COnsider an airplane flying at a standard altitude of 6km with a velocity of 330m/s. At a point on the wing of the airplane, the velocity is 400m/s. Calculate the pressure at this point. Cp=1008 j/kgK. answer should be in metric. and detailed solution.

COnsider an airplane flying at a standard altitude of 6km with a velocity of 330m/s. At a point on the wing of the airplane, the velocity is 400m/s. Calculate the pressure at this point. Cp=1008 j/kgK. answer should be in metric. and detailed solution.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: What time (in second) is required to fill the circular tank with incompressible water from h= 2 m to…

Q: An incompressible fluid (kinematic viscosity, 7.4 x10-7 m2/s, specific gravity, 0.88) is held…

Q: What is the water velocity (m/s) at point A? Here h=28.5 cm

Q: A turbine with a power coefficient Cp = 0.26 is able to generate 3.5 MW of electrical power with…

Q: vn in the figure below has air of velocity V flowing as shown. If one of the pressure gages reads…

A: The gauge pressure at point 1 is .The gauge pressure at point 2 is .The specific weight of the air…

Q: ii. Water is rotated in a pump impeller at a speed of 1500 rpm. The inlet and outlet diameters are…

Q: At point in a pipe that lay flat water in the pipe flows a at spced of S.0 mls and has gauge…

A: by continuity equation Area * Velocity = constantArea at the end of the pipe = 4 Area at the start…

Q: pls replyyy Air is flowing through a square conduit whose section changes from 100 mm (section 1) to…

A: Please refer to the detailed solution given below, Answer - Density of air at section 2 is 0.834…

Q: 2000 cc. of air takes 12 minutes to pass through a standard specimen of sand (5.08 cm high and 5.08…

A: Option d is correct.

Q: Consider a container of machine nuts that is placed into water. The container is (3) large enough…

A: 4. According to Archimede's principle, the volume of water displaced by the nuts is equal to the…

Q: 2. If the velocity at point A is 25 meters per second, compute for the velocity at point C and the…

A: VA=25 m/s

Q: Can you show the solution in which you converted m=5gal/min=30.05 lbm/min using dimensional analysis

Q: A Pitot tube shown in the figure below has air of velocity V flowing as shown. If one of the…

Q: n fluid mechanic, what is dimensional analysis and what do i required to do a dimensional analysis…

A: Given Dimensional analysis To find Importance of dimensional analysis in fluid mechanics Importance…

Q: Problem (3) Find the rate of change of h(t) (mm/s) if water is the fluid at all locations. Use V₁ =…

A: given data V1 = 7.2 m/s Q3= 1000L/min find the rate of change of h(t) in mm/sec

Q: A jet flights with a speed of 291 m/s . If the jet's engine has a power of 1,462,823 W. what is the…

Q: an airplane is flying at a 4000 m elevation where the temperature is -11C and the density of air is…

Q: A flat plate of area 2x10 cm is pulled with a speed of 0.5 m/s relative to another located at a…

A: Given Area, A = 2 x 104 cm2 Velocity, v = 0.5 m/s Distance, y = 0.2 mm Find Force…

Q: quid is flowing in a pipeline 60 mm in diameter at 8.25 m/hr. If the density of fluid 820 kg. per…

Q: The tank of liquid in Fig. accelerates to the rightwith the fluid in rigid-body motion. ( a )…

A: Part (a) The expression for tanθ is, tanθ=axg.................(1) Here axis the acceleration in…

Q: Describe the general principles of dynamic fluid?

A: Fluid dynamics: It is a branch of applied science which deals with movements of fluids(liquid and…

Q: Take the densilty and pressure values at 7km, and then apply Bernoulli equation. I think this is the…

A: Given:h = 7 kmv1=300 m/sv2=400 m/sTo find:Pressure at that point, p2

Q: Some manometers are constructed as in Fig. , whereone side is a large reservoir (diameter D ) and…

A: The volume balance equation is given as VL=VSπ4D2H=π4d2hH=d2D2hNow we…

Q: Ql:: A 11 in diamcter of pipes and 14 in long slides along a large diameter cylinder at a speed of…

Q: Chlorine gas enters a 30-mm ID pipe at 15 m/s, and exits a wider pipe, at 85-mm ID. What is the…

Q: Airplanes typically fly at altitudes of 6 or 7 miles. Estimate the air pressure and density outside…

A: Pressure is defined as the ratio of force to the area on which force is applied. The ratio of mass…

Q: Water flows through a circular nozzle, exits into the air as a jet, and strikes a plate as shown in…

A: Given Holding force on plate F=50N

Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…

Q: A toy is dropped into a pool of water (g = 9.81, p = 10003). It is then submerged 3m. What is the…

