An impedance coil is connected in parallel with a capacitance C of 12.5 μF. The input voltage to the circuit is 100 V at 31.8 Hz. The phase angle between the two branch currents (I1 and I2) is 120° and the current in the first branch is I1 = 0.5A. Determine the following: a) the power factor b) the value of conductance (G in mƱ) and susceptance (B in Ʊ) c) total admittance

Q: Describe analysis of line fault at a point of power system using symmetrical components and sequence...

A: Line Fault- It is described as a transmission line fault which occurs due to any physical condition.

Q: Using Kirchhoffs voltage law, find the unknown voltage V1 and current I for the network shown in the...

A:

Q: need a different answer from an expert

A:

Q: Design a three-section binomial transformer to

A:

Q: Question 4-) The linear electron-concentration profile shown in the figure below has been establishe...

A: The given electron concentration profile is shown below: It is given that: no=1017 /cm3W=4 μm=4×10-...

Q: V resistor Q5: Qualitatively describe how a plot of V generator vs. log(frequency) would look for a ...

A:

Q: Determine the operating point of the 2N3055 transistor if the collector current is 10 amps and the c...

A: To find the DC current gain and base current of any Real existing transistor, We need to look into T...

Q: Find the current i4 10A 100 200 300 2A 600

A: In this question,  We need to determine the current in the 60ohm resistance.  We are solving this pr...

Q: 5. An ideal 300W transformer has an input current of 9 A and an output voltage of 230 V. Determine V...

A: Brief description: Transformer is an electrical device which is used to step up and step down the vo...

Q: Question No. 4: For the below circuit, assume that: V:(t) = 20 cos(wt+30°) V2(t) = 10 sin(wt+60°) V3...

A: In this question,  We need to write the polar representation.  Polar form is representation by rms v...

Q: 3nu(-n) 0.1nu(-n) + 2nu(-n) Determine if stable system or not using infinite geometric series formul...

A: If the GM series converge to a finite value then the system is stable otherwise Unstable.  

Q: A 4-pole, 240V, wave connected shunt motor running at 1000 rpm and drawing armature and field curren...

A: SOLUTION- Given,  P =4  A = 2 (Wave connected)  N = 1000 rpm Z= 540 Ia = 50A If = 1 A    Eb= 240-50...

Q: The following information is given in connection with a parallel connected  impedances: Za = (13 – j...

A: The solution is given below 

Q: IK DC RO3 (Y+5) K RI 3 Sk (X+10) mA DI 12 V Vs Ge

A: The given circuit diagram is shown below: It is given that: X=7Y=0

Q: Сараcitor Inductor Resistor dvc = C dt dir v, = L dt VR = iRR 1/5F

A: The solution is given below

Q: Find the minterms of the following Boolean expressions by first plotting each function in a map: (d)...

A:

Q: Q3:- The overshot of the step response of a second order feedback system is 30% and settling time is...

A:

Q: Given the following system, if m(t) has a bandwidth of 200ktz, what should be the value of fe for th...

A:

Q: Assume you are an engineer in charge of a project and one of your subordinate engineers reports that...

A: Given that , circuit contains voltage source with current direction flowing through it. We have to f...

Q: Which figure represents the Boolean expression, where O is the symbol for "exclusive OR" WΘΧΘΥΘΖ (A)...

A: Exclusive OR  A logical operator that results in zero when then the bits are the same. The result is...

Q: Problem 2 For the circuit shown, use Nodal Analysis to determine the values of the voltages Va, Vb a...

A:

Q: A 55 MW thermal plant of NGCP delivers an annual output of 356 GWh with a peak load of 39 MW. What i...

A:

Q: VCE B=80 16 V 3.9 kN Ice 62 kn oVC +. B = 80

A:

Q: 1. Determine v(t) and i(t) in fig Ex 1. Use phasor and then time domain form. 2. A current source in...

A: In  this question,  RL circuit is given Find the current and voltage as shown in the circuit using t...

