Answered: An inductive circuit has a resistance…

Engineering

Electrical Engineering

An inductive circuit has a resistance of 10 ohms and an inductance of 2 henrys. The total impedance at 60 HZ is?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: there are 240 square meters of floor area in a house that contains an electric range rated as 12 kW ...

A: total floor area =240 square meter electric range =12 kW electric dryer =5000 W

Q: 014: Fill in the blanks with suitable answers: 1. One of the advantages of an interconnected power s...

A: 1). One of the main advantage of interconnected power system is power shared incase of exceeding the...

Q: A 240kW, 500V 1750 r/min separately excited dc generator has an overall efficiency of 94%. The shunt...

A: It is given that: Output Power=Pout=240 KW=240×103 WVoltage=V=500 VEfficiency=η=94 %=0.94Shunt field...

Q: A sinusoidal voltage with maximum value (336 V), and a Frequency its value (50 Hz), was applied on a...

Q: 1. Design a voltage regulator that will maintain an output voltage of 20 V across a 1-k load with an...

Q: ell 57 22 Vilt) Vo ct)

Q: What the combined circuit resistance R,?

Q: In a Varactor diode, the junction capacitance varies with the reverse bias. Select one: O True O Fal...

Q: 8. At what speed (r/min) will an eight-pole, 50 Hz, 240 V ac motor run?

Q: If we want to make a coil consisting of an aluminum wire of length (100 m), so that it carries a cur...

A: The solution is given below

Q: here are 240 square meters of floor area in a house that contains an electric range rated as 12 kW a...

A: total floor area =240 square meter electric range =12 kW electric dryer =5000 W

Q: Three heater units each taking 1, 500 watts are connected delta to a 120 Volt three phase line. What...

A: Answer -

Q: 1. Construct the half-wave rectifier circuit as shown. 2. 3. Monitor the input voltage using the osc...

A: The rectifier is used to convert the alternating current into a direct current. The half-wave rectif...

Q: キn:Iエ, 2はる,, 2V3 PX,S C4 10 nF In' 1oov 12 ell V2 L1 R1 47 Q V3 3.3 mH

A: The solution is given below

Q: The organization of a memory chip is 4KX8. How many bits wide is each memory location? 4 8 4K 32K

Q: 1- Consider the circuit shown in Fig. 1. Given that R,=1.5kQ, R,=1.2kQ, R,=1kQ and R1=1.8k2, find th...

Q: 9.3. In the circuit of Fig. 9.39, we have cho- sen Rc = 1 k2 and Vcc = 2.5 V. Estimate the maximum a...

Q: Explain each of the following topics:

A: The taditional tv and HDTV are in satilite communication it links various parts in the earth

Q: Neglecting saturation, if the current taken by a series motor is increased from 10 A to 12 A, the pe...

A: Given: A DC series motor having, Initial current, I1=10 A Final current, I2=12 A Neglecting saturati...

Q: total resistance of the circuit, total Current and total Power of the circuit; b) the current passi...

Q: 3.A series circuit consisting of a 18 ohms resistor, a 82 uF capacitor, and a variable inductor is c...

A: The solution is given below

Q: If we want to make a coil consisting of an aluminum wire of length (100 m), so that it carries a cur...

A: Given: A coil consisting of aluminum wire having, Length, L = 100 m Carries a current, I = 5 A Pote...

Q: . Calculate the load voltage, load current, and diode power in figure below using the second approxi...

Q: 23:- lUsing the Current divider rule, find unlenown Curents- m net shoun I7 loA -> 0.1k

A: Circuit diagram is given as,

Q: QUESTION 4 A real transformer has 1500 turns on the primary and 2000 turns on the secondary. Rp = 20...

Q: 2. The star-connected rotor of an induction motor has a standstill impedance of (0.4+ j4) ohm per ph...

Q: 1) Find transfer function Vo(s) / Vi(s) Vo t)

Q: Determine the Q-point, and find the maximum peak value of base current for linear operation. Assume ...

