Answered: A volume tank 9m in a diameter and…

A volume tank 9m in a diameter and 1.20m high is filled with water of temp 20°C in 14 minutes and 6 sec. a.) What is the volume flux? b.) And the mass flux (in kilograms per second)?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter13: Energy And Power

Section: Chapter Questions

Problem 5P

See similar textbooks

Related questions

Q: if reference point 1 is 19 m underwater in a pressure tank at 2 atm pressure and reference point 2…

Q: A gas at 20°C may be considered rarefied, deviating from the continuum concept, when it contains…

A: The force exerted to an area can be characterized as pressure. There are numerous different pressure…

Q: The volume of atmospheric water is 12669km3. The evapotranspiration from land is 7200 km3 per month…

Q: At a bemperature of 100°C and an absolute ressure of 5 atmospheres, what is the ratio ne density of…

A: Given that Temperature, T=100oC Temperature, T=100+273 Temperature, T=373 K Pressure, P=5atm Density…

Q: 8. On the side of a 1.83 m diameter tank is a 100 mm diameter orifice. If the orifice draws the…

Q: Water leaving the nozzle at a velocity of 4350 m/min with a volume flow rate of 0.736 m³ . if the…

A: The given data is: Velocity of water leaving nozzle (V1) = 4350 m/min Density of water (ρ) =…

Q: Water is flowing at a critical depth of flow of 1.4 m in a channel as shown in the figure below.…

A: We have to find specific energy in channel. Water flowing at critical depth of flow 1.4 m in a…

Q: What is the specific energy (m-kg/kg) for 1 m depth of flow having velocity of 3 m/s?

A: Given data: Depth of flow, y = 1 m Flow velocity, v = 3 m/s Acceleration due to gravity, g = 9.81…

Q: Question: Determine the kinetic energy of a 25.0 kg mass moving at 61.3 m/s.

A: We have to determine the value of kinetic energy as per the given data in the question like 25 kg…

Q: Water flows out of a hemispherical tank at the constant rate of 18 cu cm per min. If the radius of…

Q: Given data : Depth of flow=2 m Velocity of flow=3 m/s g=10 m/s2 Find specific energy

Q: 2. A centrifugal pump delivers 700 L/s of water against an elevation head of 40m when rotating at…

Q: (3) The geyser "Old Faithful" in Yellowstone National Park rises about 32 m upon eruption. Estimate…

A: Given :- The geyser "Old Faithful" in Yellowstone National Park rises about height = 32 m To…

Q: loving to another question will save this response. con 37 A pressure gage 10.82 m. above the bottom…

A: Given data in question. Pressure Heigth above the base To find out Density of fluid Note…

Q: Calculate the density and specific weight of carbon dioxide at a pressure of 300 kN/m² absolute and…

A: Given carbon dioxide at a pressure of 300kN/m2 absolute and 60o C

Q: Calculate the specific energy of 13 m3/s of water flowing with a velocity of 1.5 m/s in a…

A: Discharge, Q=13m3sec width of rectangular channel=7.5 m velocity of channel=1.5msec Now we know…

Q: The volume of atmospheric water is 12996km3. The evapotranspiration from lan is 72000 km3 per year…

Q: The pump in the figure discharges water at 45 lit/sec. Neglecting losses and elevation changes.…

Q: Kerosine at 20°C flows through the pump in the figure at 0.08 m³/s. Head losses between 1 and 2 are…

A: SG of kerosine at 20°C is 0.804Head of the pump…

Q: 4. BERNOULLI'S ENERGY EQUATION The radius of a water pipe decreases from 10 to 5 cm. If the average…

A: Given :- Radius, r1= 10cm r2= 5cm v1= 4m/s

Q: Determine the kinetic energy flux in watts of 0.02 m3/s of soil (s.g.=0.9) discharging through a…

A: To determine the kinetic energy flux

Q: A fluid flowing in a pipe 30 cm in diameter has a uniform velocity of 4 m/s. The pressure at the…

Q: 10. How can we write energy using the MLT system? a) [M][L]?[T]? b) [M]°[L]?[T]1 c) [M][L]³[T]° d)…

A: Energy= Force × Displacement E= ( MLT^-2) × ( L) E= (M L^2T^-2 )

Q: Water at 68 has a dynamic viscosity of 1 centipoise. Compute its dynamic viscosity and kinematic…

A: The viscosity is defined as the measure of the resistance developed in the fluid against the flow.…

Q: The pump shown creates a water jet oriented to travel a maximum horizontal distance. System friction…

Q: calculate the density and specific weight of carbon dioxide at an absolute pressure of 300 kN/m^2…

A: The density of the carbon dioxide is calculate using the relation, p=ρRT Here, p is the pressure, R…

Q: A pump pumps water from one tank (open to atmosphere) to another tank (open to atmosphere) at a…

A: To find: Water flow through the pipe

Q: Figure provides steady-state operating data for a pump drawing water from a reservoir and delivering…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: A 200-mm diameter pipe 810m long supplies water at a velocity of 2.60 m/s and a pressure of 380kPa.…

A: Bernoulli’s equation formula is a relation between pressure, kinetic energy, and gravitational…

Q: If benzene flows through the pipe line showed in the figure 3, and its velocity where is the benzene…

A: Using continuity equation :vAAA=vBAB8π4(6)2=vBπ4(4)2vB=18fpsso,

Q: Can you also draw the figure A pump delivers water from a lower to a higher reservoir. The…

Q: A volume tank 9m in a diameter and 1.20 m high fill water 20°C in 14 minutes and 6sec. what is the…

