Arigid rectangular tank of a volume of V-15.3 m contains Nitrogen. At t-0.0, Nitrogen enters the tank with a speed of 50 m/s and a density of 7 kg/m and escapes the tank with speed V=120 m/s and density of 6 kg/m. Find the rate of change of Nitrogen density in the tank at t=0.0. A=0.2 m

Arigid rectangular tank of a volume of V-15.3 m contains Nitrogen. At t-0.0, Nitrogen enters the tank with a speed of 50 m/s and a density of 7 kg/m and escapes the tank with speed V=120 m/s and density of 6 kg/m. Find the rate of change of Nitrogen density in the tank at t=0.0. A=0.2 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

Q: fluid passing a boundary of a system is 80,000 ft-lb. Determine the exit pressure if the inlet…

Q: What is the Ah in the mercury differential manometer when the volumetric water flow in the gradual…

Q: 8. A spherical balloon is being filled at a rate of 3 cm³ per 4 second. The Volume of a sphere is…

Q: What is the water velocity (m/s) at point A? Here h=28.5 cm

Q: An incompressible and Newtonian fluid is confined between two horizontal plates separated by a…

A: For solution refer below images.

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

Q: pls replyyy Air is flowing through a square conduit whose section changes from 100 mm (section 1) to…

A: Please refer to the detailed solution given below, Answer - Density of air at section 2 is 0.834…

Q: In the figure, the velocity of the water jet coming out of the 2.5 cm stationary fountain is given…

A: Given data: The diameter of the fountain is D = 2.5 cm. The velocity of the water jet coming out…

Q: In figure, Bernoulli's equation- ?between point 1 and 2 is Punp

Q: The power 395 W is required to transmit 5 x 10-3 m3/s of water. Find the loss of head due to…

A: P=ρgQH

Q: (d) Water of density 998 kg/m is moving with a speed of 6 m/s through pipe with cross-sectional area…

A: Every real fluid existing in nature must satisfy the equation of continuity. The equation says that…

Q: If the acceleration of the tank with water in the figure is 18m / s ^ 2, what is the pressure at…

A: The diagram of the water level in case of acceleration in the x-direction, The angle is calculated…

Q: pressurized water tank supplies water to a hose. The tank has a pressure of 155 kPa and the hose…

Q: A manometer of the shape shown in the figure has limb A filled with water and the limb B with oil…

Q: In the dam shown in the figure, the water flows at the entrance of the conduit with a speed of 0.4…

Q: an airplane is flying at a 4000 m elevation where the temperature is -11C and the density of air is…

Q: Time left 0:04:1 H R (m) Н (m) В (т) Sg 2.5 7.8 M R. Fresh 2.5 1.10 Water Determine the magnitude of…

A: Given: H=7.8m R=2.5m B=2.5m S.G=1.10

Q: Problem #1 WA A pump is used to transport water to a higher reservoir. If the water temperature is…

Q: Consider the pump shown in the figure. The water enters a filter before entering the pump. As the…

A: The conversion of mechanical energy to hydraulic energy by means of the machine (hydraulic) is…

Q: A water jet has a diameter of 75mm and ahs a velocity of 15m/s. What is the horsepower exerted by…

A: Given:- d=75mm Vjet=15m/s To find:- Horsepower exerted by the jet(F)

Q: His speed in still water?

A: Given; Swimming along the river flow:A swimmer can swim 30 km so,Distance, d=30kmand time,t=5…

Q: The velocity profile of a liquid flows through the z direction of the vertical tube (figure right)…

A: Given: r0= radius of the pipeVelocity profile,vz=12µdpdzr2-r02

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

Q: Water is flowing between wedge-shaped walls into a small opening as shown in the figure below. The…

Q: (b) Consider two identical water tanks (20 m x 10 m x 10 m) filled with water. The depth of water in…

A: given; ⇒identical dimension of two tank =(20m*10m*10m)⇒depth of first tank (w1)=8m⇒depth of water in…

Q: A ball weighing 1 kg is "floating" on a circular jet, as shown in the figure (ignore the wire, which…

