An aqueous solution of nickel(II) nitrate, Ni(NO3)2, is made by dissolving 8.96 grams of nickel(II) nitrate in sufficient water in a 100. mL volumetric flask, and then adding enough water to fill the flask to the mark. What is the weight/volume percentage of nickel(II) nitrate in the solution?

Q: NaCl(s) + AgNO3(s) -H2O-> NaNO3(aq) + AgCl(s). Given the chemical reaction, Suppose you are using…

A: The objective of the question is to find out how many grams of AgNO3 must be added to the solution…

Q: In the lab, a student makes a solution of CaCl 2 by dissolving 9.0 grams of solid in 425 mL of…

A: We have given that  Mass of CaCl2 = 9 gram  Volume of solution = 425ml = 0.425L  We know that…

Q: Calculate the grams of precipitate formed if you react 29.2 g AgNO3 with 34.6 g of Na2S according to…

A: Silver nitrate reacts with sodium sulfide to form silver sulfide and sodium nitrate. The equation…

Q: A student determines the concentration chloride in an unknown sample by pipetting 10 mL of the…

A:

Q: total acidity in water samples can be determined by neutralization with standard sodium hydroxide…

A:

Q: A solution of HCI has been prepared at a concentration of approximately 0.4 M and must be…

A: HCl is acid and sodium carbonate is base. so acid base neutralization reaction occurs.

Q: A student weighs out a 1.75 g sample of NaCl, transfers it to a 250. mL volumetric flask, adds…

A:

Q: Calculate the volume in mL of the iron(III) bromide stock solution that the chemist should pour out.

A:

Q: To make a calibration curve, you would first make a stock solution. Determine the mass of copper(II)…

A: Since you have asked multiple question, we will solve the first question for you.If you want any…

Q: A. A student weighs out a 10.1 g sample of NaBr,transfer it to a 500.mL volumetric flask,adds…

A: The molarity of a solution is calculated using formula:   Molarity=No.of moles of soluteVolume of…

Q: One of the active ingredients in stain removers is sodium percarbonate (Na2CO3), and a typical stain…

A: Percentage w/v of Na2CO3 = 6.5 % Volume of solution = 150.0 mL % w/v is given by: %w/v=mass of…

Q: To neutralize the acetic acid contained in 10 mL of commercial vinegar, 18 mL of a sodium hydroxide…

A:

Q: What mass of Fe(OH)3 (MW = 106.87 g/mol) will be obtained when 100. mL of 0.240 M FeCl3 (MW = 162.2…

A:

Q: 0.3354 g of  ethambutol hydrochloride tablet powder was weighed Volume e of acetous perchloric acid…

A: Step 1:

Q: tep A4 (Calculation steps in your lab notebook) Create a table in your lab notebook to calculate…

A: For laboratory experiments, we usually prepare a large bulk volume of different reagents. These are…

Q: Calculate the volume (in mL) of 0.100 M NagCOs needed to produce 1.00 g of CaCOg(s)

A:

Q: .To find the concentration of an acid solution, pure sodium carbonate can be used as a standard. In…

A: Given: Mass of sodium carbonate i.e. Na2CO3 used = 2.15 g. And the volume of HCl solution used =…

Q: Calculate the concentrations of hydroxide and hydronium ions in a solution prepared by dissolving…

A:

Q: A student titrates an unknown amount of potassium hydrogen phthalate (KHC8H4O4, often abbreviated…

A: An acid reacts with base to form salt and water. This reaction is known as neutralization reaction.

Q: The solubility of magnesium hydroxide, Mg(OH)2, in water is 9.0 x 10 4 g/100 mL. What volume of…

A: The equation for the above process is written as: Mg(OH)2+HNO3---------->Mg(NO3)2+H2O. Now,…

Q: 80°C is 20.8 grams, and the maximum amount of potassium nitrate that can be dissolved in 10 mL of…

A: Amount of KNO3 dissolved in 10 ml of water at 60oC = 11.0 g Amount of KNO3 dissolved in 1 ml of…

Q: 4. What volume of 0.1000 mol/L. NaOH(aq) is needed to react completely with 20 mL of 0.1805 mol/L…

A:

Q: 1. What is the concentration, in parts per million, of a solution in which 600 grams of aluminum…

A: Since you have asked multiple question, we will solve the first question for you as per our…

Q: When aqueous solutions of Pb(NO3)2 and NaCl are mixed, PbCl2 precipitates. The balanced net ionic…

A:

Q: A 0.639 g sample of cobalt, Co, is added to 236 mL of 0.100 M H₂SO, and reacts according to Co (s) +…

A: To determine the limiting reagent in any reaction, one should calculate the number of moles of each…