Q: For a BJT transistor if VCC-8V, VCE= 8V, the transistor will operate in ------ region O cutoff activ...

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used nowaday...

Q: Two capacitors in series are charged across a 24V source. If C1 is 12 picofarads, and the voltage ac...

A: The solution is given below

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage...

A: Source is star connected. V =Vab =380 V Note: frequency is not given, we assume f= 50 HZ

Q: Using Kirchoff's voltage law to determine the unknown voltage V3 for the configuration given in the ...

Q: 1.2. A NPN transistor with a saturation current Is = 10-12 A is operated at room temperature (25°C)....

Q: This.

Q: The rotor resistance and standstill reactance of a 3-phase induction motor are respectively 0.015 oh...

Q: 1) Find out the impulse, step, and parabolic response of the 1 order control system of transfer func...

A: Answer -

Q: 4. Bundling of conductors in a transmission line reduces the risk for corona. Also, it: a. Reduces t...

A: The solution is given below

Q: For the continuous-time periodic signal ã(t) below, determine the fundamental period To and fundamen...

A: It is given that:

Q: Vo1 of the following circuit is equal to Ge Si 12 k2 Voz Vo -10 Vo K 3.3 k2 9V 10V 9V

A: given circuit.we have to calculate Vo1

Q: Q1)Design moving coil ammeter as a voltmeter to read 15 V (RMS) alternating voltage. If the internal...

A: As per guidelines given to us, we can provide the solution of one question in multiple type of quest...

Q: QUESTION 6 Give the highest memory address contained in IC 2 in the system below. Give your answer i...

A: The solution is given below

Q: receiver has a sensitivity of 0.3 μV, and the same receiver can handle a signal level of 75 mV witho...

Q: QUESTION 4 What is the highest system address stored in IC 1? As- A7. Ao IC 1 IC 2 CS CS O H OFF H 1...

A: The solution is given below

Q: d. For the emitter bias network shown below, calculate Zi, Zo, and Ay. 12 V Re 220 k2 10 uF B = 100,...

A: The solution is given below

Q: or the circuit given below, assume VCC=15 VBB=6.82V, RB = 1.2 KN, RC = 1 KN, B=50, find the value of...

Q: A transformer has a turns ratio of 2:1. What is the peak secondary voltage if 120 Vrms is applied to...

A: Brief description: Here they have given the turns ratio of the transformer as 2 : 1. Turns ratio is ...

Q: Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage Va...

A: To solve D, E, F, & G

Q: 2Vx jia -jia2 I2 I4 12 220°A 1220° v 10 V 220°A Ii

Q: 4) For the Darlington circuit below, a) determine the dc levels of VB1, VCi, VEI, VCBI, and VCE2. b)...

A: Answer -

Q: 12 V what value of Rc will cut the voltage gain to half the value obtained from the original values ...

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

An inductive circuit has a resistance of 10 ohms and an inductance of 2 henrys. The total impedance at 60 HZ is?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
What is the minimum AC voltage rating of each capacitor in Question 11?
By convention, the sign of reactive power to an inductance is and the sign of reactive power to a capacitance is
A 206.0-2 resistor and a 2.80-µF capacitor are connected in series across the terminals of a sinusoidal emf with a frequency of 150 Hz. The inductance of the circuit is negligible. What is the impedance of the circuit?
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
QUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found. QUESTION 10 E-06, PC-05. An inductor is said to be saturated when? The current through it is zero. The current is at a maximum. It will no longer accept lines of flux.
The attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics: Resistor resistance: 10 ohm Capacitor capacitance: 0.05 F Inductor inductance: 13 H Current Amplitude: 4 A Voltage amplitude across the source: 60 V Frequency at the source: 0.3 Hz Voltage amplitude across the resistor: 35 V Voltage amplitude across the capacitor: 37 V Voltage amplitude across the inductor: 80 V (a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source. Hint: Vrms = V0/sqrt(2) Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 ) (b) Calculate the RMS value of the current (c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
Value of series impedance if inductance is 5mH , resistance is 4 ohm and frequency is 50 Hz.