A wheel is mounted on a steel shaft (G = 83×10⁹ N/m²) of length (1.5 m) and radius (0.80 cm). The wheel is rotated (5°) and released. The period of oscillation is observed as (2.3 s). Determine the mass moment of inertia of the wheel.

A wheel is mounted on a steel shaft (G = 83×10⁹ N/m²) of length (1.5 m) and radius (0.80 cm). The wheel is rotated (5°) and released. The period of oscillation is observed as (2.3 s). Determine the mass moment of inertia of the wheel.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Determine the oscillations of a system with two degrees is L = (x² + y²) - w²(x² + y²)

Q: Estimate the period T of a kitchen broom allowed to swing in small oscillations while suspended from…

A: Suppose there is a short broom, consisting of 1.2 m rod of mass 0.5 kg and a dust collector at the…

Q: An electric motor delivers 4 kW power at 1725 Rpm its rotating speed. The motor is mounted on 4…

A: Given:-Power, P=4 KW=4000WSpeed, N=1725 RPMNumber of springs, n=4Spring stiffness constant, k=15…

Q: Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m,…

Q: HW2 A uniform disc of 80 mm radiuse has a mass of 2000 g. It is mounted centrally in bearings which…

A: Given d=80mm r= 40mm = 0.04m m= 2000g = 2kg N=550rpm…

Q: QUESTION: A disk of mass m of radius R is mounted on a swivel joint L from the center of gravity as…

Q: 7. Derive the mass equivalent of the system shown. pulley m2

A: All frameworks having mass and versatility are prepared to do free vibration, or vibration that…

Q: A disk, mass 2kg, radius 0.5m spins at a constant angular speed w = 12s¹ about an axle that is at an…

Q: The spool of cable has a mass of m (100 kg) and a radius of gyration of k (0.77m). The tension in…

A: given; mass(m)=100kgradius of gyration(kc)=077mtension force(T)=(30t3+77t )Ninner…

Q: A block of wood floats in water in the stable equilibrium position shown. The block is displaced…

A: Condition of dynamic force equilibrium, Fx is the net force acting on the system m is the mass of…

Q: 01 A solid homogeneous cylinder of radius R and mass m rotates freely from its initial rest position…

Q: QUESTION 3: A mass m=(2A+3)kg in Fig. 3 is attached on top of a straight rigid bar that is hinged at…

A: in above image there are 2 questions which are not related to each other. As per honor code and…

Q: The free-fixed rod ( length of 2 m, diameter of 0.5 mm, density of 300 kg/m') vibrates in lengthwise…

Q: PROBLEM II) In the following figure ignore the given harmonic displacement xg and assume that a…

A: Equations of motion are mathematical expressions that describe a physical system's behavior in terms…

Q: A turbine rotor of a ship is of 2000 kg mass and has a radius of gyration of 0.8 m. Its speed is 200…

A: The objective of the question is to determine the maximum couple tending to shear the holding down…

Q: Determine the natural frequency of the system shown beside using Motion equation

Q: System is shown. mass=M Length = L Uniform rod is pivoted about one end and oscillates in a…

A: givenmass of uniform rod=Mlength of uniform rod =Lone place a mass m=M

Q: The plane of the figure represents a horizontal plane. A thin rigid rod at rest is pivoted without…

Q: A wheel is mounted on a shaft (G= 80x10^9 N/m^2) of length 3 m and radius 1 cm. The wheel is rotated…

A: GivenG=80×109 N/m2L=3mr=1cm=0.01mθ=5degreeT=2.3s

Q: The mass of the system shown is released from rest at xo = 7.5 in. when t = 0. Determine the…

A: The weight is W=32.2 lb The spring constant is k=11.56 lb/ft The initial displacement is xo=7.5 in…

Q: A flywheel is fitted to a multi cylinder engine, which runs at a mean speed of 390 r.p.m. If the…

A: Given data:

Q: A connecting rod is supported by a knife-edge at point A; the period of its small oscillations is…

A: Equation of motion. -mgsinθ=(mrα)r+mk2αα+grr2+k2sinθ=0 For small oscillations, sinθ=θ…

Q: nd the expression for the motion of mass B as a function of the bar angle (theta). Plot e…

A: To find the expression of the system and to plot the displacement of mass Blet mass of the ball A =…

Q: A uniform density stick of length L oscillates as a physical pendulum. It is pivoted a distance x…

