(a) What is the efficiency (in percent) of a cyclical heat engine in which 30o.0 kJ of heat transfer occurs to the environment for every 50.0 kJ of heat transfer into the engine? % b) How much work (in kJ) does it produce for 500 k) of heat transfer into the engine? kJ

(a) What is the efficiency (in percent) of a cyclical heat engine in which 30o.0 kJ of heat transfer occurs to the environment for every 50.0 kJ of heat transfer into the engine? % b) How much work (in kJ) does it produce for 500 k) of heat transfer into the engine? kJ

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter4: The Second Law Of Thermodynamics

Section: Chapter Questions

Problem 80AP: A Carnot engine operates in a Carnot cycle between a heat source at 550 and a heat sink at 20 ....

See similar textbooks

Related questions

Q: Calculate the net work output (in J) of a heat engine following path ABCDA in the figure, where V1 =…

A: Write the given values from the diagram.

Q: A thermodynamic system undergoes a process in which its internal energy decreases by 600 J. Over the…

Q: In a very mild winter climate, a heat pump transfers heat from an environment at 4.00 °C to one at…

Q: A coal-fired electrical power station has an efficiency of 38%. The temperature of the steam leaving…

Q: An engine has a hot reservoir that contains 20 MJ of heat energy at 400º c, and a cold reservoir…

A: Solution: Given that Qhot = 20 MJ Qcold = 15 MJ

Q: Imagine a Carnot heat pump operates between an outside temperature of 0 °C and an inside temperature…

A: From the given equation,

Q: Suppose 200 J of work is done on a system and 70.0 cal is extracted from the system as heat. In the…

Q: An automobile engine has an the heat rejected by the engine. efficiency of 20% and produces 6000 J…

A: Given value--- efficiency = 20 percent. Work = 6000 J. We need to find--- Find the heat rejected…

Q: Suppose that there are two very large reservoirs of water, one at a temperature of 91.0 ∘C and one…

Q: How much heat transfer occurs to the environment per day by an electrical power station that uses…

A: Given: The total amount of heat transfer is 1.2×1014 J. The efficiency of the engine is 42%.…

Q: An inventor is marketing a device and claims that it takes 25. 00 kJ of heat at 327.00°C and…

A: Given Heat input = 25. 00 kJ Higher temperature = 327.00°C environment temperature or lower…

Q: It is claimed that, while running through a whole number of cycles, a heat engine takes in 25 kJ of…

A: First law of thermodynamics or law of conservation of energy states that the total energy of an…

Q: What is the efficiency of a gasoline engine that receives 194.5 J of energy from combustion and…

Q: A thermodynamic system undergoes a process in which its internal energy decreases by 500 J. Over the…

A: The expression for the required transferred energy is,

Q: A steam engine absorbs 7.91×105J and expels4.99 × 105J in each cycle. Assume that all ofthe…

Q: A 500 W Carnot engine operates between constanttemperaturereservoirs at 100 C and 60.0 C.What is the…

A: a) The rate of heat input is,

Q: Let’s say that the Carnot engine takes 100 J of heat from a reservoir at 500 K, does some work, and…

A: temperature of hot reservoir = TH= 500K energy from hot reservoir = QH= 100J temperature of cold…

Q: energy of cycle comprising four process in which the heat transfers are: 60 kJ/kg, -28 kJ/kg, -35…

A: First law states that the algebraic sum of work and heat tranfers in a cyclic process will be equal.…

Q: The energy transferred by heat from an engine during one cycle is 500 J. How much energy must be…

A: The heat transferred or rejected from the engine is, QR=500 J The efficiency, η=30%=0.30

Q: What is wrong with the claim that a cyclical heat engine does 4.00 kJ of work on an input of 24.0 kJ…

A: Energy conservation law states that Energy can never be created or destroyed, it can only be…

Q: Two heat engines are operated in series so that part of the energy expelled from engine A is…

Q: Is it possible to construct a heat engine that creates no thermal pollution?

A: Heat engine is an engine that takes in energy as heat and partially converts it into other forms…

Q: When gasoline burns in an automobile engine, the heat released (336 J) causes the products CO2 and…

A: ΔU=?q=-336 JW=-463 J

Q: A 37 percent efficient engine loses 400 J of heat during each cycle. What work is done, and how much…

A: The given data are listed below with appropriate variables. Here, η denotes the efficiency and QL…

Q: If 1 kg of air at 250 kPaa pressure and 100°C were to be expanded at constant pressure in a closed…

Q: An engine with an efficiency of 0.34 absorbs 55 J from a heat reservoir in each cycle. If it…

Q: An ideal heat pump, one that satisfies the Carnot relationship W = Qh11 - Tc>Th2, is used to…

A: Given: The room temperature is T=293 K. The outdoor temperature is T'=273 K. The work done is W=275…

Q: An inventor claims a new cyclic engine that uses organic grapejuice as its working material.…

A: heat absorbed, QH = 1250 J temperature of hot reservoir, TH = 1010 K work, W = 1120J temperature of…

