A4 The circuit showed in Figure A4, is powered by an AC voltage source Vs. Sketch the phasor notation for the currents and admittances in the circuit. Tip: the admittance Y is defined as 1/Z, where Z is an impedance. a. Current phasor sketch. b. Admittance phasor sketch. c. Calculate the inductive reactance, assuming the following values: L = 12 mH, frequency = 1.5 kHz. R VR S FIGURE A4 ୮୪୪୪ VL

A4 The circuit showed in Figure A4, is powered by an AC voltage source Vs. Sketch the phasor notation for the currents and admittances in the circuit. Tip: the admittance Y is defined as 1/Z, where Z is an impedance. a. Current phasor sketch. b. Admittance phasor sketch. c. Calculate the inductive reactance, assuming the following values: L = 12 mH, frequency = 1.5 kHz. R VR S FIGURE A4 ୮୪୪୪ VL

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and capacitor in series. b) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and inductor in series.
A sinusoidal current of 5 Arms is flowing through a series combination of a resistor and Inductor. The value of R is 45 ohms and that of the inductance is 15 mH and a frequency of 60 Hz. Find the magnitude and the phase angle of the voltage across the combination. (Hint: you can use phasor diagram). Select one: a. [V]=28.89, angle=9.39 b. IV]=25.60, angle367.00 c. [V]=128.01, angle3D10.18 d. IVl=226.77, angle=D7.16
write a report to compare between ac througe capactance and ac throughe in inductance then:for the cirucit shown beside, find the total impedance between a & b and cirucit current (I)
AC Circuits Current, Voltage, Power, Power Factor and Phasor Diagrams. Consider the circuit shown in Figure 3. (i) Find the total impedance ZT as seen by the voltage source. (ii) Find the total current IT supplied by the source. (iii) Sketch phasor diagram of Vs and IT and State whether IT leads or lags Vs (iv) Determine the power factor angle for the circuit. 9. L R1 1002 0.213H IT Vs R3 1502 C 12020°V 22µF 60HZ R2 50Ω Figure 3 Answers |(1) Zr = (ii) IT= (iii)
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Given the DELTA-connected resistors, inductors, and capacitors. Convert into to equivalent WYE-connection.
Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
What impedance vector - j25 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
An ac voltage represents by a sinusoidal waveform as shown in Figure 6 below. a) Define: i. The period ii. The frequency