An equalization basin is used to balance pH and alkalinity in wastewater, just before the biological treatment step. The rate at which the wastewater flows into the basin is 0.3[1 + cos nt/(15255936) ft°/s] while the rate at which the neutralized wastewater leaves the basin is 0.3 m/s. The basin's floor area is 1000 m?. Map the hourly changes in the water depth, assuming h = ho = 5m at t = 0. Also assume that the depth of the water at t = 0, is half the sidewall depth of the tank.

An equalization basin is used to balance pH and alkalinity in wastewater, just before the biological treatment step. The rate at which the wastewater flows into the basin is 0.3[1 + cos nt/(15255936) ft°/s] while the rate at which the neutralized wastewater leaves the basin is 0.3 m/s. The basin's floor area is 1000 m?. Map the hourly changes in the water depth, assuming h = ho = 5m at t = 0. Also assume that the depth of the water at t = 0, is half the sidewall depth of the tank.

General, Organic, and Biological Chemistry

7th Edition

ISBN:9781285853918

Author:H. Stephen Stoker

Publisher:H. Stephen Stoker

Chapter8: Solutions

Section: Chapter Questions

Problem 8.6EP: For each of the following pairs of solutions, select the solution for which solute solubility is...

See similar textbooks

Similar questions

For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Oxygen gas in water with P = 1 atm and T = 10C Oxygen gas in water with P = 1 atm and T = 20C b. Nitrogen gas in water with P = 2 atm and T = 50C Nitrogen gas in water with P = 1 atm and T = 70C c. Table salt in water with P = 1 atm and T = 40C Table salt in water with P = 1 atm and T = 70C d. Table sugar in water with P = 3 atm and T = 30C Table sugar in water with P = 1 atm and T = 80C
A sample (50 mL) of a bottled water was added to a 100 mL volumetric flask and then diluted to the mark. From this stock solution, 50 mL was taken, added to a 100 mL volumetric flask and diluted to the mark. Final concentration of the serial dilution: 587.7161ppm. 1. what is the concentration in the original bottle (ppm)
A solution of HCl was titrated against sodium carbonate. What is the average normality of acid in the given data? (MW Na₂CO3 = 106) T2 0.3479 0.3562 0.3042 Weight (g) Initial V (ml) 0.80 1.60 35.20 36.70 39.80 Final V (mL) Vol HCl used (mL) 35.10 39.40 N of HCl (eq/L) 0.1954 0.1870 Average N of HCl (eq/L)
Lead hydroxide, Pb(0H)2(s) | Pb(0H)2(s)Pb+2(aq)+20H-(aq) | Ksp=1.4x10-20 H2O(aq)H*(aq)+OH-(aq) Pb(OH)2 Water Kw=1.00x10-14 Molar masses 241.21 Pb 207.20 OH- 17.01 If Pb+2(aq) is controlled by the solubility of Pb(OH)2, what Pb+2(aq) concentration is expected if pH=p0H=7.00? b. What pH would be required to lower Pb+2(aq) to 2.07 ppb? a.
Will a ppt of MGF2 (s) form if 95 mL of .90 M Mg2+ (aq) with 35 mL you mix of 1.1 x 10-5 MF (aq). (Which of the following is entirely correct?) O Q = 5.8 x 10-12, no ppt Q = 4.0 x 1013, no ppt O Q = 9.9 x 10-6, ppt forms Q = 1.1 x 1010, ppt forms Q = 1.9 x 106, ppt forms
Solution X 100 mL of 0.10 M NaOH(aq) is mixed with 100 mL of 0.10 M HBr(aq) Solution Y 100 mL of 0.10 M NaBr(aq) is mixed with 100 mL of 0.10 M HBr(aq) Solution Z 100 mL of 0.10 M HC,H,O,(aq) is mixed with 100 mL of 0.10 M NaC,H3O,(aq) 6. A student prepares three solutions, X, Y, and Z, as described in the table above. The values of Ka for the acidic species in the solutions are given in the table below. Species Ka HBr(aq) >>I (very large) HC,H;O,(aq) 1.8 x 10-5 a. Using the information above, write the letters of the solutions in the boxes below to rank the solutions in order of increasing pH. Explain your reasoning for the ranking Lowest pH Highest pH b. Does the pH of solution Y increase, decrease, or remain the same when 100 mL of water is added? Justify your answer. c. The student adds 0.0010 mol of NaOH(s) to solution Y, and adds 0.0010 mol of NaOH(s) to solution Z. Assume that the volume of each solution does not change when the NaOH(s) is added. The pH of solution Y changes…
A dilution of benzene in methanol is made by placing 1.5 mL benzene (density of benzene is 0.879 g/mL and its mol. Wt. is 78.1) in a 100-mL volumetric flask and brining to volume with methanol. What is the concentration of benzene in the solution in mg/L In ppml