Answered: An alternator operating at an…

An alternator operating at an efficiency of 98% has a full-load capacity of 25,000 kw. How much air expressed to the nearest thousand cfm, is required for ventilation

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A 415 V, 3-phase star connected alternator supplies a star-connected load, each phase of which has a…

Q: Q: For the sweep generator shown, if the transistor is triggered every 5msec. by the impulses shown.…

A: Solution- The transistor conducts in every 5msec.When the input is low, the current on the capacitor…

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: The detailed solution is provided below.

Q: Find the no load line voltage of a wye connected 3-phase, 6pole alternator which runs at 1200 rpm…

Q: The variable resistor Ro in the circuit shown is adjusted until maximum average power is delivered…

A: Given circuit, To find Ro we need to find VTH and Isc.

Q: A slow speed alternator works in parallel with a turbo-alternator, the combined output being 2500 kW…

A: We got two alernators one is slow speed alternator and another is turbo-alternator they both work in…

Q: -2. A. A lighting load of 2000 kW and a mo pplied by two alternators running in parallel E. lagging.…

Q: A 100KVA, 3000V, 60Hz, 3-phase, wye connected alternator operates at rated KVA at a power factor of…

Q: A three-phase synchronous generator with a nominal pole voltage of 3300 V, nominal apparent power of…

A: The objective of the question is to calculate the real power absorbed by the load during nominal…

Q: 5 QUESTIONS 1. Instantaneous power of an AC signal is not particularly useful in electronics. Why? E…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: 7. A power station has to meet the following load demand : 50 kW Load 4 between 10 A.M. and 6 P.M.…

A: The solution can be achieved as follows.

Q: In hydroelectric power station, the flow of falling water of 70 m3 / sec will be available at a head…

Q: A

Q: Niagara Falls, Ontario has attracted tourists from all over the world since even the early 19th…

A: Given data, Output power P0=2000 MW Average energy used by per household = 11 MWh

Q: One side of a transformer has 1,800 turns while the other side has 450 turns. The high voltage side…

Q: A three-phase turbo alternator has a reactance of 15 ohms and negligible resistance, the machine…

Q: 5. The maximum load on the Thermal Plant of 60MW capacity is 50MW at an Annual Load Factor of 50%.…

A: Thermal power plant is generate the electricity . it is also known as a combustion power plant . it…

Q: An industrial assembly hall is continuously lightedby one hundred 40-W mercury vapor lamps…

A: An industrial assembly hall is lighted by 100 mercury vapor lamps whose rating is 40W each. So, the…

Q: Q1: A 50HZ,11KV,3-ph,alternator with earthed neutral has a reactance of 50\ph and is connected to…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 1. A sinusoidal voltage source in placed in series with a DC voltage source and produces an output…

A: It is given that: vt=70.7cos377t+20 volts

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: I am attaching detailed solution image of this question.

Q: 5. A 240-V rms 60-Hz source supplies a parallel combination of a 5-kW heater and a 30-kVA induction…

A: In this question , parallel connected load is given....We have to find out system apparent power ,…

Q: A single-phase swimming pool pump motor consumes a power of 12 kVA when supplied by a sinusoidal…

Q: Current i enters a generalized circuit element at the positive terminal and the voltage across the…

A: Consider both the circuit shown below. In Figure-1 current is leaving from the active element which…

Q: Q23. The average load of a dairy plant at 11 kV, 50 Hz is 950 kW at 80% power factor, but the…

A: Write the given values in the question. P1=950 kWf=50 Hzpf1=80%=0.8P2=1200 kWpf2=95%=0.95

Q: 1. A lighting load of 600 kW and a motor load of 707 kW at 0.707 lag are supplied by two alternators…

A: Given: Lighting load, P1=600kW Motor load, P2=707kW Motor load p.f, cosϕ2=0.707(lagging) Power…

Q: The nameplate of an electric molur owing information: Line voltage: 220V rms Line current: 15 A rms…

Q: A 2500kVA, 6600V synchronous turbo alternator is operating at full load and 0.8 pf lagging. This…

Q: An air blast circuit breaker is designed to interrupt a transformer magnetising current of 15 A…