Q: A given cyclical heat engine can do 1.6 × 105 J of work with 2.27 × 106 J of heat input. What…

A: Efficiency=η=WorkInput=1.6×105 J2.27×106 J=0.0705=7.05%

Q: A heat engine working between 230.0°C and 520.0°C, takes in 1.401 x 107 J of heat and delivers 4.100…

Q: What is the minimum work required of a refrigerator if it is to extract 50 J per cycle from the…

A: The expression for work done by the refrigerator is,

Q: Consider a heat engine that uses reservoirs at 800.°C and 0.00 °C. Calculate the maximum possible…

A: The expression for the efficiency of the heat engine is given by, η=1-T2T1×100 -----(1) Here, η is…

Q: What is the best coefficient of performance possible for such a heat pump, if it has a hot reservoir…

A: The temperature of the hot reservoir is, TH=45.0°C+273=318 K The temperature of the cold reservoir…

Q: Suppose as a system increases in volume, it absorbs 52.5J of energy in the form of heat from the…

A: Consider a system takes ΔQ amount of heat and spent it by doing work against pressure P to increase…

Q: If the heat absorbed by any engine is 530.44 J and if the efficiency of this engine is 66%, then the…

A: Given Heat absorbed Q=530.44J Efficiency η=0.66

Q: An engineer must design a refrigerator that does 300 J of work per cycle to extract 2100 J of heat…

A: Write the variables with suitable value.

Q: An inventor claims to have devised a cyclic engine which exchanges heat with reservoirs 25ºC and…

Q: A total of a 185 J of work is done on a gaseous refrigerant as it under goes compression, If the…

A: Given data The amount of total work done on the gas is W=-185 J. The increase in internal energy of…

Q: What is wrong with the claim that a cyclical heat engine does 4.00 kJ of work on an input of 24.0 kJ…

A: Work output is the difference between the heat transfer into the engine and heat transfer to the…

Q: (2) lihäi The coefficient of performance of a heat pump that is removing heat from the cold outdoors…

Question

(a) What is the efficiency (in percent) of a cyclical heat engine in which 30.0 k) of heat transfer occurs to the environment for every 50.0 kJ of heat transfer into the engine?
%
hob) How much work (in kJ) does it produce for 500 k) of heat transfer into the engine?
kJ

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The energy output of a heat pump is greater than the energy used to operate the pump. Why doesn't this statement violate the first law of thermodynamics?
Consider the processes shown below. In the processes AB and BC, 3600 J and 2400 J of heat are added to the system, respectively. (a) Find the work done in each of the processes AB, BC, AD, and DC. (b) Find the internal energy change in processes AB and BC. (c) Find the internal energy difference between states C and A. (d) Find the total heat added in the ADC process. (e) From the information give, can you find the heat added in process AD? Why or why not?
Consider the process shown below. During steps AB and BC, 3600 J and 2400 J of heat, respectively, are added to the system. (a) Find the work done in each of the processes AB, BC, AD, and DC. (b) Find the internal energy change in processes AB and BC. (c) Find the internal energy difference between states C and A (d) Find the total heat added in the ADC process. (e) From the information given, can you find the heat added in process AD? Why or why not?
A thermodynamic system undergoes a process in which its internal energy decreases by 500 J. Over the same time interval, 220 J of work is done on the system. Find the energy transferred from it by heat.
Suppose 20 g of ice at 0 is added to 300 g of water at 60 . What is the total change in entropy of the mixture after it reaches thermal equilibrium?
Calculate the net work output of a heat engine following path ABCDA as shown below.
Consider a transformation from point A to B in a two-step process. First, the pressure is lowered from 3 MPa at point A to a pressure of 1 MPa, while keeping the volume at 2 L by cooling the system. The state reached is labeled C. Then the system is heated at a constant pressure to reach a volume of 6 L in the state B. (a) Find the amount of work on the ACB path. (b) Find the amount of heat exchanged by the system when it goes from A to B on the ACB path. (c) the change in the internal energy when the AB process occurs adiabatically with the AB change though the two-step process on the ACB path.
A Carnot engine working between two heat baths of temperatures 600 K and 273 K completes each cycle in 5 sec. In each cycle, the engine absorbs 10 kJ of heat. Find the power of the engine.
A Carnot engine is used to measure the temperature of a heat reservoir. The engine operates between the heat reservoir and a reservoir consisting of water at its triple point. (a) If 400 J per cycle are removed from the heat reservoir while 200 J per cycle are deposited in the triple-point reservoir, what is the temperature of the heat reservoir? (b) If 400 J per cycle are removed from the triple-point reservoir while 200 J per cycle are deposited in the heat reservoir, what is the temperature of the heat reservoir?
When 400 J of heat are slowly added to 10 mol of an ideal monatomic gas, its temperature rises by 10 . What is the work done on the gas?
Two hundred joules of heat are removed from a heat at a temperature of 200 K. What is the entropy change of the reservoir?
A coal power plant consumes 100,000 kg of coal per hour and produces 500 MW of power. If the heat of combustion of coal is 30 MJ/kg, what is the efficiency of the power plant?