin (1000 t) ↑ >30 Ω 10 Ω 10 Ω www 50 μF Vo(t) 10 mH
A: In this question, We need to determine the voltage Vo using the nodal analysis? We know XL = wL…
Q: 2 for the resonate at all frequencies. www R2 4 mB LOMF7 * below which will make the cir
A:
Q: A- in scott connection: 1- Draw the connection diagram. 2- Prove that when the load is balance then…
A:
Q: 2/ Consider CMOS inverter biased at VOD = 8v a with transistor parameters of KN = Kp and VTN = - VTP…
A: For the above given question we need to calculate the critical voltage on the voltage transfer curve…
Q: A 600 kVA single phase transformer with 0.012 pu resistance and 0.06 pu reactance is connected in…
A: Given that , there are two transformer of 600 kVA and 300 KVA We will refer the concept of parallel…
Q: Q5. Calculate the maximum and minimum collector curr (fig. 6) and find Icsat. and VCEsat. RB = 250…
A: Given circuit is shown below. I=IC+IB Apply KVL at input side 15=IRC+IBRB+0.714.3=IC+IBRC+IBRB
Q: Problem 4. Determine the value of voltage V sho in Figure 5.6. 4Ω 50 V- 6Ω V
A: Given circuit,
Q: Find the inverse z-transform of X (2) = 1 (1-0.25z-¹)
A: Given: Xz=11-0.25z-1
Q: (3) A digital system is required to amplify a binary encoded audio signal. The user should be able…
A: Answer:b) 6
Q: Q1 Write a sequence of instruction to poll switch at 17 of 74F244 that is connected to port 0. ALE…
A: The given figure is shown below:
Q: 9.32 Find I and Z in the circuit shown in Fig. P9.32 if Vg = 25 /0° Vand I = 5 /90° A. Figure P9.32…
A: The circuit diagram is shown below, Where,Vg=25∠0° VandIa=5∠90°A
Q: Q/Analyze the circuit using Nodel's theorem ? 252 4 A 452 252 1) 8 A
A:
Q: The region between concentric spherical conducting shells r=0.5 m and r = 1 m is charge free. If…
A:
Q: GCS) 1000 (5+5) S (S+36) (S +70) Analytical met
A:
Q: At 50Hz operation a single phase transformer has eddy current loss of 100 W, Its eddy current loss…
A:
Q: (2) An 8 bit successive approximation analog to digital converter has full scale reading of 2.55 V…
A: For the given 8 bit successive approximation ADC we need to calculate the conversion time for 2 volt…
Q: fa A 3-phase ring main ABCD fed at A at 11 kV supplies balanced loads of 50 A at 0.8 p.f. lagging at…
A: It is given that: Section AB=1+j0.6 ΩSection BC=1.2+j0.9 ΩSection CD=0.8+j0.5 ΩSection DA=3+j2 Ω
Q: An emergency stop system is to be designed for a certain automatic production machine. A single…
A: Consider X1= START button X2=STOP button X3=STOP button X4=machine X5=power to machine First of…
Q: A 20 KVA, 2200/220 V, 50 Hz, single phase transformer gave the following reading: O.C. Test: 220 V,…
A: In this question we need to find voltage regulation , maximum efficiency and equivalent circuit…
Q: Q1\ An ohmmeter has a moving coil of resistance 25 2 with 5mA full scale deflection current. The…
A: Given,For an ohm-meter,Internal resistance, Rin = 25 ΩFull scale deflection current, IF = 5mABattery…
Q: Q1: Answer two of the following questions: a) For the circuit shown in fig.(1), R v = 10e V and i =…
A:
Q: (a) Determine the value of Rf necessary for the circuit in oscillator. Use R₁ = R₂ = R3 = R = 10 k2…
A: a. Given data is for RC phase shift oscillator. R1=R2=R3=R=10k ohmC1=C2=C3=C=0.001μF For…
Q: Use the mesh-current method to find the steady- state expression for v, in the circuit seen in Fig.…
A:
Step by step
Solved in 2 steps
- 1. How do the data retention characteristics of RAM and ROM storage devices differ? 2. What is the purpose and use of the Program Counter (PC), Stack Pointer (SP), and Memory Address Register (MAR) registers? 3. Write an 8085 program to store 4EH in memory location 2840H and store 3EH in memory location 2841H, exchange them and store the result in memory locations 2842H and 2843H respectively. Solve this problem using three different methods. 4. Write a program to exchange the content of memory locations [2801] [2800] with [2803] [2802]. 5. The following program is supposed to add the contents of memory location 2050h to the Accumulator. The program works correctly only part of the time. Show that it is wrong to execute the program and how to correct it. MOV LDA ADC HLT В.А 2050H в 6. In a multibyte addition program, when you must use the ADD instruction? When you must use the ADC instruction? 7- The 8085-instruction set does not include a clear accumulator instruction. Which…4) Design and draw these memory units with their control circuits. Explain operations. a) A single EPROM 2716 is used with an 8088 microprocessor so that this microprocessor will see only X bytes of memory between the address range of DF800 –DFFFF or DD800 - DDFFF instead of 1M byte that it expects. Draw this circuit. What are X bytes? Do not use 74138 decoders. b) Design and show a 16K x 16-bit memory circuit by using 8K x 8-bit RAMS. Explain its operation. Do not use decoder 74138 chip.1. Write the contents of all registers and the conditions codes registers after each execution instructions in Table Q1(a). Instructions SUBS r0, rl, 12 MOV 12,13, ASR #3 ro 11223344 Table Q1 (a) rl F7770025 12 r3 CF119856 CF119856 NZ V C 010 1
- Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.8085 microprocessor went through its manipulation operation in the ALU, the results was transferred on the data bus and status of the results was stored in the flag register for indications . With your knowledge and understanding illustrate a complete bit configuration of 8085 flag register and show the functions of the represented bits in the register.2. a) Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address).
- B) Name the internal registers of 8086, Table the combination of registers to form the physical addresses for memory segments.The microprocessor unit that responsible for instruction queuing is .. O EU O ALU BIU O Segment registers O None of the above1- Identify the addressing mode for: MOV Cx, [SI] 2- The instruction that adds immediate datalcontents of memory location specified in an instruction/register to the contents of another register/memory location is a. SUB b. ADD c. MUL Share Content Participants
- 1. Draw the figure showing the types of registers in an 8086 microprocessor. Write the register group types explaining the functions shortly for each one.a.Write the addressing modes of the following instructions: (i) MOV A, @R0(ii) MOVX @DPTR, A (iii) MOVC A, @A+DPTR (iv) MOV R0, #45H b) Write instructions to perform the following operations: (i) Move the content of Accumulator to register 7(R7).(ii) Move the contents of RAM memory location 55H to Port 1(iii) Receive content from ROM Memory location 200H into Accumulator.(iv) Clear bit 7 of the Accumulator.c) Why 4-20mA Current loop is widely used Industrial Standard for sensor data transmission and control. What are its advantages over 0-12V Standard? d) Two configurations of GPIB is shown in Fig. A and Fig. B. Explain the working of GPIB in both the configurations and what are the differences between the two. this question is asked in microcontroller and microprocessorAssume register R0, R1 and R2 contain the value of 0x00000100, 0xAABB1122 and 0x00000102. ARM Cortex-M3 processor executes the instructions STR R1, [R0] and LDRB R1, [R2] in sequence. What is the content of register R1 if the storing mode of data in memory using Little Endian Mode? A. 0xAABB11BB B. 0xAABB1111 C. 0xAABB1122 D. 0x0000BBAA E. 0x00001122