Q: A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and…

A: Velocity of jet=25m/s Velocity of vane=10m/s

Q: A coal-fired power plant discharges 1 m^3/s of cooling water into a river, which has a flow of 9…

A: The temperature of the river before mixing is 20 oC and as per the regulation the temperature in the…

Q: How much Megawatts can a motor generate if a 14 kN-m torque transmitted at 5.3 Hz is applied to the…

A: To find the Shaft Power-

Q: A flocculation tank contains 1800 m³ of water, which is mixed using paddles at an average velocity…

A: Given data in question Volume Velocity gradient Temperature Dynamic viscosity To find out…

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A: Given, Pipe length (L) = 15 m Diameter (D) = 30mm or 0.03m Volume flow rate (V˙) = 1 m3/h or…

Q: Example Problem in Pipe System: Water flows from a large reservoir at the rate of 1.20 ft3/s through…

Q: Problem 12.24 In a 1 in 20 model of stilling basin, the height of the hydraulic jump in the model is…

Q: Air in a large tank, at 300 °C and 400 kPa, fl ows through aconverging-diverging nozzle with throat…

A: Given data: Initial temperature of tank T1=300o C = 573 K Initial pressure of tank P, = 400 kPa…

Q: An object is launched at a velocity of 20 m/s in a direction making an angle of 25° upward with the…

A: Given data: Velocity =20 m/s Upward angle =25 degrees

Q: 1.5 kg of gas, R = 518.45 J/kg°K, K = 1.321 undergo a constant volume process from P1= 500 kpa, ti =…

A: Mass(m)=1.5 kg, R=518.45 J/kgoK, K=1.321, P1=500 kpa, P2=1700 kpa.

Q: Calculate the density and specific weight of carbon dioxide at a pressure of 300 kN/m absolute and…

A: To find the Density and Specific weight of carbon dioxide-

Q: A 12.5mm diameter orifice at the vertical side of the tank showed a discharge of 60 liters for every…

Q: A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.83 mm. The nozzle shoots…

Q: A pump helps bring oil (SG = 0.8) to reservoir D from reservoir A at 235 liters per %3D second. The…

A: step1-

Q: A large tank feeds a straight pipe that delivers water to a turbine, and then exits to atmosphere,…

A: The given data is shown below: f=0.01L=100 mD=0.1 mK1=K2=1ρ=1000 kg/m3μ=15×10-3 Ns/m2V=2m/sPower=500…

Q: Determine the kinetic energy flux of 0.02m^3/s of oil (sp. gr. = %3D 0.85) discharging through a…

A: The discharge rate, Q=0.02m3sSpecific gravity of fluid, SG=0.85Diameter of nozzle, ∅=50mm

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

A volume tank 9m in a diameter and 1.20m high is filled with water of temp 20°C in 14 minutes and 6 sec. a.) What is the volume flux? b.) And the mass flux (in kilograms per second)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

SUBJECT :Civil engineering Question: The discharge pressure of a water pump is 9, 000 kPa. The temperature is 150 deg deg C and density is 917 kg/m3. What is the equivalent pump head in meters? A. 11.005 m B. 1,000.5 m C. 1,050.5m D. 1, 100.5 m
FLUID MECHANICS-WATER HAMMER: A valve at the end of a gasoline pipeline is rapidly closed (assume instantaneously). If the gasoline velocity was initially 12m/s, what will be the water hammer pressure rise? The bulk modulus of the gasoline is 715 MPa, and the density of the gasoline is 680 kg/m3.
A volume tank 9m in a diameter and 1.20 m high fill water 20°C in 14 minutes and 6sec. what is the volume flux? And the mass flux (in kilograms per second).
Civil engineering: Energy Please solve the problem clearly , don't use previously solved solutions. I am asking this for a second time. Hope you understand Question: The atmosphere is stable with a lapse rate of -0.2 degree C/100 m. The surfaces air temperature is 15 degree C. A parcel of air is released at the ground with a temperature of 25 degree C. Calculate the maximum mixing height, in m.
A pressure gage 7.5m above the bottom of the tank containing a liquid reads65.45 kPa; another gage at a height of 4m reads 88.45 kPa.What is the densityof the liquid in kg/cu.m?
Air at 1 atm and 20 C flows in a 2-cm-diameter tube. The maximum velocity (m/s) of air to keep the flow laminar is ?
2) From the figure shown below determine how many minutes would it take for the water surface in tank 1 be with the same level with the liquid surface at tank 2? 3.0m 2.0m 2.0m 4,5m 2.00m 65mmø C=0.60
The discharge through a 75mm diameter orifice at the bottom of a large tank was measured to be 1734 liters for every minute. If the head over the orifice remains constant at 5.5m, determine the coefficient of discharge. (A 0.91 В 0.63 0.84 No Answer among the choices (E) 0.72
Question 57 If pressure head of water is 100m and specific gravity of kerosene is 0.81, what is the pressure head- of kerosene?
A pressure gage 7.5m above the bottom of the tank containing a liquid reads 65.45 kPa; another gage at a height of 4m reads 88.45 kPa.What is the densityof the liquid in kg/cu.m?
A bird is flying in a room with a velocity field of V = (u, v, w) = 0.6x i + 0.2t j - 1.4 k (m/s). The room is heated by a heat pump so that the temperature distribution at steady state is T(x, y, z) = 400 0.4y-0.6z-0.2 (5-x)² (°C). Calculate the temperature change that the bird feels after 10 seconds of flight, as it flies through x = 1 m.
Convert 15.14 poises to kinematic viscosity in square meter per second if the liquid has a specific gravity of 0.964