analysis: Determine the percentage of silt and clay based on USCS. Round off your answer to two (2) decimal places.  Size (mm)       Mass of soil retained                               on each

Q: L 40 PL 30 Determine its classification using USCS.

A: soil is classified as MI

Q: A fully saturated soil sample has a volume of 28 cc. The sample was dried in oven and the weight of…

A:

Q: For the sieve analysis test, the following data is obtained. Draw the grain size distribution curve…

A: Plot the grain size distribution curve.

Q: 2- The following are the results of a sieve analysis: U.S. sieve no. Mass of soil retained (g) 4 10…

A: Given,

Q: You are given the following results from Atterberg Limits testing on a soil sample (PL= 30%, LL =…

A:

Q: The following data are the results of a sieve analysis. Determine the percentage of silt and clay…

A:

Q: QUESTION ONE A particle size distribution curve is given in the figure below Classify the soil using…

A:

Q: Home work :1- Following are the results of a sieve analysis: Mass of soil retained on each sieve…

A: Sieve   Mass  % mass Cumulative % Cumulative % No Sieve size Retained Retained Retained Passing…

Q: The following are the results of a sieve and hydrometer analysis Analysis Sieve Number Grain size…

A: Given- Result of a sieve and hydrometer analysis. To find -  (A) Draw the grain size distribution…

Q: A cylinder has 500 cm3 of water. After a mass of 100 grams 1) A) of sand is poured into the cylinder…

A: NOTE : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: 1. The following are the results of a sieve analysis: U.S Sieve No. Mass of soil retained (g) 4 10…

A:

Q: Determine the percentage of Clays based on AASHTO Soil classification system for the grain-size…

A: First draw grain size distribution curve in semi log graph between sieve size on x axis and % finer…

Q: Please answer this problem using the AASHTO system. NOT the MIT system. Thank you! The particle…

A: The given data is shown below:

Q: The grain-size characteristics of soil re given in the following table. Use Table 2.3 for the…

A: OPTION - A is correct

Q: The results from a compaction test are as follows: 130.0 128.0 126.0 124.0 122.0 120.0 118.0 116.0…

A: given compaction test result curve, X axis is water content and Y axis is dry unit weight.Water…

Q: 3. The sieve analysis data for a granular soil are given below. %passing 19mm sieve = 100 %passing…

A: Step 1

Q: Unified Soil Classification System Problem Set No. 6 Sieve No. Diameter Percent Finer (mm) 2. The…

A:

Q: 7. The following table shows a data set from a sieve analysis. (a) Plot the grain size distribution…

A: From graph we get,

Q: Q/ For the given sieve analysis test of a soil sample, find the following: 1. The percentage of soil…

A: For the given percentage passing and grain size distribution curve is shown below: 1. Percentage…

Q: Q3- A sieve analysis on soil sample showed the following results; Size, mm T2 4.75 2.00 0.84 0.42…

A: Solution Given Data Size, mm 12 4.75 2.00 0.84 0.42 0.25 0.15 0.075 0.001 % finer 100 63 57 49…

Q: Question 1 A sieve analysis of a soil sample gives the following results. particle size/mm mass of…

A: The given data is shown below: The total mass of the soil sample is 500g.

Q: Q5: For the particle size distribution curve in the figure below, determine the following: 1- The…

A: From the graph  We can observe that  For SOIL A:  Gravel - 0%  Sand - 100%  Silt - 0% , clay - 0%…

Q: 10. Sieve analysis and hydrometer analysis were performed on a soil sample. The table below…

A:

Q: Determine the percentage of Silts and Clays based on USCS for the grain-size characteristics of a…

A: First need to draw grain size distribution curve in semi log graph between sieve size on x axis and…

Q: Sieve Size Sieve opening (mm) Percent Finer 3 in. 76.2 100% 2 in. 50.8 90% 1 in. 25.4 80% #4 4.75…

A: Given the sieve sizes and percentage finer soil in those sieves.

Q: Question 1 The given data shows a sieve analysis of a soil sample. Classify the soil using AASHTO…

A:

Q: Question 1 A sieve analysis of a soil sample gives the following results. particle size/mm mass of…

A: The given data is shown below: The total mass of the soil sample is 500 g.

Q: The particle size characteristics of a soil are given in the table. Using USDA method, determine:…

A:

Q: Two soil samples A and B were found to have the physical properties shown in Table 1. Check the…

A: Given :

Q: 737 grams of dry sand completely fills a 500 cm³ permeameter tube. The specific gravity of the sand…

A:

Q: 3. You are an earthwork construction control inspector checking the field compaction of a layer of…

A: Given: Volume of Soil Excavated = 1170 cc Weight of Dry Soil excavated = 1849 gms Weight of Wet Soil…

Q: 8. a) According to the results of a sieve analysis in Table 1 below, plot the sieve analysis graph…

A: A) Sieve Size (mm) Mass Retained (gms) % Weight Retained CCumulative % Retained % Finer =(100-%…

Q: The table below shows the lab result of the sieve analysis of a soil sample Diameter (mm) Percent…

A:

Q: The table below shows the results from the specific gravity (S.G.) test performed in a soil…

A: Coefficient of Quartile Variation: It is defined as the absolute measure of dispersion. In other…

Q: Q/ For the given sieve analysis test of a soil sample, find the following: 1. The percentage of soil…

A: (1)

Q: The resuts of a sieve analysis for a soil sample are given in the table. (a) Plot (to scale) the…

A: Tabulate the following.

Q: A soil sample has a bulk unit weight of 17.5 kN/m^3 at a water content of 10.1%. Use Gs=2.58…

A:

Q: PROBLEM 8: The particle size distribution curve of a particular soil sample has the following…

A: According to bartleby rules,only first question is solved

Q: and graphs. Given the sieve analysis data below, complete the table ar a) Plot the grain-size…

A:

Q: The results of a sieve analysis are reported in table 1. The total weight of the sample was 500 g.…

A: Due to lack of graph I am using interpolation method…

Q: 8. The results of a standard compaction test on a soil sample from Glasgow are shown in the graph…

A:

Q: A soil sample was taken from a pit and its total unit weight was equal to KN (17.17) and its water…

A:

Q: Calculate the CEC of a 100g soil sample that was found to contain the following cations:…

A: From the CEC is the sum of the equivalent weight of the Ca2+,Mg2+,H+, K+,  Al3+, NH4+ We have to…

Q: What is the 95% maximum dry density from the laboratory (Please answer in two decimal places in…

A:

Q: The particle size characteristics of a soil are given in the table. Using USDA method, determine:…

A: Given,  Sieve analysis data

Q: For a soil sample, the following set of experimental data has been obtained: Liquid Limit (LL) = 34…

A: Given:Liquid Limit (LL)=34Plastic limit (PL)=6Now,Plasticity Index PI=LL-PLPI=34-6PI=28

Q: 05: The Figure below represents the data that was obtained from a liquid-limit test on a soil. 50…

A: Given DataWP=liquid limit=20.3WL=plastic Limit=20.8part 1Liquid limit is the lowest water contentso…

Q: The following data are the results of a sieve analysis. Determine the percentage of silt and clay…

A:

Q: The following are the results of a sieve and hydrometer analysis: Sieve number/ Percent Analysis…

A: (a) Draw the calculation table as shown below. Sieve no/grain size Diameter mm Cumulative fine…

Soil engineering for highway design

Soil engineering is a part of geotechnical engineering that deals with the characteristics of soil. It also helps to understand the behavior of the soil in different conditions. The basic concepts of soil are studied to check the strength, compressibility, and porosity of the soil. This makes soil engineering an important topic for civil engineering.