Answered: As the ratio of the load resistance to…

As the ratio of the load resistance to the internal resistance increases, the power dissipated by the internal resistance decreases. (A True B False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Related questions

Q: The switch, which is in (a) position for a long time, is brought to (b) position at time t 0.…

Q: "The world energy demand is growing and the only sustainable solution to meet this energy demand is…

A: Sustainable energy: The energy which can be restored throughout a human lifetime and hence does not…

Q: 2. What is Kirchhoff's law of voltages? Draw a circuit to illustrate and write the mathematical…

A: Kirchhoff's Law of voltages: According to this law, the algebraic sum of all voltages in a loop must…

Q: 16 kfl For the circuit shown, determine Ve(t) and ic(t) then sketch them versus time. 1 10 us 20 nF…

Q: Example 1 Determine r, Z; (with r,=0), Z, (with r,=∞), A, (with r,=0). Repeat with r,=50 kN. 470 k2

A: The solution can be achieved as follows.

Q: Design a solar PV panel that can deliver 400W at 38V from a cross-sectional area of 12 square…

A: Given P=400 W required V=38 V cell details are cross sectional area =12 square centimeter cell…

Q: Q1) For the circuit shown in figure, obtain mesh currents. SV 4ohm C: 2 A 60 ww ww.

Q: Remove (R,) and measure (V) or (VAB) as shown below

A: Thevenin's Theorem Thevenin's theorem states that we can simplify a linear network no matter how…

Q: An independent voltage source providing a fixed voltage but essentially any energy. Select one: True…

A: Choose the correct options The given statment is false or true?

Q: o) Find the Current I: 600 120 50 A 60 800 40V Reg 150 200 %3D %3D %3D %3D %3D %3D %3D

Q: An electronic device is cooled by passing water at 333 K through small tubular passages with 2.54…

A: an electronic device is cooled by passing water at 333K through a small tubular passages with…

Q: For the general properties of a system i.e causality, linearity, and stability. Determine which…

A: GIVEN: (1) yn=n x n(2) Y(t)= x2(t) FIND: the given equation hold which of the following…

Q: The system of using helicopters to work on live power lines is based on the principle that…

A: The system of using helicopters to work on live power lines is based on the principle that…

Q: For a system if the value of damping o decreases, then the rise time is increased. Select one: O…

A: We need to tell about rise time as we vary damping .

Q: What does a dependent current source do? Give a real world application.

A: Dependent Current Source

Q: If ao is temperature coefficient of a resistance at 0 °C, then its temperature coefficient a at…

Q: What does a dependent voltage source do? Give a real world application.

A: The explanation is as follows.

Q: 6. (1 pt) Given the following second order system, what type of system is it? O Critically damped…

Q: 17. 7.17 PSPICEMULTISIM The 165 V, 5 Ω source in the circuit is inadvertently short-circuited at…

Q: Consider the given circuit where Ix= 30 µA. %3D 3.5 M2 1.2 M2 750 k2 7 M2 6 MQ 15 V Calculate the…

Q: Answer the questions below: For the circuit given below, compute for the value of Vx (assume the…

Q: t=0 be Il4 ww

A: Given:I1=12 AR=10000 ΩC=0.025 FL=20 H We will first find the initial inductor current.Just before…

Q: Consider the following circuit. What is the value of current I in the circuit shown? (a) I A (b) 2 A…

A: Given,

Q: 7 Renewable Energy Sources are readily available everywhere, whole year round. Select one: True…

A: RENEWABLE ENERGY SOURCES: Renewable energy is a type of energy produced from sources that do not…

Q: 'Design d.c voltmeter by using direct method with d'Arsonval meter of 50 2 and full scale deflection…

Q: Consider the circuit shown In the figure below. (Assume R, = 15.5 2 and R, = 5.50 N.) %3D %3D 25.0 V…

Q: A twelve volt battery is joined to a series circuit with an inductance of 0.5 henry and a 10 ohm…

A: PRESENCE OF SOURCE: In the presence of sources all the passive elements which are R, L and C always…

Q: R2 V.

A: In this question, we have to find out I1, I2 , I3 , I 4, I5 and voltage drop using Kirchhoff…

Q: Why is there a need to separate some appliances in a circuit and place them in their own circuits…

A: There is a need to separate some appliances in a circuit and place them in their own circuits…

Q: 1A (A ww 3Ω + 8F VC - The circuit above is in DC steady state. What is the value of v, in volts? 5Ω

Q: Q4:- An assembly consists of 8 classical systems distributed over five power strips with a single…

A: Given values are - NT=N1+N2+N3+N4+N5=8 1E1=0eVE2=1eVE3=2eVE4=3eVE5=4eVETotal=6eV

Q: Geothermal and Hydroelectric Energies are tapped to supply electricity in order to power our…

A: From the question Geothermal energy Heat with in earth heat energy can be transfer into electrical…

Q: True value: The actual value of a quantity. It is almost possible to obtain it in practice. Select…

A: In this question we need to verify the given statement is true or false

Q: For a system if the value of damping o increases, then the rise time is increased. Select one: O…

A: In the control system If the damping ratio increase then rise time?

