An electromagnet is modeled as L=0.3H and R=200 in series, and connected to a 120V(rms) sinusoidal voltage, and 60Hz at t=0 when the phase angle is 10°, v(t) = 120v2 cos(120nt + 10°). a. The transient component of the complete response of the current will have practically died out after b. Suppose that the form of the complete response is i(t) = 2 cos(120nt – 60°) – Bqe¯70ty for a different electromagnet and voltage source. If the electromagnet is initially uncharged, the value of B1 is

An electromagnet is modeled as L=0.3H and R=200 in series, and connected to a 120V(rms) sinusoidal voltage, and 60Hz at t=0 when the phase angle is 10°, v(t) = 120v2 cos(120nt + 10°). a. The transient component of the complete response of the current will have practically died out after b. Suppose that the form of the complete response is i(t) = 2 cos(120nt – 60°) – Bqe¯70ty for a different electromagnet and voltage source. If the electromagnet is initially uncharged, the value of B1 is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Similar questions

A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
The capacitive reactance (XC).... be affected by the harmonics of non- * .sinusoidal wave will all-of-them O could O cannot O
C 7. A capacitor, a coil, and two resistors of equal resistance are arranged in an AC circuit as shown in the figure. An AC source provides an emf of AVrms = 20.0 V at a frequency of 60.0 Hz. When the double-throw switch S is open as shown in the figure, the rms current is 183 mA. When the switch is closed in position a, R rms S- the rms current is 298 mA. When the switch is closed in position b, the rms current is 137 mA. Determine the values b L of R, C, and L. ell
(b) An AC generator produces a sinusoidal waveform, given by the expression: (t) = -25 sin(150nt – 30°) V. Eind the freau Daton (iv) (v) Determine the instantaneous voltage at t = 3.215 ms. Find the RMS value of v(t). (c) A current flowing through a 52 resistor has a periodic waveform as shown in Figure Q4(c). (i) Find the RMS value of the current waveform (ii) Find the average value of the current waveform (iii) Calculate the power absorbed by the 52 resistor IN
For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and the volt/cm switch is on 1 V/cm. a) the frequency will be Hz b) the r.m.s value will be In CRO the beam can also be shifted vertically by applving a suitable DC voltage to the
The single phase AC sinusoidal voltage then the rms value of the voltage v is .........
The inductive reactance (XL) .. .be ..... ..... affected by the harmonics of non- * .sinusoidal wave
1. Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage and circuit current in purely capacitive circuits?. 2. Vm = 100cos(377t + 75°) transform into sine form is a complex number that represents the amplitude and phase of a sinusoid. 3. 4. What is the phase relationship between a supply voltage and current through a purely inductive circuit?. 5. The rms value of the signal is also called the 6. The It is also the cosine of the angle of the load impedance. 7. When Q < 0, the power factor is 8. The process of increasing the power factor without altering the voltage or current to the original load is known as 9. is the cosine of the phase difference between voltage and current. is the measurement to measure average power. 10. What is the meaning of VAR?
Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage and circuit current in purely capacitive circuits? 2. Vm = 100cos(377t + 75°) transform into sine form is a complex number that represents the amplitude and phase of a sinusoid. 3. 4. What is the phase relationship between a supply voltage and current through a purely inductive circuit? . 5. The rms value of the signal is also called the
The frequency of a sinusoidal voltage with a maximum value of 250V is 55 Hz.a) Write the equation for this voltage.b) Calculate the value of the voltage at 0.008 seconds from the beginning, while the curve increases in the positive direction from the moment t = 0?
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
Find the capacitance if correct will upvote otherwise i will dislike...