A: Write the expression for the moment of inertia by using the parallel axis theorem and substitute the…

Q: Determine the period of small oscillations of a small particle that moves without friction inside a…

Q: The mass moment of Inertia of rotating parts of an automobile with rear engine is 1.2 kg - m and…

A: The answer is in below steps

Q: A multi cylinder engine is fitted with a flywheel of mass 0.7 ton ,which runs at a mean speed of 440…

Q: A shaft 1.5 m long has a diameter of 5 cm for the first 75 cm and diameter 7.5 cm for the remaining…

A: The solution is in next step

Q: W Moment of inertia OLD FEL Uniform rigid bar, mass m

A: To determine the equation of motion of the rigid bar.

Q: A flywheel with a radius of gyration 0.5 m is fitted to a multi cylinder engine, which runs at a…

A: Given k=0.5 mN=360rpmCs=0.02−(−0.04)=0.06ΔE=45kN⋅mTo FindMoment of inertia of the flywheelMass of…

Q: inertia (in kg.m) of a flywheel t

A: Given data, Maximum fluctuation of KE in an engine has been calculated to be= 2600 JAverage speed…

Q: The homogeneous rod OA is supported at point 0, and a mass of 2m is attached at the bottom of the…

A: A system consists both potential energy U and kinetic energy K, according to law of conservation of…

Q: Derive the equation of motions using Lagrange's equation for the system given in Fig. 1. F(0) 5k F0)…

Q: A body of uniform cross-sectional area A ane density po and at equilibrium displaces a vol…

Q: A uniform disc of 80 mm radiuse has a mass of 2000 g. It is mounted centrally in bearings which…

Question

A wheel is mounted on a steel shaft (G = 83×10° N/m²) of length
(1.5 m) and radius (0.80 cm). The wheel is rotated (5°) and
released. The period of oscillation is observed as (2.3 s). Determine
the mass moment of inertia of the wheel.
LU
1.5 m
0 (1)
G= 83 x 10' N/m²
r = 8 mm
Fig (5)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: To find frequency of oscilation and torsional stiffness

VIEW

Step 3: to calaculate mass momet of inertia

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An aluminum sphere with a radius of 8 in. is attached to one end of a 20 ft long aluminum rod of 1 in. diameter. For aluminum, modulus of elasticity, G = 3.44 x 10 Ib/in while its density is 0.097 Ib/in The other end of the rod is fixed as shown. Find the period of this pendulum
The least radius of gyration of a ship is 8 m and meta-centric height 70 cm. Calculate the time period of oscillation of the ship?
A wheel is attached by a cable to a block The wheel has a radius of 2ft and weighs 300lbs, the block weights 20lbs. If the radius of gyration about the point of rotation of the disk is 1.5ft, how many revolutions will it take for the wheel to come to a stop assuming it was moving at 10 rad/s CW. Assume the block is on the left side of the wheel and thus causes a CCW moment.
Wng Consider systems A and B shown in the figure. The ratio of natural frequency of system A(wn,) to natural frequency of system B(wng), i.e. 4 is: (for the disc, assume moment of inertia about its centre is Assume g = 9.81 m/s? juiny m m. g = 9.81 m/s? A a frictionless No slip V3 о ООО о
I need the answer as soon as possible
Maximum fluctuation of kinetic energy in an engine has been calculated to be 2600 J. Assuming that the engine runs at an average speed of 200 rpm, the polar mass moment of inertia (in kg.m) of a flywheel to keep the speed fluctuation within ±0.5% of the average speed is
the subject is vibration engineering. please answer my question. im begging you
4. In order to determine the mass moment of inertia of a 4-foot diameter flywheel, the flywheel is tested\twice with different deadweight. In the first test a weight of 20 lb is attached by cord and observed to fall 10 ft in 4.6 seconds. In the second test a weight of 40 lb falls 10 ft in 3.1 seconds. Assuming that the torque due to bearing friction is constant, determine mass moment of inertia of the flywheel. Your solution must include W supporting FBDS.
Determine the first three natural frequencies of the post shown. The post is made of structural steel with a modulus of elasticity of E = 29 x 10° lb/in² and a mass density of 15.2 slugs/ft³. Consider only the axial oscillation. 5 ft 5 ft 10 ft A= 0.75 in² A = 2.15 in² A-2.95 in²
Solve it correctly please.