A: Given, An air blast circuit breaker is designed with, Magnetizing current, Im=15 A Chopping current,…

Q: Three similar coils are star connected to a 3-phase, 400 V, 50 Hz supply. If the inductance and…

A: Three similar coils are star connected to a 3-phase, 400 V, 50 Hz supply. Inductance 38.2mH…

Q: Neon signs (which often contain gases other than neon) use high voltage to excite gaseous atoms that…

Q: A 240 rms 60 Hz source supplies a parallel combination of a 4.5-kW heater and a 27-kVA inductor…

A: In this question we need to find the kVA rating of the capacitor required to adjust the system power…

Q: 1) Voltage and current waveforms for a certain load are shown in Figure 1 parts a and b…

Q: A generator rated 75MVA is delivering 0.8pu power to a motor through a transmission line of…

Q: None

A: 1. Calculate the RMS Voltage:The RMS (Root Mean Square) voltage is the effective value of the AC…

Q: What is the RMS value of an AC voltage that has a 347 V peak? O a. 245.3 Ob.490.6 C. 265.7 d. 469.3

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A 3- phase , 50 Hz, 400 motor develops 100 H.P. ( 74.6 kW ), the power factor being 0.75 lagging and…

Question

100%

17. An alternator operating at an efficiency of 98% has a full-load capacity of 25,000 kw. How much air
expressed to the nearest thousand cfm, is required for ventilation?
A. 98,000 cfm
B. 25,000 cfm
C. 75,000 cfm
D. 51,000 cfm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

In electrical power systems, the transmission of electrical power at high voltage allows to: Select one: a. Reduce the line voltage drop. O b. Reduce the reactive power. O c. None of the above d. Improve the power factor.
A generating station has a maximum demand of 30,000 kW. Calculate the cost per unit generated from the following data: Capital cost = P 130M; Annual load factor = 50%; Annual cost of fuel and oil = P7.5M ; Taxes, wages and salaries etc. = P7M and Interest and depreciation = 12%
A noninductive heater element with a resistance of 5 2 is connected across a 60 Hz source. The supply has a sine wave voltage with an instantaneous maximum value of 141.4 V. a. Determine the power in watts taken by the heater unit. b. What is the energy, in kilowatt-hours, taken by the heater unit in one month if it is operated 5 hours per day for a period of 20 days?
Two AC generators running in parallel supply the following loads: 400kW at unity pf; 500kW at 0.9 lagging pf; 600kW at 0.866 lagging pf. One machine is loaded to 1000kW at 0.92 lagging pf, what is the operating pf of the second machine? Ans. 0.951 lagging
An 11 kV, three-phase, star-connected alternator has a synchronous impedance of10∟80° Ω/phase and operates at unity power factor on infinite bus bars. It supplies acurrent of 300 A by using a general load diagram. Determine: the full-load current for normal excitation ( motor mode), the current and power factor for 100% excitation on 25% overload (generatormode), the maximum power that the machine can develop in the generator mode for50% excitation
The 3-phase average power rating of the CPU on a mainframe computer is 22,659 W. The 3- phase line supplying the computer has a line voltage rating of 208 V (rms). The line current is 73.8 A (rms). The computer absorbs magnetizing VARS. a) Calculate the total magnetizing reactive power absorbed by the CPU. b) Calculate the power factor.
11-12 how to solve?!
A single-phase electrical installation, supplied by a voltage of 220V; 50Hz, includes in parallel: Two single-phase motors, each of useful power P, = 2000W, efficiency n = 0.8 and power factor cosp = 0.75. Four incandescent lamps of 200W each. Two single-phase air conditioners, each of absorbed power P. 1000 W and power factor cosp=0.8. 1- Calculate the total active power of the installation 2- Calculate the total reactive power of the installation 3- Calculate the total apparent power of the installation 4- Calculate the total power factor of the installation 5- Calculate the intensity of the total current
Subject Power System Quality
One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10Vinduced in it and the coils are arranged in slots so that there is a successive phase displacement of10 electrical degrees between the emf in each coil an the next. Find by calculation the rms value ofthe total phase voltage developed by the winding. If the alternator has six pole and is driven at 100rpm.