a. For the network below, determine lg, Ic. VE and VCE

Q: Solve for all current values though and voltage across each resistor.

A:

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V v.

A:

Q: When the load impedance is equal to the characteristic impedance of the transmission lines, then the...

A: Calculation of  reflection coefficient and standing wave ration, of the transmission lines when the ...

Q: What is the characteristic time o

A:

Q: Problem 2.24: If a system known to be linear and time-invariant has the response to x(t) = u(t) give...

A: The solution is given below 

Q: 3. Find the values of resistance R and capacitance C in the circuit, if I = 1.442 33.959 A. 130 s 40...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: RTD Ri Figure 3(b) 3

A:

Q: Q7. Explain what happen to a power supply if there is no smoothing capacitor connected across the ou...

A: If the capacitor are connected across the output then capacitor increase the DC voltage and there is...

Q: QI Find the magnitude, phase, real part, and imaginary part of the complex signal elw x(w) = %3D (jw...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 R1 R3 R5 10 V1 12 R2 6....

A: Given circuit shown    

Q: A coil of wire of resistace 50 ohm is embeded in a block of ice. What is the amount of ice melted in...

A:

Q: A load of 1250 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

A:

Q: 1YO V 10 SL 20 N 10 L 16 N 82

A:

Q: Total capacitance of two capacitors of 20 mF connected in parallel will be:

A: Given: Two capacitors of 20 mF connected in parallel.

Q: Explainanyonepracticalmeasurementsystemwithallofitsfunctionalelements

A: Pressure measurement system:

Q: SCR is a three layered three junction power electronic switch? a.True b. False

A:

Q: A silicon p+ - n junction has a donor doping of 7*10^17 cm-3 on the n −side and a cross-sectional ar...

A: Brief description: For a given p+n- junction we need to calculate the value of forward diffusion cur...

Q: In free space, V = 6xy z + 8. Py at At point P (-3, 3, 3) %3D O 424.4 pC/m3 954.9 pC/m3 O 106.1 pC/m...

A: Volume charge density = divergence of flux density. But flux density D=€E where € is permitivity . A...

Q: 122 122 D2 MM 1252

A:

Q: Referencing the 555 timer datasheet pin functions section, which pin will disable the timer when a n...

A: I am giving the answer of this question. control voltage- The threshold and trigger levels are contr...

Q: A water jet cinsume 3450 W for 126 hours a week.  1. What is the energy consumed (kWh) for one-year...

A:

Q: Question 1 Find the current, I which pass through 52 resistor by using Norton equivalent circuit. 2Ω...

A:

Q: Determine the commutator pitches Y. for the following wave-wound armatures: (a) 75 segments, four po...

A: This question belongs to electrical machine . It is based on the commutator pitch for a wave wound a...

Q: What is the dominant lower critical frequency of a three-stage amplifier in which fcl = 50 Hz for ea...

A:

Q: Explain anyone practical measurement system with all of its functional elements

A: The practical measurement system includes modern measuring instruments such as multimeter, oscillosc...

Q: The cost of a single phase overhead feeder is OMR 7 a per km ( a is area of cross section in sq mm) ...

A: It is given that: For 1m of length and 1mm2 cross-section area of conductor,Resistance=162Ωcost of s...

Q: F a) Write the switching expression for the output, F(A,B,C,D) b) Simplify this switching function s...

A: To simplify output, we will follow outputs from each gates and so on we can conclude final output F....

Q: A diode is not yet fully forward biased (Vp=0 3V) so there is only a small amount of current The sat...

A:

Q: Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6| B = |0| and C =[10 5 1] ...

A: Given a system defined by x˙=Ax+Buy=Cx where, A=010001-6-11-6B=101C=1051

Q: A 46-mH inductive coil has a resistance of 10 ohms. How much current will it draw if connected acros...

A:

Q: Convert to integral form. Use either Gauss or Stokes theorem V × F = x

A:

Q: If your cellphone camera needs at least 1000 photons per second to detect light of wavelength 502 nm...

A: Given  Number of photons n=1000wavelength λ=502 nmc=2.998×1018 m/sh=6.626×10-34 J.s

Q: At T 400K, what the concentration of free electrons / holes in intrinsic silicon? 1.5x1010/cm3 5.16x...

A:

Q: Y(s RO) Et

A: Given       Signal flow diagram shown 

Q: : Mention and explain any 4 the differences between conducting and Non-conducting wires

A: Conducting and Non-conducting wires:

Q: What kind of circuit is shown in the figure? Q16Fig1.gif O 1.Low-pass filter O 2.High-pass filter O3...

A: In circuit 1 capacitor is in series with resistor and output is taken from resistor  Hence given cir...

Q: This code check whether a number is divisible by 5 and 11 or not. * 1-.. 2-.... 3-.... 4-... O 1-lf ...

A: The code for checking whether the given number is divisible by 5 and 11 or not:  

Q: Use superposition to find the voltage v in the circuit shown. ЗА 10Ω ww www + V - 40 V 10 Ω 2V,

A: In this question we will find voltage across 8 ohm using superposition theorem.... Superperposition ...

Q: An Alternator having three-phase, 3-wire ABC system supplying an effective line voltage of 120 V, ha...

A:

Q: Explain the essential features of Indicating Instruments?  Diagrams – draw neatly , scan and attach...

A: Measuring instrument- Define a measuring instrument as any device that can be used to determine the ...

Q: Determine the forward diode current for a silicon PN junction diode when the applied forward biased ...

A: Given Forward biased voltage =0.8 vTemperature=36°CReverse saturation current=15μA

Q: Distinguish between i. Series Mixing and Shunt Mixing of a Feedback amplifier. iii Voltage Sampling ...

A: Series Mixing Shunt Mixing 1. In type for voltage as a signal the series mixing exhibit the series...

Q: Obtain c(1.4) and c(2.4) under the unit step input using the modifiedz-transform. (T-0.5) R(2) ZOH T...

A:

Q: 4. Find the branch current analysis at the circuit shwon in figure below. a I R3310 N R1 ils, 2 E, 1...

A: Branch current analysis means I am using kirchoff current law(KCL).

Q: n the PN junction shown below, the charges of the depletion region are due to? " this is the questio...

A: The diagram shows the charges in the diode in the depletion region. The depletion region have both t...

Q: 2.a. Find the total resistance between 'a’ and 'b’ for the circuit given below. 1Ω 1Ω 10 Ω a o Rab 5...

A: Given,

Q: Ex. Calculate the PA for the follow assembly code which is assume the DS = 4500h, SS = 2000h, BX = 2...

A: Registers can be used instead of using memory which is smaller in size and takes less time to be acc...

Q: 10 6m PR1:V(1)-V(0) .PR2: I(R1) 5m 7.5 4m 5 3m 2m 2.5 1m -1m -2.5 -2m -5 -3m -4m -7.5 -5m -10 38.394...

A:

Q: (a) calculate the possible value of the linear displacement of its rod. (b) design and sketch an ope...

A:

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Air Blast Circuit Breaker....

A: link https://circuitglobe.com/air-blast-circuit-breaker.html

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).