Using Thevenin Theorem Find Rth, Eth, and current I1

Q: solve the Vds in V as shown, Mosfet if VDD = +20 V and RD=820 ohms, VGS(off) = -5V and IDSS = 10mA

A: Given data: Drain voltage,VDD=+20 V Drain source resistance,RD=820 Ω Turn off gate to source…

Q: Instrumentation amplifier The following circuit is called an instrumental amplifier. It is very…

A:

Q: A feedback control syetm is shown in the figure. Sketch the root locus determining: a) Number of…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Req 3 W m 2 W 6 W www 4 W 8w} W 6 W w 0.5 W 8 W m 3 W www 1 W 1.5 W

A: We need to find out equivalent resistance for given circuit , we will use series and parallel…

Q: 4. Solve for V using Mesh analysis. 120 -15° V ΑΠΩ 120 Ω scoo 62300 Α -j30 ΩΣ 50 Ω

A:

Q: A feedback control syetm is shown in the figure. Sketch the root locus determining: a) Number of…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: For the following circuits a. Find IB, Ic, and IE. b. Determine VB, VC, and VE. c. Calculate VBC and…

A: Given:

Q: 4. Use source transformation to find Vx. 20v +1 92 M 100 (1 52 M +Vx 10A 8₁ (1) 3A

A: Given: Circuit diagram:

Q: 11. Let G[s] = = loop pole at s= -1. (a) K = 0.1 (b) K = 0.2 (c) K = (d) K = (s+3)²+(1)²…

A: The given problem is from control system.  The detailed solution is given in the next steps.

Q: Question-6 c A 415 V, 3-0, Delta connected synchronous motor runs at rated voltage and with an…

A: Given- 415 V, 3-ϕ Delta connected synchronous motor, V=415 V, Excitation emf E=500 V, Synchronous…

Q: Problem 4: What is the impedance of a 100 mH inductor at 150 rads/sec? Express the impedance in both…

A: The given problem is from inductor. The detailed solution is given in the next step

Q: How should you connect a 4 μF capacitor and an 8 μF capacitor so that the 4 μF capacitor has a…

A:

Q: An RC series circuit is connected to a 480 volt, 60Hz line. The apparent power of the circuit is 8.2…

A:

Q: Given that VBE = 0.7 V and using the values from the table: VCC (V) 10 BETA 156 Calculate the…

A:

Q: A circuit consisting of three resistors rated: 10 ohms, 14 ohms and 16 ohms are connected in wye.…

A:

Q: How does real power affect frequency and reactive power affect the voltage of the supply?

A: Concept- Real power, frequency as well as reactive power and voltage of the supply are related to…

Q: The transistor shown has VTH = -0.5 V and kp = 2 mA/V². If VDD = 5 V, determine the Gain of the…

A:

Q: 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 V Figure 3.61 For Prob.…

A: Given data: The nodal analysis circuit is shown below,

Q: Consider an LTI system described by the following equation (the system is initially relaxed) y"(t) +…

A:

Q: Find the inverse z transform of the given function: 22² ²+2 Y (z) = z²-1.5z+0.5

A:

Q: Example 3. Determine vc, iL, and the energy stored in the capacitor and inductor in the circuit of…

A:

Q: Rs 100 £2 www Ls 100 mH b Given: At a frequency of 500 rad/sec, the two circuits shown above have…

A: It is given that:- ω = 500 rad/sec Rs = ? Ls = ?

Q: Consider the periodic continuous-time signal r(t) = g(t) * d (t) where 1-t, -1<t≤0 0<t<1 otherwise…

A:

Q: 3- If we increased 2 bits of the ADC quantizer, what is the improving in the SNR will be? Discussed…

A:

Q: g) Find the power absorbed by the inductor. Mention the unit. h) Find the resonant frequency and…

A: It is given that: V=15 V

Q: Problem 3: A 100 2 resistor and 0.1 mF capacitor are wired in parallel. What is their combined…

A: We need to find out the impedance for given circuit.