Q: If 16.45 mL of ammonium thiocyanate solution is required to react completely with 25.00 mL of 0.1546…

A: Answer: These questions are based on the stoichiometric calculation where we have to calculate the…

Q: 4.00 mL of H2O, 3.25 mL of an aqueous 0.030 M SCN- solution, and 11.00 mL of an aqueous 0.020 M Fe3+…

A: Here, Molarity of SCN-=0.030 MVolume of SCN-=3.25 mL×1L1000mL=0.00325 LMolarity of Fe3+=0.020…

Q: A chemist prepares a solution of mercury(II) iodide (HgI,) by measuring out 0.0056 µmol of…

A:

Q: The normality of an aqueous solution of hydrochloric acid is determined by titration with a…

A: One mole of barium hydroxide reacts with two mole of hydrochloric acid to form one mole of barium…

Q: The solubility of an unknown substance was tested three times during an experiment. Based on the…

A: Solubility The amount of solute present in 100 g of solvent is known as solubility. The solubility…

Q: A stock solution of potassium permanganate (KMnO4) was prepared by dissolving 20.8 g  KMnO4 with DI…

A:

Q: Given the acid base reaction between hydroxide and acetic acid OH(-) + CH3COOH → H2O + CH3COO(-) We…

A:

Q: 25. Use the reaction: 2AgNO3(aq) + H2SO4(aq) → Ag2SO4(s) + 2H2O(1) 2 HNO3(aq) What volume of 0.123 M…

A: The objective of the question is to calculate the volume of AgNO3 solution needed to form a certain…

Q: Consider the following precipitation reaction: 2 AgNO3(aq)+ MgCl2(aq) = 2AgCl(s)+ Mg(NO3)2(aq) How…

A: The given reaction is: 2AgNO3aq+MgCl2aq⇌2AgCls+MgNO32aq According to the above chemical reaction, 2…

Q: Verify your calculation Did you report your data to the correct number of significant figures?…

A:

Q: A student dissolved 4.00 g of Co(NO3)2 in enough water to make 100. mL of stock solution. He took…

A: Given, 4.00g of Co(NO3)2 is dissolved in 100mL of water. The initial moles of Co(NO3)2 in the…

Q: What is the concentration of sodium chloride in the final solution if 18.50 mL of 0.125 M BaCl2…

A: From the moles of sodium chloride we can calculate the concentration of sodium chloride.

Q: 5.00 ml of 7.35 M Fe(NO3)3 is combined with 1.00 mL of 0.50 M HCIO4 and 4.00 ml of 2.00 × 10-2 M…

A: Given: Vol of  Fe(NO3)3 = 5.00 mL Concentration [Fe(NO3)3 ] = 7.35 M Vol of HClO4 = 1.00 mL…

Q: A chemist performs a gravimetric analysis. The chemist combines 1.00 L of 2.00 M AGNO, (ag) with…

A: Given: Concentration of AgNO3 = 2M Concentration of NaCl = 4M Volume of AgNO3 = 1 L Volume of NaCl =…

Q: A sample containing a mixture of CuCl2(s) and KCI(s) with a mole fraction of 13.8% KCI was dissolved…

A:

Q: A student needs to make 250 mL of 1.4 M Fe(NO3)3 by dilution. How many milliliters of a 5.0 M…

A: Given data:  Initial molarity of Fe(NO3)3 (M1) is 5.0 M The final volume of Fe(NO3)3 (V2) is 250 mL.…

Q: 5.00 mL of 2.32 M Fe(NO3)3 is combined with 1.00 mL of 0.50 M HClO4 and 4.00 mL of 2.00 × 10–2 M…

A: The reaction between Fe(NO3)3, HClO4, and KSCN is shown below.…

Q: 3. A mixer containing 100 gal of Na,SO4 solution (4 lbs of Na;S04 per gal) is attached to a…

A:

Q: Glycerol, C3H03, is a substance used extensively in the manufacture of cosmetics, foodstuffs,…

A: given :-  volume of glycerol = 70.000 mL  density of glycerol = 1.2656 g/mL volume of solution =…

Q: A homogeneous solution contains copper(1I) ions (Cu2+), silver ions (Ag*) and potassium ions (K*).…

A: As per solubility data, compound with lowest solubility precipitates first. As only silver bromide…

Q: In the laboratory you dissolve 15.8 g of nickel(II) bromide in a volumetric flask and add water to a…

A: Answer:- This question is answered by using the simple concept of calculation of molarity of the…

Q: You

A: You can used the formula direactly,  ( M2 • V2 ) resulting Solution = ( M1 • V1 )stock solution…