A three-phase, six-pole, 60 Hz, 230-volt wound rotor motor has its stator connected in delta and its rotor in star. There are 80 percent as many rotor conductors as stator conductors as stator conductors. Calculate the voltage and frequency between slip rings if normal voltage is applied to the stator when, a. the rotor is at rest, b. the rotor slip is 0.042

A three-phase, six-pole, 60 Hz, 230-volt wound rotor motor has its stator connected in delta and its rotor in star. There are 80 percent as many rotor conductors as stator conductors as stator conductors. Calculate the voltage and frequency between slip rings if normal voltage is applied to the stator when, a. the rotor is at rest, b. the rotor slip is 0.042

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

hine. b) In rotating machines, how would the voltages be generated in windings or groups of coils? c) Sketch the Full-bridge driving circuit for the permanent magnet brushless (PMBL) DC motor. Q3/
Q22/ A three phase induction motor with supply frequency of 50 Hz , 10 poles. If the slip is 4 % at a certain load, determine (a) the synchronous speed, (b) the speed of the rotor (c) the frequency of the induced e.m.f in the rotor and speed of the induction motor if the slip changes to 5.75 %
A three-phase induction motor used for a commercial application in Oman runs at 580 rpm at no load and at 552 rpm at full load. a) How many poles do this motor have? b) What is the percentage slip at full load? c) The frequency of the rotor currents when slip is 5 % d) The frequency of the rotor currents at standstill. a) b) c) d)
The armature resistance of a shunt motor fed from a 220 Volt DC source is 5 ohms and the resistance of the excitation winding is R ohm and it rotates stably. Then, a resistance of R ohm is added to the excitation circuit (a resistor with the same value as the winding resistance) to control the speed. How many RPM is the motor in the last state in steady state.Mechanical losses will be neglected, motor magnetically linear, no saturation, temperature change will be neglected.Armature current = Ia = 3 ALoad torque=Tload= 8 Nma) 143 rpmb) 734 rpmc) 1361 rpm d) 77 rpm e) 1333 rpm
Solve it quickly please
1. A 220 V, 60 Hz, 6-pole, 3-phase induction motor has a slip of 3%. Determine the slip speed, and the rotor frequency.
K-1)The speed of a 3-phase wound-rotor induction motor can be changed by varying the amount of resistance in the rotor circuit. a) true b) false K-2). Which of the following statements are true about a 3-phase synchronous motor? a) It is a constant speed motor even under varying loads. b) It runs at the same speed the magnetic field rotates on the stator. c) It can correct its own, and the supply line's power factor d) all of the above K-3. A) What determines the speed of a 3-phase synchronous motor? a) the number of poles b) the frequency of the supply c) both "a" and "b" d) neither "a" nor "b" K-3)B) From a technician's standpoint, which of the following is the most practical method of providing a wide range of speed control for a 3-phase synchronous motor? a) by changing the frequency b) by changing the number of poles c) both "a" and "b" d) neither "a" nor "b"
What do you mean by 'static', 'alternating’, and 'rotating' magnetic field? Explain the significances of the rotating magnetic field in rotary machines. What are the purposes of using starter in a three-phase induction motor? With neat diagrams, explain the operation of a Wye-Delta starter for a three phase induction motor.
The rotor of the 4-pole three-phase squirrel cage induction motor has been replaced with the rotor of the three-phase 4-pole rotor wound induction motor. When the motor is fed with normal supply, the machine will a) Does not work b) Runs at a very slow pace c) Runs at slightly lower speed than normal speed d) Runs at a slightly higher speed than normal speed e) none
Q2] Fill in the blank (9 Marks) 1-The current drwan by the armature of D.C. motor is directly proportional to 2- The speed of a D.C. shunt-wound motor will shunt field regulator is increased. 3- The synchronous speed of a three-phase induction motor is number of pairs of poles. Rotor copper losses Rotor input power in induction motor = 5- A 4-pole three-phase induction motor has a synchronous speed of 25 r.p.s. The frequency of the supply to the stator is_ Hz. 6- The power input to a mains transformer is 200VA. If the primary current is 2.5A, the secondary voltage is 2V and assuming no losses in the transformer, the turns ratio step down. is 7- A 200kVA transformer has an iron loss of 1 kW and full load cu loss of 2 kW. Its load kVA corresponding to maximum efficiency is kVA. 8- If cu loss of a transformer at 7/8th full load is 4900 W, then its full-load cu loss would be watt. 4- if the value of resistance of the proportional to the 9- The slight curvature at the lower end of the open…
18. What is the frequency on the rotor of a 3-phase squirrel-cage induction motor, when the rotor is at a standstill with the stator excited? a) equal to stator frequency b) equal to stator frequency times percent slip c) equal to zero d) none of the above
I need the answer quickly