An aquifer slope away from a river. The hydraulic conductivity of the aquifer which is 20 ft thick is known to be 0.1 ft/day. The water is 20 ft deep in the river, and the bottom of the trench is 30 ft below the bottom of the river and 600 ft away from the edge of the river. The trench is 40 ft deep. Will water flow out of the trench without pumping? If so, what will be the rate of flow?

An aquifer slope away from a river. The hydraulic conductivity of the aquifer which is 20 ft thick is known to be 0.1 ft/day. The water is 20 ft deep in the river, and the bottom of the trench is 30 ft below the bottom of the river and 600 ft away from the edge of the river. The trench is 40 ft deep. Will water flow out of the trench without pumping? If so, what will be the rate of flow?

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter16: Soil Improvement And Ground Modification

Section: Chapter Questions

Problem 16.10P

See similar textbooks

Similar questions

An aquifer slopes away from a river, as shown in Fig. 3-7 The hydraulic conductivity of the aquifer which is 20 ft thick is known to be 0.2 ft/day. The water is 20 ft deep in the river, and the bottom of the trench is 30 ft below the bottom of the river and 600 ft away from the edge of the river. The trench is 40 ft deep. Will water flow out of the trench without pumping? If so, what will be the rate of flow?
trench 80 ft long is excavated 500 ft away and is parallel to a riverbank. A sand aquifer is 40 ft thick The river water surface is 50 ft above the horizontal bottom of the aquifer. If the water depth in the trench must be maintained at 10ft, at what rate must water be pumped from the trench? How far from the trench will the aquifer cease to be saturated? Use K of sand = 30 ft/day
A pump well is dug through a confined aquifer having a thickness of 32 meters. The piezometric surface of the aquifer is 18 meters measured from the top impermeable layer. The first observation well is 75 feet directly west of the pump well and the second observation well is 75 feet directly north of the first observation well. Determine the hydraulic conductivity of the aquifer if it supplies a discharge of 10 liters per second and the drawdown of the observation wells are 13 feet and 23 feet.
In fig 3-5, the aquifer thickness is 10 ft, the hydraulic conductivity of the aquifer is 0.06 m/day, and the river water surface is 7m above the bottom of the aquifer. If it is necessary to maintain a water level in the trench not more than 10 m deep, at what rate must water be pumped out of a 100 m long trench? The distance between the edge of the trench and the river is 300 m. Assume all water comes from the river.
A well with a diameter of 18 in. penetrates an unconfined aquifer that is 100ft thick. Two observation well are located at 100 ft and 235 ft from the well, and the measured drawdownsare 22.2ft and 21ft, respectively. Flow is steady and the hydraulic conductivity is 1400 gpd/ft^2. What is the steady-state rate of discharge from the well?
A well with a 0.25-m diameter fully penetrates an unconfined aquifer that is 20 m thick. The well has a discharge of 0.015 m ・ s−1 and a drawdown of 8 m. If the flow is steady and the hydraulic conductivity is 1.5 × 10−4 m ・ s−1, what is the height of the piezometric surface above the confining layer at a site 80 inches from the well?
A well 30 cm diameter penetrates 30m below the static water table. After a long period of pumping at a rate of 0.022 m3/sec .The drawdowns in well 17.37m and 45.11m from the pumped were found to be 3.65m and 2.25m respectively. What is the transmissivity of the aquifer? What is the approximate drawdown in the pumped well?
Determine the hydraulic conductivity of a confined aquifer from which water is being pumped by a fully penetrating well. The aquifer is 100 ft thick ,and the well is being pumped at a rate of 1500 gal /min. Water surfaces in the two observation wells 700 ft and 70 ft from the pumped well are respectively 1 ft and 10 ft below their levels prior to the beginning of pumping
3. An unconfined aquifer has a hydraulic conductivity of 25 mm/sec. There are two observation wells 458 ft apart. Both wells penetrate the aquifer to the bottom. In one observation well water stands 28.8 ft above the bottom at a radius of 687 ft, and in the other it stands 22.5 ft above the bottom. What is the discharge per 100-foot-wide strip of the aquifer in square ft per day?
Don't copy from other solutions thank you. Three piezometers have been installed in the confined aquifer having a uniform thickness of 4.6 m. and hydraulic conductivity of 2 x 104 m/s. a) Compute the hydraulic grądient. b) Compute the transmissivity in m2/day. c) Compute the flow rate per unit width of the aquifer in liters/day.
Need help with C. 8. An aquifer has a hydraulic conductivity of 12 ft/d and an effective porosity of 17% and is under a hydraulic gradient of 0.0055. (A) Compute the specific discharge. (B) Compute the average linear velocity. (C) The water temperature is 14°C and the mean pore diameter is 0.33 mm. Is it permissible to use Darcy's law under these circumstances? What is the reason for your answer?
Hello Wondering if you could help me answer the following question? Thank you A fully penetrating pumping well extracts groundwater from a confined aquifer with a pumping rate of 750 m3/day. The hydraulic conductivity of the aquifer is 10 m/day and the saturated thickness is 50 m. The drawdown of the aquifer from this pumping well is insignificant at a distance of 1000 m from the pumping well. At what distance from the pumping well is the drawdown 10 cm? Assume the hydraulic gradient is negligible in the local area. Transmissivity T = 1746.76 gal/min/ft Hydraulic conductivity = 11.645 gal/min/ft2 Storativity = 0.809 The drawdown on Jenny’s Well by the end of August. =0.6902 ft. Observation well situated is 69.7 ft away from the pumping well (which is pumping at the rate of 305 gal/min). The aquifer is confined, and the depth has been measured from well logs and is 150 ft. The data for time (t) and drawdown (s) is given below: t (min) s (ft) 0.072 0.003 0.105 0.006…