Q: Given the system in Figure 3, design the value of K so that for an input of 100tu(t), there will be…

Q: 2- Find Y[n] by convolving x[n] and h(n), illustrate the process (Show the work), graphically or…

Q: Q10. What will be the total resistance of the given circuit? المقاومة الكلية ل لدائرة Ao ,50Ω 100 2…

A: The given circuit is,

Q: Using Kirchoff's Laws, what is the current flowing at R1? R2=10 Ra=0.5 0 E1=12 V E1=9 V R3=10 R1=10…

Q: Question 1 Using Kirchoff's Laws, what is the current flowing at R1? R2=10 Ra=0.5 0 E1=12 V E1=9 V…

A: Given circuit,

Q: Employ Kirchhoff's laws to analyze the circuit given below. Label the branch currents passing…

A: Given : Brief description: In the above given question first of all they have mentioned an…

Q: R1 R3 Ra Rs CR2 V13 V2 Figure 6.1 +

A: In superposition principle we have to calculate responses of circuit with individual sources acting…

Q: 240 N 800 N 12 k2 4 k2 + t=0 33.33 µF 12 kN. 20 V 200 2 500 mH 1) Find VI(t) for t>0 2) ic(t) for…

Q: An independent voltage source providing a fixed voltage but essentially any energy. Select one: True…

A: The independent voltage source is an ideal voltage source, it doesn't depend on any other source to…

Q: An independent current source having zero voltage across its terminals while providing a fixed…

Q: 2. Using the definitions of the ideal independent and dependent sources, state which…

Q: With a D'Arsonval movement with 100 internal resistance and 1 mA FSD current, it is required to…

A: In this question we need to find a value of series resistance of a multirange voltmeter.

Q: Potentiometer: The resistive wire AB in the circuit shown has the length of 100cm. When switch S is…

A: It is given that: R=6 ΩL=L1=0.4 mL=L2=0.2 mAB=100 cm

Q: Ex, Find the current (I) For the Circuit shown? 5 9.

A: The solution can be achieved as follows.

Question

As the ratio of the load resistance to the internal resistance increases, the power dissipated by the internal resistance
decreases.
(A True
(B) False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l3l4RTR182kR275kR356kR462kPT3.436WP1P2P3P4
What are interpoles, and what is their purpose?
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
B.. What is the load current for the circuit shown in the figure? Please choose one: a. 6.0 mA b. 3.0 mA C. 9.0 mA D. 7.5 mA
Which of the following statements is/are true? (A In purely inductive circuit, the current leads voltage. (B) In purely resistive circuit, the current lags voltage. C In purely resistive circuit, the current is in phase with voltage. D In purely capacitive circuit, the voltage lags current.
Determine the Branch Currents using Mesh Currents: a.) Branch ab b.) Branch ac c.) Branch bc NOTE: The unit of resistance is in ohms and the unit of the voltage supply is in volts.
Write the application of extra super tension that have rating 132KV and what used for?
Q4. The source current in the circuit shown is in Figure 3a) What impedance should be connected across terminals a,b for maximum average powertransfer?b) What is the average power transferred to the impedance in (a)?c) Assume that the load is restricted to pure resistance. What size resistor connected across a,bwill result in the maximum average power transferred?d) What is the average power transferred to the resistor in (c)?v
What approximation do we usually make in circuit theory? -A current-carrying particle is the current. -A current-carrying particle has no charge. -A current-carrying particle does't accelerate. -A current-carrying particle is mythical. -A current-carrying particle is massless Please see diagram for more details.
Consider the circuit shown in Figure P1.68. a. Which elements are in series?b. Which elements are in parallel? c. Apply Ohm’s and Kirchhoff’s laws to solve for R x.
Consider the circuit shown in Figure P1.66. a. Which elements are in series?b. Which elements are in parallel?c. Apply Ohm’s and Kirchhoff’s laws to solve for V x.
Find the equivalent resistance using (1)Delta Wye Transformation and confirm using (2)parallel-series simplification. Then get the total current. Note: Show each figure by redrawing. Also, find the total current delivered to the resistor network if a 24-VOLT DC BATTERY is applied.