A В R4 3 22k R1 R2 4.7k2 6.8k2 R3 R5 4 10k2 33k2 V1 V2 6.00V 12V

Q: The capacitor is short circuited when carrying out ac small signal analysis. True False

A: Yes for ac small signal analysis capacitors are true.

Q: A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a…

A:

Q: Vp=lov O Vp-/ov 1.okn. UDC 12 Voltuge Determine the max.mum And actass the resistor and sketch the…

A: In this question we need to find a maximum and minimum voltage across resistor and also need to draw…

Q: Questions 16 to 20 (Write True or False) A16 A larger inductor produces a smaller rate of change of…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: In a 132 kV, 50 Hz system, reactance and capacitance up to the location of the circuit breaker is 50…

A: It is given that: V=132 KVf=50 HzXL=5 ΩC=0.02 μF R=500 Ω

Q: 1. For the goven circvil, greph ?,14) i (4) Iov 1202 Vgl4):8 sine 377t VHs

A:

Q: 8. For unitt-shep responses chowa ae figure, find the houfor the system to 20 see E/Dae) fimetion 4.

A:

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A: Given, Capacitance, C=10 μF. Supply voltage, V=110 V. Frequency, f = 50 Hz.

Q: Explain the operation of source free RL circuit with the help of neat circuit diagram and relevant…

A: To explain the operation of source free RL circuit let draw the series RL circuit with the source…

Q: . An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The combination…

A: 6) Given: An ideal conductor of 50mH is connected in series with 175 micro farad capacitor. The…

Q: H.W. For the circuit in Figure below, calculate the low and high-critical frequency. Assumed re' =…

A:

Q: Explain the relation between area, distance and capacitance

A: To explain the relationship between distance ,area  and capacitance i will assume the case of…

Q: 17. In an RC parallel circuit, ET = 240 V, R = 10 kN, and XC = 8.2 k2. What is IC? a. 44 mA b. 29.27…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance .…

Q: 6. Find the total capacitance for the network shown below. C1 C3 C5 JuF C2 6uF C7 9uF C6 JuF 9uF 3uF…

A:

Q: 1. In general, how would the phasor diagram of Figure 2.4 change if the frequency was raised? 2. In…

A: consider the given question;

Q: Q/Exprees the de cinaluunber (85)(-85),2 see complemurst)

A:

Q: A resistor of 20ohms and a capacitance of unknown value when connected in parallel across a 100V,…

A: A resistor of 20 Ohms and a capacitance of unknown value when connected in parallel across a 100 V,…

Q: P 64W 8. 20 Rr 50n

A: The solution can be achieved as follows.

Q: Q5/ A. Design ring counter has the initial state QQ2 QQo = 1010

A:

Q: 5. What value of the current when a capacitor of 10uF connected to a 110V a.c. 50 Hz power supply?…

A:

Q: U gchIC LOgi .. Q/ Given the information provided in figure below, determine: RB Vcc 32.1 µA 2.5 KN…

A: Here it is asked to find the Rb using the informations given. Here some assumptions have been…

Q: "If lab is equal to 595.8252306 and lb is 344296, the phase sequence is:" O POSITIVE NEGATIVE

A: In this question we need to choose a correct option.

Q: Given A = 2ax - 4ay + Azaz and B = 4ax + 7ay-5az. If the angle between A and B is 65 degrees, what…

A: Given:We have:A = 2ax - 4ay + AzazB =4ax +7ay - 5az∠A & B = 65°

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

A:

Q: Use nodal analysis to determine current in the capacitor in the figure below. (40+/50) £2 25/0° V O…

A:

Q: In a series RC circuit, the voltage across the capacitor and the resistor are 60 and 80 volt…

A: Let us take current (I) as reference phasor. The voltage across the resistor(vR) is in phase with…

Q: Current locus for RL circuit with two element variable.

A: For  the given circuit  The current locus is determined as shown below

Q: Antenna Tank Circuit L Germanium Amplifier Diode To Speakers 12 pF - 120 pF Vout 4.7 nF 100 ka R2…

A: Given circuit is - Given table is - Given values of inductance is - L=1μH

Q: Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:

A: Given: A circuit is having Inductive reactance, XL=1022 Ω Resistance, R=985 Ω

Q: The figure below shows a phase shift oscillator with amplitude control. Design  the circuit to…

A: Given: The figure below shows a phase shift oscillator with amplitude control: To find: Design the…

Q: oscillator to a Haw tley How 2 Design oscilloute at 1OMHZ, if the Lz is equal to ten times of Li

A: The Hartley oscillator can be designed with the help of opamp and the Inductor and capacitor value…

Q: Channel 1 and Channel 2 Time (ms) Phase problem. In the above figure the time base is 1 ms/div, what…

A: Given: Time base=1ms/div

Q: Determine the value of Rµ for the maximum power transfer, Pmax to occur and calculate the maximum…

A: Thevinins theorem for DC circuit here   Providing The procedure is quite same for AC also It is also…

Q: Q) Ac bridges are consists of - O Arms and source. Arms, source and detector. O Arms and detector.…

A: As shown in the diagram, An AC bridge network consists of: 1) Four Arms in square shape 2) Detector…

Q: Which of the following is the capacitance of an 88-microfarad and a 108- microfarad starting…

A:

Q: V er to the above diagram. Assume source frequency , magnitude of source voltage, R and L fixed. To…

A:

Q: Please correct and clean solution and both part are solve

A: Given Data VBE= 0.7Vbeta=100VA=50 V

Q: 3) The input of the oscilloscope can be modelled as a capacitor (Cs) in parallel with a 1MQ resistor…

A:

Q: Adpole having anonentp=35ŷ +lont nc m is locaded at Q(r2)-4jinfrespace Find uet pesy

A:

Q: 1. What capacitance when connected in series with a 5000 resistor will limit the current drawn from…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 4) The arms of a four an arm bridge a, b, c and d supplied with a sinusoidal voltage have the…

A: In this question we need to find value of R2 and the frequency at which bridge is balanced

Q: the decrease of voltage gain with frequency 2. the capacitance which effectively appears from input…

A: In this we will write about decrease in voltage gain with frequency...

Q: xplain the physical processes, that occur in RC and RL circuits when there are bursts of voltage…

A: Consider the case of the RC circuit first. As the switch is closed suddenly in a RC circuit, the…

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.