Q: Al A tank fill by the liquid and partially immersed a very long vertical tube in it. The tube has…

A: given data;radius of tube=Rsteady state velocity(V)=?pressure profile =?rotating at ω radian per…

Q: The U-tube in Fig. is open at A and closed at D. Ifaccelerated to the right at uniform a x , what…

A: The pressure at C is atmospheric pressure when the water level in the right limb falls up to point…

Q: 2.75 An open tank contains water to a depth of 1.5 m. The tank is put in an elevator which…

A: Given :- Depth = 1.5 m Acceleration = 2.5 m /s2 To Find:- Pressure Force per metre length 1.…

Q: best fits between the options of the graph A, B, C, D and F,

A: Given:- Static head= 85 Capacity= 195 To Find:- Best impeller & Expected Power consumption

Q: The minimum pressure on an object moving horizontally in water (Ttemperatu at10 degree centrigrade)…

Q: The horizontal nozzle in the given figure has D₁ = 12 in and D2 = 6 in, with inlet pressure p₁ = 38…

Q: e atmospheric temperature is -32 degree Celsiu

A: given: velocity of jet=1250km/h

Q: A racing car is moving at a speed of 70 m/s on a racetrack with an altitude above sea level of 5000…

A: Given data: Velocity of car = v = 70 m/s Altitude above sea level = 5000 ft = 1524 m We have to find…

Q: : A liquid of (u = 1.25 Pa.s.) fills the space of (Sum) shown in figure below. Calculate the forque…

Q: A vertical gap of 0.1 mm contains a fluid of viscosity (2 Pa.s). A thin metallic plate sheet (0.2 m…

A: This question is based on the concept Newton's law of viscosity.

Q: Consider the following figure showing a jet of water supporting a weight of 100 N at aheight of 5 m…

A: A force is an influence that can alter an object's motion. A force can cause an object with mass to…

Q: Consider a following figure showing a jet of water supporting a weight of 100 N at a heigh of 5m.…

A: Given Weight = 100N Height = 5 m Exit velocity = 20 m/s To find Diameter of the nozzle A jet of…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A flat-bottomed raft is traveling across a shallow lake at 6 ms-¹. The lake is 10 cm deep. If the raft has a surface area of 3 m² and the lake is full of water with viscosity of 0.001 Pa s, determine the force required to maintain the raft's speed. [0.18 N]
Fluid mechanics
i am a little lost on how you are changing units velocity is 2 m/s. you change it to kg/s and then m^3/s i am not seeing the relationship
I need answers in less than an hour T.T. Thank you!
1. A pressure gauge attached to a pipe is reading 1.34 m of Hg at a place where the atmospheric pressure is 10.33 m of water. The approximate absolute pressure at the mountain isa. 930 kPab. 181 kPac. 280 kPad. 100 kPa 2. The flow is said to be unsteady and non-uniform when,a. The flow velocity is not changing with time but changing with spaceb. The flow velocity is changing with both time and spacec. The flow velocity is changing with time but not changing with spaced. The flow velocity is not changing with both time and space 3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe).a. Cannot be find since length is not givenb. Cannot be find since diameter is not givenc. 7.85 mm/sd. 12.73 mm/s 4. 1 kg water is flowing through an inclined pipe at…
The power provided by a centrifugal pumo is given by P=mgh where P = power/watts m = mass flow rate, kg/s g= gravitational acceleration, m/s² h = pump head,m prove that this equation is dimensionally homogeneous
in the figure is lowered from a ship to a floor. The on the осеan construction site plastic panel weighs ( 200N) in air and is Cuble ship lowered at a rate of ( 2 m/s ). Assuming the panel remains vertically oriented, calculate ng the tension force in the cable. Take ( p = 1000 10* m/s ),e and use; water T Plustic Punel kg/m', v 1.31 1/5 1/2 CDlam = 1.328 / Rej" Cpturb = 0.072 / Rej. .
Consider two tanks filled with water. The first tank is 8 m high and is stationary, while the second tank is 2 m high and is moving upward with an acceleration of 5 m/s^2. Calculate the pressure of each tank at the bottom.
Need help with this engineering problem.
If a hole is drilled at the bottom of a full bucket of water of height. H 60 meter what is the second velocity and first if we have pressure 1 in the air is 103 kpa and pressure 2 760pa (proof the equation you used to solve it ) Kindly re-draw the diagram.
i need the answer quickly
An anemometer is 20 m from the ground surface in an area with a friction coefficient of 0.45. It measures the wind speed at altitude as 8 m/s. 80 m in the same area. Estimate the wind speed at altitude and the specific power (specific power) for the area. What is the rate of change ?