Air treated as an ideal gas and having a specific heat at constant volume Cv=1200 J/kg.K undergoes a process. During this process, heat is observed to exit the system with an amount of 10 kJ while work is provided to the system with an amount of 22 kJ. If the initial temperature of air was 20 C, what is the final temperature of air if the mass of air undergoing the process is 0.4 Kg. Select one: a. 45 C b. 49.5 C c. 39.4 C d. 51.4 C

Air treated as an ideal gas and having a specific heat at constant volume Cv=1200 J/kg.K undergoes a process. During this process, heat is observed to exit the system with an amount of 10 kJ while work is provided to the system with an amount of 22 kJ. If the initial temperature of air was 20 C, what is the final temperature of air if the mass of air undergoing the process is 0.4 Kg. Select one: a. 45 C b. 49.5 C c. 39.4 C d. 51.4 C

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A piston-cylinder contains gas initially at 3500 kPaa with a volume of 0.03 m². The gas is compressed during a process where pV¹25= C to a pressure of 8500 kPaa. The heat transfer from the gas is 2.5 kJ. Determine the change in internal energy, neglecting changes in kinetic and potential energies. [Ans. 141.9 kJ]
* Your answer is incorrect. A piston-cylinder assembly contains 0.7 lb of propane. The propane expands from an initial state where p₁ = 60 lbf/in.² and T₁ = 70°F to a final state where p₂ = 10 lbf/in.² During the process, the pressure and specific volume are related by pv² = constant. Determine the energy transfer by work, in Btu. W = i 3.123 Btu
In the polytropic process pvn Constant if n = 1 the process is termed as
In a given experiment, we want to study the expansion of a gas from state i to state f by three different paths in the pV diagram. Based on the following figure, where the pressure is indicated in atmospheres and the volume in liters, determine the work done by the gas, in joules: (a) Along the path iaf (b) Along the path if. (c) Along path ibf.
Saturated air at 55F dry bulb (db) temperature is heated to 100 F db. The required heating energy, in BTU/lbair, is most likely: 11 Btu/lbm 15 Btu/lb 9 Btu/lb 5 Btu/lb 20 Btu/lb
Please solve this in thermodynamics
b) Steam generators are a type of heat exchanges that are used in power plants to generate steam at desired pressure and temperature (Fig. Q1.b). In a steam generator, saturated liquid water at 30°C enters a 60-mm diameter tube at the volume flow rate of 12 L/s. After exchanging heat with hot gas, the water changes to steam and leaves the generator at a pressure of 9 MPa and a temperature of 400°C. During this process, the diameter of the water/steam tube does not change. Steam out Gas out Hot gas in Liquid water in Fig 2. Schematic of the steam generator in Q1.b. (i) Calculate the steam mass flow rate (ii) What is the inlet velocity of the steam? (iii) What is the exit velocity of the steam? (iv) Calculate the rate of heat transfer (in MW) required to change the phase of liquid water to steam.
Need correctly...