A: To find: The height at which the ball will float. Given: The weight of the ball is m=1 kg. The…

Q: COnsider an airplane flying at a standard altitude of 6km with a velocity of 330m/s. At a point on…

Q: What time (in second) is required to fill the circular tank with incompressible water from h= 2 m to…

Q: Open tank (4.5 m long, 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this…

A: Length = 4.5 m Height = 2.5 m Width = 3 m Acceleration = 3.5 m/s2 Height of liquid = 1 m

Q: Water flows steadily through the elbow, placed horizontally on the surface shown in figure.…

Q: A nozzle of inlet area A₁ and exit area A2 exhausts to atmosphere. A fluid of density p enters the…

A: 3.(a)

Q: A cylinder with a mass 0.222 kg is sliding downwards through a vertically positioned pipe. A thin…

A: m=0.222 kgγoil=8044.2 N/m3voil=6×10-6 m2/L=128 mm

Q: /s and thegage pressure at the entrance is 250 kPa. Ignore weight of the fluid and the pipe.…

A: for solution refer below images.

Concept explainers

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.

Question

Oc 587.10015
d.505.20015
669.00015
Arigid rectangular tank of a volume of V-15.3 m contains Nitrogen. At t=0.0, Nitrogen enters the tank with a
speed of 50 m/s and a density of 7 kg/m and escapes the tank with speed V=120 m/s and density of 6
kg/m. Find the rate of change of Nitrogen density in the tank at t=0.0.
3
A=0.2 m
Nitrogen
A=0.2 m
Rigid tank

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Computation

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
You must have a diagram to show the force. Provide answer in detailed way
Consider the figure
the open tank in the figure contains water and is being filled through section 1. Assume incompressible flow. If the water level h is constant, determine the exit velocity V2 for the given data V1 = 3 m/s and Q3 = 0.01 m3/s.
kg Water (p = 1000- -) flows through the elbow below. The diameter of both the inlet and outlet is 1.1 cm, and the velocity through the nozzle is V =4.5 m/s. The outlet m³ has an angle of 0 =15 degrees. The water is at a pressure of 29 kPa (gauge). Find the magnitude of the force on the elbow. 0 V
Consider a frictionless, massless and leak-proof plug blocking a rectangular hole of dimensions 2Rx Lat the bottom of an open tank as shown in the figure. The head of the plug has the shape of a semi-cylinder of radius R. The tank is filled with a liquid of density p up to the tip of the plug. The gravitational acceleration is g. Neglect the effect of the atmospheric pressure. R R R g A+: Sectional view A-A The force Frequired to hold the plug in its position
A closed tank contain water up to a height of 2 m and over the water surface there is air having a pressure of 90 kPa above atmospheric pressure. Find the discharge through a small sharp-edged orifice of 15 cm dia. at the bottom of tank. Take C=0.6.
In the figure below, the tank containing the water is very large and open to the air, and the pipe through which the water drains is very small. The pipe is not open to the air and the water can be treated as an ideal fluid. Find the speed at which the water is traveling in the pipe.
Q4: A manometer of the shape shown in the figure has limb A filled with water and the limb B with oil with density 950 kg/m³. The area of the enlarged mouth portion is 50 time the area of the tube portion. If the pressure difference is 22 N/m² calculate the height h p2 p1 Ah water Oil Ah H=2h
A horizontal fan (such as that shown in example 5.24) pulls in stagnant air (ie. basically stationary air) atatmospheric pressure; the air approaches the fan outlet with speed 44 ft/sec (ie. 30 mph) and with static pressure 0.3 psi. The air flowing through the fan can be assumed to have a constant density of 2.4*10-3 slug/ft3. The air losses due to friction are 0.1 psi (or 6000 ft-lb/slug of air passing from the fan inlet to the outlet). a) Determine the shaft work in ft-lb/slug b) If the fan outlet area is 2 ft2, determine the rate of work on the air.
could you please help me calculate theheigth in metres of the fluid at time t= 100s
An airplane is flying at standard sea level. The measurement obtained from a Pitot tube mounted on the wing tip reads 2190 lb/ft2. What is the velocity of the airplane?