A telephonic communication service is working at carrier frequency of 10 GHz. Only 10% of it is utilized for transmission. How many telephonic channels can be transmitted simultaneously if each channel requires a bandwidth of 5 kHz?

A telephonic communication service is working at carrier frequency of 10 GHz. Only 10% of it is utilized for transmission. How many telephonic channels can be transmitted simultaneously if each channel requires a bandwidth of 5 kHz?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 78P: The prefix “mega” (M) and “kilo” (k), when referring to amounts of computer data, refer to factors...

See similar textbooks

Related questions

Q: An input of a conventional AM modulator is a 300 kHz signal which supports an amplitude of 30 Vpp.…

A: Consider the given data as below. Carrier amplitude, AC=30 V Modulating signal amplitude, Am=5.0 V

Q: 1) Series Circuit R, 252 80V Rq= 452 V- 20 V I = 10 A %3D T. R, %3D V : V2 IL

Q: A message signal of frequency 10 kHz and peak voltage 10 V is used to modulate a carrier of…

A: Given data: A message signal of frequency is, fm = 10 kHz A message peak voltage is, Vm = 10 V A…

Q: With regard to the Internet and privacy policies and codes, consumer protection groups typically…

A: Required : True or False

Q: A certain type of capacitor is designed to filter low-frequency signals, impeding their transmission…

A: a. the capacitive reactance can be expressed as

Q: Assuming a 60 Hz, how much time – in seconds – is the peak positive current behind the peak positive…

A: Given value--- frequency = 60 Hz. We have to find--- the peak positive voltage when the current…

Q: High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to…

A: Resistance of wire is given as R=ρLA ......(1)

Q: A physics student likes to study while listening to loud music. If electricity costs 12.00$/kWh…

Q: Determine the rms voltage of the given waveform V2 40 V wt 80° 260 440° (b) 20V 23.1V O 28.3V O…

Q: (a) An RLC circuit is used in a radio to tune into an FM station broadcasting at f = 99.7 MHz. The…

A: An RLC circuit is tuned into an FM station. This means that f=99.7 MHz is the resonant frequency and…

Q: (a) An RLC circuit is used in a radio to tune into an FM station broadcasting at f = 99.7 MHz. The…

Q: An output of an analogue soil moisture sensor is ranged from 0 - 3.3 V based on the moisture…

A: "According to Bartleby guideline we can answer only three subparts. Kindly repost the other part…

Q: Using the following diagram to describe the resistor band colors for the following resistor values…

A: a. 10KOhm 1 = Brown 0 = Black K = Orange +-5% = Gold Hence, 10 K Ohm = Brown Black…

Q: (I) What is the reactance of a 6.20μ F capacitor at a frequency of (a) 60.0 Hz, (b) 1.00 MHz?

A: Given, Capacitance, C=6.2μF=6.2×10-6 F.

Q: this number O.080231*10^(- 4) :m can change to nm unit to be 802.31 O 0.80231 *10^(-9) O 802.31…

Q: The capacitance of biological membranes is about 1.0 μF per cm2 of membrane area, so investigators…

A: The current through the membrane, V=IC12πfC Therefore, capacitance is, C=ICV12πf

Q: I1= 100sin (750t+45) A I2=50sin (500t-30) A U=200sin (750t-90) V Plot the waves of the three of…

Q: 4. A sin wave has a great (maximum) value for the Vp=12 v find. а) Уг.m.s b) Ур c) Vayg

A: Peak voltage=Vp=12V

Q: The plates of a flat charged and isolated capacitor departs over time. In the hypothesis of…

A: Displacement current:- A quantity that appears in Maxwell's equations is displacement current. The…

Q: Two resistor 30 k Qand 50 k Qare at room temperature of 30°C. For a bandwidth of 1 MHz, determine…

Q: 20 volts. The slope of the graph In the Potentiometer experiment, let the known emf of the power…

A: A potentiometer is an electric device used to control the EMF and internal resistance of a cell.…

Q: Q1) For the parallel RLC bandpass filter shown in the circuit below: R = 795.774 N, L = 253.303 µH,…

A: Given: The value of the resitor is 795.774 Ω. The value of the inductor is 253.303 μH. The value of…

Q: For the resistor network shown, what fraction of Vs will be measured at Vout? Resistor Combinations…

A: When two resistances are in series , their equivalent resistance is Req = R1 + R2 When two…

Q: Results for this submission Entered Answer Preview Result 001111 001111 incorrect 101000 101000…

A: (a)The initial state of LFSR is s0. The initial value of the LFSR is called the seed, and because…

Q: The capacitance of biological membranes is about 1.0 μF per cm2 of membrane area, so investigators…

Q: i,A garden is rectangular being 22 m wide and 45 m long. How long is a line drawn from one corner to…

Q: Given a capacitor with capacitance 10.0 ± 0.1 µF and a resistor with resistance 10.0 ± 0.2 MΩ. What…

Q: 2) An ultrasound beam with frequency f1 MHz is attenuated by a factor of 20 in passing through a…

A: 2)

Q: clubeu het the muasse f veloities al faryononts ARB be mA,mB P VA VB Then Cousenving snuoadeumm…

A: Here, we need to find mass of fragment A. So, we have use conservation of momentum along x and y…

