(a) What is the energy stored in the capacitor 90s after we close the switch? (b) What is the energy dissipated by the resistor during the first 90s since the switch is closed?

Q: Раовсем #8 ANALYZE THE USE A SOUME TRANSFORMATION FOR 10 ER RESISTOR FIRST. ^^^ CIRCUIT AND…

A:

Q: The transfer function of a system is 2s² + 6s +5 (s + 1)² (s+2) The characteristic equation of the…

A: This is a problem of control system. The solution is given in the next step

Q: For the control system shown below, if K(s) is a proportional + integral + derivative controller,…

A: The block diagram is given as Here, the transfer function of the controller will…

Q: Drain current (A) 800 600 400 200 2 4 Drain-source voltage (V) 3 5 5 V 4 V 3 V 2 V The output…

A: The output characteristics of the NMOS transistor are defined between the drain-to-source voltage…

Q: 2.2 Consider the RC circuit of Figure 9 in which a 0.1 volt input is applied for 0.5 millisecond and…

A:

Q: 1-Take the following system H, with the input z, and output y y(n) = x(n) - 2x(n − 1) + x(n − 2).…

A: As per Bartleby guideline we need to answer the first three questions only. Kindly repost the rest…

Q: 8. Determine v(t) and i(t). v = 20 sin(10t +30°) V i 4Ω 0.2 H

A:

Q: For the circuit shown above, what is the amplitude of the sinusoidal steady-state expression for vo?…

A: The capacitance and inductance should be converted into equivalent impedance and then by applying…

Q: It says the resonate frequency is not the arithmetic mean of the high and low cutoff frequencies and…

A: The low and high cut-off frequencies are shown below:fL=fo-12B.W.…

Q: 41. Use supermesh analysis to solve for the current voltage across the 8 resistor and the curren…

A:

Q: A differential amplifier is connected to a supply of Vs = ±10V, and has a nominal gain of 4x105.…

A: Given, Differential amplifier has Supply Voltage (Vs) = + or - 10V Nominal gain (A) = 4×105 We need…

Q: The transfer function of a system is 2s² + 6s +5 (s + 1)² (s+2) The characteristic equation of the…

A:

Q: An electromagnetic wave in free space is propagating along the z-direction and its electric field is…

A: Given data The direction of the propagation of the electromagnetic wave is +Z-direction. The…

Q: 1. Derive expression for propagation constant of T and π networks terminated through their…

A:

Q: QUESTION 2 10 cos 2t V + R www C io + 6 sin 21 V For the circuit shown above, what is the amplitude…

A:

Q: Problem 8. A balanced three-phase source furnishes power to the following three loads: Load 1: 1 kVA…

A: Given:- load 1 : 6 KVA at 0.83 pf lag load 2 : unknown load 3 : 8 KW at 0.7071 pf lead IL= 84.6 AVL…

Q: Q1 Select a suitable sampling time to digitize the following system 10 G(s)= S+4

A: Sampling theorem:

Q: Express the following into their phasor forms. a. i = 10sin (1000t + 20°) A b. v = 20cos (wt – 30°)…

A: We need to express the following in phasor form a. i = 10sin (1000t + 20°) A b. v = 20cos (wt – 30°)…

Q: Copy of Copy of A DSB-LC AM signal x (t) =a (1+ msin200t) cos 1000t with a=5 is the amplitude, m=0.8…

A:

Q: Q1. An FM transmitter has the block diagram shown in Figure Q1. The audio frequency response is…

A: Given: Range of audio frequency is 20 Hz-20 kHz. The carrier frequency is 90.7 MHz and the peak…

Q: V4 10 R5 2 Ĉin R8 6 C₁ Find i1, i2, and i3 11 4 13 R9 8 R6 12 V5 (+) 5 R7 3.