Q: 2. A singer voice is sampled for 4 second by an 8-bit ADC at a sampling frequency of 10 kHz. The sam...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Find the charge on the capacitor in an RLC series circuit where L = 2 H, R = 24Ω, C = 0.005 F, and E...

A: GIVEN:               L=2HR=24ΩC=0.005FE(t)=12sin 10t V FIND: Charge on the capacitor in RLC series c...

Q: 4. Vo and In Si Ge IR +12 V - 5.6KQ

A: The solution is given below 

Q: Find and plot y(t) = x(t) * h(t) h()

A: In this question,  We need to determine the output y(t) if x(t) and h(t) is given.  We are solving t...

Q: 2. Vo, and Ip 12V A Si Y Si 2.2KQ Vo

A:

Q: C.T. and P.T. are used for _________ Group of answer choices measuring high currents and voltages ...

A:

Q: Capacitor dvc ic = C- Inductor dil VL = L Resistor VR = İRR %3D dt dt 115F 3SH

A:

Q: I4 RA R2 R3 I3 o Vout in V_ R1 V+

A: Given circuit shown  R1=7 kΩ ,R2=12 kΩ,R3=6 kΩ, R4=10 kΩ

Q: How many lines are there in an NTSC signal? a) 1024 b) 1856 c) 625 d) 525

A: The NTSC stands for National Television system Committee and the NTSC Signal is used in television s...

Q: 2. (a) Derive the common-mude rojection ratio (-ADACH OM) of the stages in Fig. 4. For simplicity, n...

A: Given: Consider the circuit below: To find: Derive the common-mode rejection ratio (=ADM/ACM-DM) of...

Q: The maximum value of the sinusoidal voltage wave generated in one coil of an alternator is 25 volts....

A: Maximum value of alternator is, Vm=25 V Writing the voltage expression at any time t. Vt=Vmsinωt Vt=...

Q: Load 1 Load 2 24 kW 40 kW pf = 0.8 lagging pf = 0.95 lagging A 240-Vrms, 60 Hz source supplies two l...

A:

Q: 150kN, V1 = 3v, V2 = 6v, V3 = 9v, Rı = 500KN, R2 = 1MN, and R3 = 800kN. 4. Calculate the output volt...

A:

Q: An electric skillet draws 5000 mA at 220 V. Assuming that everything is constant and the voltage dro...

A:

Q: A PWM signal is sent to a permanent magnet DC motor through an H-bridge circuit. The PWM frequency i...

A: Given f=100 kHz V=16 V No load speed = 1500 rpm T= 2Nm   duty cycle = 20 % =0.2                    =...

Q: The United States has about 300 GW of coal-fired power plants that in total emit about 2 Gt of CO,/y...

A:

Q: S. Use k-map method to derive the simplified POS expression for the given: F= (X+Z')(Z+WY)'+ (VZ+WX'...

A: Firstly lets expand the expansion as shown below

Q: Example: If the analog signal to be quantized is a sinusoidal waveform, that is x(t) = Asin(2 x 103t...

A: Brief description : In pulse code modulation depending upon the message signal the formula of signal...

Q: 8. A light bulb, having a tungsten-filament, draws 2.85 A at 220 V when running at normal condition....

A: Resistance at any temperature =( resistance at 17 degrees )×(1+(temperature coefficient of resistanc...

Q: 6. A circular coil has a mean diameter of 100 cm having an electron density of 3.34 x 1024 e/m³ with...

A: The solution is given below

Q: R. R1 RL RA R2 V s -ww ww

A:

Q: B1 A single-phase, 50 Hz transformer has 30 primary turns and 420 secondary turns. The cross- sectio...

A:

Q: Electrical Engineering The response of a standard second order under damped system to a unit-step in...

A:

Q: Question 1 A 132/33 kV 250 MVA single-phase step-down transformer has the following parameters: R1 =...

A:

Q: How many lines are there in an NTSC signal?

A: In this case, out of the given options, the correct option corresponding to the number of lines pres...

Q: Assume a signal is represented by the following expression,    Calculate:   a)The signal bandwid...

A:

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.