A Thyristor Controlled Series Capacitor (TCSC) consists of a 100 µF capacitor in parallel with TCR with a 7 mH inductor. A) Compute the impedance of the TCSC when the firing angle of the TCR (a) is 115°. Is i capacitive or inductive? B) Compute the impedance of the TCSC when the firing angle of the TCR (a) is 165°. Is i capacitive or inductive? ILT Ic + Vc - Xc XL امشه IL

A Thyristor Controlled Series Capacitor (TCSC) consists of a 100 µF capacitor in parallel with TCR with a 7 mH inductor. A) Compute the impedance of the TCSC when the firing angle of the TCR (a) is 115°. Is i capacitive or inductive? B) Compute the impedance of the TCSC when the firing angle of the TCR (a) is 165°. Is i capacitive or inductive? ILT Ic + Vc - Xc XL امشه IL

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Similar questions

low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
A 5uF capacitor is connected across an emf of 50 Volts maximum value and frequency of 1000 cycles. What is the equation of the current?
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
Discuss the effect of changing the capacitor.
Please explain and make an observation of this capacitor experminent. The Data and Results are also attached below.
A Bipolar capacitor is plugged into an outlet in our house and removed. Can the voltage of this capacitor be measured by DC voltmeter or AC voltmeter ? What can be the voltage value read in the voltmeter?
Which is not true about sample and hold circuit? a. when switch is off, the charge is maintained at the capacitorb. when switch is on, analog input is deposited at the capacitorc. when switch is off the capacitor dischargesd. capactor is the hold circuit
c. If a 480 ?F capacitor is added to the output in the figure, calculate the following:i. Vripple.ii. Average voltage, Vdc.iii. Sketch a graph of the input and output voltage against time of the capacitor. (Built-in-potential of silicon = 0.7V)
A 10 Q resistor is placed in series with a coil of self resistance RL and inductance L and a pure capacitor 'C' across a 50 V variable Ans: 40 Q, frequency supply. The current is maximum and has value of 1 A when the frequency is 500 Hz. At this frequency, voltage across the capacitor is 300 V. Calculate (i) capacitance of the capacitor (ii) resistance and inductance of the coil (iii) Power consumed in the circuit (iv) Voltage across the resistor and the coil. 1.06 µF, 95.5 mH,50 W,10 V,302.7 V
Determine the voltage across capacitor #3 (C3)? Select one: a. 7.2 volts b. 6.36 volts c. 5.65 volts d. 4.8 volts
Ans.a) 79580/Hb)1mH/m Problem: 2.6.12. A galvanometer has a coil resistance of 50 ohms and a current sensitivity of 0.001 micro-ampere per mm. How much is the voltage across its terminals when the deflection is 15 cm at full scale? Ans. 7.5µ V Problem: 2.6.13. A 40-F capacitor is charged to store 0.2 J of energy. An uncharged 60-µF capacitor is then connected in parallel with the first one through perfectly conducting leads. What is the final energy of the system? Ans. 0.12J Problem: 2.6.14. A 40-uF capacitor is connected in parallel with a 60-µF capacitor and across a time-varying voltage source. At a certain instant, the total current supplied by the source is 10 A. Determine the instantaneous currents through the individual capacitors. Ans. 4A and 6A