A:

Q: find the line and phase

A: The given three phase system is a balanced wye to Wye connected network. The line current and phase…

Q: What size branch-circuit conductor (THHN) is required for a 32A continuous nonlinear load that…

A: Given Conductor type =THHN load current =32  A load type = continuous non linear load

Q: 3. Obtain complex exponential Fourier series expansions for the following signals x(t) = At, (a) ܐܐܘ…

A:

Q: A silicon photodiode is connected to an op-amp as indicated. Under an illuminance of 500 lux, the…

A: According to the question, we need to explain the working of the circuit shown below

Q: Q7. A three phase Y-connected unbalanced load having the following phase impedances: Za = 20 +j1022,…

A: It is given that:- Za=20+j10 ohmZb=10+j10 ohmZc= 30-j15 ohm Zn = 20 ohm VL = 415 V

Q: More than 90% of the microprocessors/micro-controllers applications. Why? Could you explain this…

A: According to the question, we need to discuss the role of the microprocessor/micro-controller in the…

Q: 23. If weight of conductor of transmission line =770kg/km, with span length = 300 m, Ultimate…

A: Given: Weight of conductor of transmission line= 770 kg/km, span length=300 m, Ultimate strength=…

Q: A PCM based system has 2^N codewords. N=8, and the q value is 0.0078125. Evaluate the SQNR if the…

A: Given that n=8q=0.0078125Input signal amplitude is 0.1.

Q: RC Circuits VII Each circuit below consists of a battery, a capacitor and several resistors. Assume…

A:

Q: stablish and analyze Ohm's Law applied for a coil in sinusoidal alternating current.

A: According to the ohm's law current flowing across any conductor is directly proportional to the…

Q: 4. What value of filter capacitor is required to produce a 1% ripple factor for a full-wave…

A: 4. For the given Full wave rectifier having  RL = 1.5 K ohms  V ripple = 1% of V peak  V peak = 18 V…

Q: Figure below shows a 4-input OR gate built using a chain of gates. Determine the activity factors at…

A: Given, The 4-input OR gate built using a chain of gates is shown below,

Q: ideal op-amp behaviors

A:

Q: angle. O a. 30 degrees O b. 0.866 O c.0.6 O d. 60 degrees ee wire system, the two Wattmeter read…

A: It is given that:- W1=4000 WW2= 2000 W ϕ = ?

Q: QUESTION 2 10 cos 2t V +1 R www C m +1 6 sin 2t V For the circuit shown above, what is the amplitude…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: Example 12.34 A 40 KVA transformer has a core loss of 400 watts and full-load copper loss of 800…

A: Given- 40 kVA transformer, Core loss Pi=400 watts=0.4 kW, Full load copper loss Pc=800 W=0.8 kW,…

Q: Consider the sinusoidal voltage: v(t) = 125cos (250πt –25°) V. d.What is the phase angle in radians?…

A:

Q: What reading would be displayed by an digital multimetre if it were switched to an AC voltage range…

A:

Q: 1. Two coils having 500 and 50 turns respectively are wound side by side on an iron core of a cross-…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: do comparing between dielectric properties of oil insulators and liquid insulators

A: Dielectric Properties:- Dielectric properties include the dielectric constant and dissipation…

Q: 3. In figure A, V1 = 12 V, V2 = 15 V, V3= 25 V, V4= 30 V. The applied voltage E must be equal to V.…

A:

Q: The total current in this circuit is _______.

A: Given: 15 V AC source with 10 kHz frequency. Required: Total current in the given R-L circuit.

Q: 1. By hand, find the inverses of: [10 1 1] [J] [24] A₁ A2 A3

A:

Q: 2.) Find the value of a (46 - 12i)/a = 14 - 4i

A:

Q: A noninverting Schmitt trigger circuit has an Rin of 14kΩ, an Rf of 15kΩ, a -Vout of -5 V, and a…

A:

Q: "uestion 10 What is the magnitude of the impedance of a 50 mH inductor? Assume the frequency is 164…

A: We need to find out impedance for inductor .

Q: 3. This differential equation describes an LTI system with input u and output y: ÿ+ay+by = cù+u → a,…

A: Given data: The differential equation of the LTI system with input u and output y,     Determine the…

Q: Question 9 What is the value the following sinusoidal voltage signal v(t) = 115 cos (238t+ 25⁰ ) V…

A:

Q: An AC supply of 230 Vrms is applied to a half-wave rectifier circuit through a transformer of turn…

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.