Answered: An alternating current of 5A and a…

An alternating current of 5A and a direct current of 10A flow simultaneously in the same conductor. What will an AC ammeter indicate when inserted in the circuit? A. 15A C. 7.5A B. 11.18A D. 10A

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A pure element is connected across an AC signal. CH1 and CH2 measures the voltage and current,…

Q: In the three phase half wave controlled converter, after one cycle, when will the thyristor T3 be…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: Alternating voltage and current differ from direct voltage and current because alternating voltage…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 1. Find the average value of current when the curren that are equidistant are 4A, 5A and 6A.

A: It is given that:

Q: Find the maximum value of a sinusoidal voltage with an effective value of 110 Volts.

Q: Suppose you are asked to generate the waveforms as shown in figure 1, continuous over time, using…

Q: iii. Induced emf in the coil if the current fall from 3A to 1A a. 420V b. 620V c. 0.62V d. 0.42V

A: Put the given inductor value L and change in time

Q: Which of the following would have a greater amount of inductance if connected to an AC power source?…

A: The explanation is as follows.

Q: Choose [T]rue or [F]alse for the following statements. a) F b) T c) T d) T e) F Can you check if its…

A: a. True - The peak-to-peak value of a waveform is indeed the maximum instantaneous value measured…

Q: Why not use inductance in DC circuits

A: The explanation is as follows.

Q: A series circuit consisting of a 30 – microfarad and a 0.155 – henry inductor is connected to a 120…

A: Given data: C=30 μFL=0.155 HV=120 V

Q: R= バニスル | कि-30-

Q: If the output voltage across the transformer secondary coil is Vm AC volt. a- Give a circuit to…

A: We want the output as DC value. Hence a rectifier type circuit must be present. The input AC voltage…

Q: Let the voltage passing through a resistance R = 1000 ± 20 ohm is 10.0 ± 0.1 Volt. The average power…

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt ac source, and…

A: In thid question we will find given device types with given information...

Q: The value of armature current in the waveform is 14 A, a- 54 degrees, and B-155 degrees. The RMS…

Q: Stator core of alternator is built up of steel sheet lamination of thickness between a) 0.35 mm to…

A: Stator core of alternator

Q: The coil winding in PMMC meter is -1 small heavy large fine

A: Given The coil winding in PMMC meter is

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 200 Volts at 1.1 milli…

Q: v. With reference to an 50 Hz3 phase alternator explain how P,Q,V and F are controlled.

A: It is asked to explain the control of P (active power),Q (reactive power), V (voltage) and F…

Q: sinewave is having a frequency of 50 Hz and taneous voltage of 200 Volts at 1.2 milli ds. Find:…

Q: h of the following load is Inductive in nature tor hontor

A: Water heater is a resistive load and uses heat produced by resistors to heat water.

Q: 100 volts rms value triangular wave, the peak voltage will be (a) 100 V (b) 111 V (c) 141 V (d) 173…

A: We need to find out the peak value of triangular wave for given RMS Value .

Q: The efficiency of any real wind turbine O a. can be more than 59.3% O b. can be less than 59.3% O c.…

A: According to Betz's law as air flows through a certain area, and as wind speed slows from losing…

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

Q: 4) Listen Regarding a Sine wave of an A.C. voltage (pictured below for reference), changing the…

A: Option c only correct Since charging voltage level per division will only effect the village values…

Q: an ac circuit produces a current of 1-j2 amperes. If the voltage is 10∠0 or just 10 volts. Find the…

Q: Can V curve be plotted for an alternator. If yes then what is the difference between V curve of an…

Q: 5. A welder machine operates automatically as follows : 30A current in 10 seconds, 20A in 10 sec.,…

A: In this question we will find RMS value of given waveform....

Q: (i) Amplitude of waveform Q = Answer and unit for part 1 (ii) Peak to peak value of waveform P =…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

An alternating current of 5A and a direct current of 10A flow
simultaneously in the same conductor. What will an AC ammeter
indicate when inserted in the circuit?
A. 15A
C. 7.5A
B. 11.18A
D. 10A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Choose [T]rue or [F]alse for the following statements. a) F b) T c) T d) F e) T
The sinewave has a peak voltage of 7 A and a Half cycle value of 9.3333 ms. What is the frequency? a. 214.28 Hz b. 321.42 Hz c. 53.57 Hz d. 35.71 Hz
3- Please I want answer of this Electrical Principles question. Thanks
How do we increase or decrease the generated voltage output in the operation of a factory finished Alternator?
13. Thevenize the bridge circuit across a-b in figure 13.
Rating of Fuse for the rated current of 7A is a. 7A b. 10.5A C. 3.5A d. 14A
Instantaneous voltage is multiplication of the resistace and .......... current in the resistive circuit. a) instantaneous b) average c) rms d) peak
In Canada, the AC power line voltage is nominally 115 V Vrms at 60 Hz. What are the peak voltage and the peak-to-peak voltage in this setting?
Compare between AC circuits and DC circuits
Describe the characteristic and operation of the meter movement in measuring alternating-current. Provide illustrations.
Determine the CH2 peak value. Write the values only in four decimal places. the correct answer is 1.9600 please show the solution thank you!
Each terminal of a small polarity-independent incandescent bulb is connected to the positive terminals of two (2) DC voltage sources. The negative terminals of these sources are connected together. The first voltage source can have a range of value from 0-12, incrementable by 1.5 volts every turn of the rotary switch (i.e. 0 V, 1.5 V, 3 V, 4.5 V .... 12 V). The voltage of the second source is unknown. Using a luxmeter, the brightness of the lamp was measured for every increment of voltage of the first source. The following observations were recorded: a. 1.5 V produces a higher brightness than 3 V b. 0 V produces a higher brightness than 1.5 V c. 12 V produces higher brightness than 9 V d. 12 V produces equal brightness as 3 V What is the voltage of the second source? Justify each observation.