Q: 2. For the circuit shown below: a. If XMM2 connected across R2 reads 6V and XMM1 connected across R1…

A: The given circuit can be analysed by using kirchhoff's voltage law and the voltage across any…

Q: Q2. A noisy transmission channel has a per-digit error probability p = 0.01. (a) Calculate the…

A: It is given that: p=0.01q=1-pq=1-0.01q=0.99n=10

Q: or the following circuit find a. Rc. b. RE. . RB. d. VCE. 2. VB. Ra Ga VB 2 mA Rc 07. VCE B: RE 02.

A:

Q: 28-3 Find and sketch all possible inverse Laplace transforms x(t) for X(s) = (s-3)(s+2)* Sketch the…

A: The given problem is from Laplace transform. The detailed solution is given in the next step

Q: Can someone please redo this question in a proper format. Also, recheck the work. I do not…

A: The required parameters can be calculated by using the DC analysis of the given amplifier circuit.

Q: ■ Calculate the current Ic Ic Vs = 100/0⁰ -j5 Ohm 8 Ohm

A: Given data, Circuit diagram is given by,

Q: A causal LTI system has the transfer function H(s) given below: 100000(s + 1) (s +1000) (s + 100000)…

A:

Q: 20 10 Let G[s] s(s+2) reference input is a unit step. (a) 0 (b) 0.5 (c) 1.0 (d) 1.5 = and Ge[s] = K…

A:

Q: Solve for the transfer function v/(1) 110 ΚΩ M v₁ (1) 400 ΚΩ 4 μF + 4μF Vo(s) of the given circuit:…

A: In this question,  We need to determine the transfer function as shown the circuit.  We are solving…

Q: Q5/ Calculate the thermal noise power available from any resistor at room temperature (290°K) for a…

A: Given, Temperature = 290° K  Bandwidth = 2 MHz  Resistance = 100 ohm  So find the thermal noise…

Q: Consider the transistor circuit shown below:- A B If the transistor has ß = 19 and VE = 4V then. C…

A:

Q: Example 1. Find the equivalent capacitance seen between terminals a and b of the circuit in Figure…

A: We need to find out the the equivalent capacitance for the given circuit .

Q: -F¹ negative sequence networks are to be connected at the fault terminals through the impedar ; the…

A: There are three types of asymetrical faults, namely; Line to ground fault Lin to line fault Double…

Q: (a) Ge[s] = (b) Ge[s] = (c) Ge[s] = Let G[s] = (d) Ge[s] = = (s+2) (S-1) (s+1) (S-1) 4(s+1) (s+2)…

A:

Q: Ex8: determine the diode current at 20°C for a silicon diode with n = 2, Is= 0.1 mA at a…

A: 8. Given, Silicon Diode having Temperature (T) = 20°C Ideality factor (n) = 2 Reverse saturation…

Q: Example 2: In the circuit shown in Fig. 4, switch 1 has been in position (a) and switch two has been…

A: This question is based on the transient response of the 2nd order circuit. Initial conditions are…

Q: Given a PMOS with VGs = -0.7V, VDs = -0.5V, VTH = -0.5V, k = 2mA/V² and λ = 0.05, what is the small…

A:

Q: How do I determine the closed loop gain and the rate of fall?

A: The circuit is given as This is an integrator circuit. So that output response will be as low pass…

Q: The nameplate of a single phase motor states that the full load speed is 17,000 rpm. What type of…

A: It is mentioned on the nameplate of the motor that the full load speed of the given single-phase…

Q: - If we used x(+) below and sampled it at 20 KHz, how many Samples would we have after 60 ms? X(t) =…

A:

Q: An RC series circuit has a power factor of 72%. How many degrees are the voltage and current out of…

A: Given, Series RC circuit is having Power factor (pf) = 72% We need to determine the angle of Voltage…

Q: Find the rectangular form of the following complex numbers: (a)-8/210°, (b) 40/305°, (c) 10e -30°,…

A: We need to find out rectangular form of given form .

Q: Determine if each of the following statements is true in general. Provide proofs for those that you…

A: Even signal A signal is referred to as an even if it is identical to its time-reversed counterparts;…

Q: The Pavegen tile has 5 watts per step. Assume that there is 15 steps per minutes in peak hour. The…

A: Electrical energy can be generated using Pavegen Floor Tiles. When people step on tiles, the weight…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.