Q: A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by…

A: The correct option for the following Ques is Option B Ps= 64, Pc = 128, bandwidth = 2khz, and u =…

Q: Compute the power required to service a city 110,000 homes, each of which draws an average current…

A: Given : Current (I) = 18 A Voltage (V) = 118 V Power(P) can be given as : P = V * I For one house,…

Q: The main purpose of an oscilloscope is to graph an electrical signal as it varies over time. Most…

Q: High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to…

A: Given data: Diameter of headphone is, d1=40 mm=40×10-3 m. Thickness of headphone is, L1=2 mm=2×10-3…

Q: (i) What is the accuracy of a measurement of 26.5gm taken as against 25gm? (ii) State the types of…

A: (1) Percentage accuracy = |measured value - accepted value|accepted value * 100…

Q: 90V 90V 9.0V 90V 1000 10.0 0 10.00

A: In first figure, Total voltage V1 = 9.0 + 9.0 = 18v And resistors are connected in series, So…

Q: Given the equation, V – Voe-(2.6x10-3)t, at what time will | %3D oe the voltage drop by its original…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: If an incandescent lightbulb is connected to a 120 V, 60 Hz electric outlet, how many times a second…

A: Current has sinusoidal wave form. So, in one wave there are two peaks (one maximum and one minimum).…

Q: A lossless 75-N coaxial cable has a velocity factor of 0.67. For a shorted line at a frequency of…

A: a) Given data The resistance of the cable is R = 75 Ω. The velocity factor is given as vf = 0.67.…

Q: A sound speaker is rated at a voltage of P = 120.0 V and a current of Icurrent = 8.00 A Electrical…

A: Answer

Q: Resistance R1 from color code = 100 + 5 Ohm Resistance R2 from color code = 74 + 3.7 Ohm Ri and R2…

Q: Show that the rms value for the sawtooth voltage as shown is ΔVmax/√3.

A: The expression for the straight line of a sawtooth voltage is,…

Question

A telephonic communication service is working at carrier frequency of 10 GHz. Only 10% of it is utilized
for transmission. How many telephonic channels can be transmitted simultaneously if each channel
requires a bandwidth of 5 kHz?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

25 analog signals (each is bandlimited to 15kHz) are transmitted simultaneously over a channel via the TDM-PAM system. Compute the TDM output transmission rate.
Lee watchesTV for 2 hours per day. During that time, The TV consumes 200 W per hour. Electricity cost 12 cents per 1 kilowatt hour. How much does lees TV cost to operate from a month of 30 days?
Thirty signals, twenty of them have 4kHz bandwidth, the other have bandwidth of 3 kHz are FDM/SSB multiplexed then modulated by an RF carrier of 800 kHz using AM modulator: 1- Calculate minimum multiplexing and transmission bandwidths. 2- Calculate multiplexing and transmission bandwidths if 0.7 kHz guard band is allowed between each two signals and below the first signal.
A microcontroller ADC uses a 3.3 volt reference and 10 bit resolution. What is the amount of the LSB? 0.33 volts 0.00322 volts 0.0129 volts 0.000805 volts
o 20 V Determine а. VG b. Ipq and VGsQ С. Vр апd Vs d. VpsQ 2.2 k2 910 k2 D Ipss = 10 mA Vp =-3.5 V Vase 110 k2 1.1 k2
A transmitter transmits an AM signal with a carrier frequency of 1470 kHz. When a superheterodyne radio receiver (which has a poor selectivity in its RF-stage bandpass filter) is tuned to 1530 kHz, the signal is heard loud and clear. However, if this radio is cheap, its front-end bandpass filter is not very selective. Thus, the same signal is also heard (not as strongly) when tuned to another carrier frequency setting within the AM range of 535-1605 kHz. State, with reasons, at what frequency you will hear this station. The IF is 455 kHz.
The prefix “mega” (M) and “kilo” (k), when referring to amounts of computer data, refer to factors of 1024 or 210 rather than 1000 for the prefix kilo, and 10242 = 220 rather than 1,000,000 for the prefix Mega (M). If a wireless (WiFi) router transfers 150 Mbps of data, how many bits per second is that in decimal arithmetic?
Explain, why high frequency carrier waves are needed for effective transmission of signals. A message signal of 12 kHz and peak voltage 20 V is used to modulate a carrier wave of frequency 12 MHz and peak voltage 30 V. Calculate the (i) modulation index (ii) side-band frequencies.
Citizen's band (CB) radio utilizes frequencies between commercial AM and FM. What is the frequency of an 11.55 m wavelength CB channel? _______________MHz
6 mins each day using 1000 W microwave. How much does thiS cost over 30days if u are charged $0.10/kWh
FM radio stations are assigned frequencies every 0.2 MHz, but two nearby stations cannot use adjacent frequencies. What is the maximum resistance the tuning circuit can have if the peak current at a frequency of 106.1 MHz, the closest frequency that can be used by a nearby station, is to be no more than 0.100 % of the peak current at 105.7 MHz ? The radio is still tuned to 105.7 MHz, and you can assume the two stations have equal strength.
For an AM envelope with maximum peak a voltage of 52 V and minimum peak to a peak voltage of 24 determine the ff. a. Percent modulation Blank 1 b. Peak voltages of the carrier and side frequenciesBlank 2 Maximum positive to negative с. envelope voltage Blank 3