why multiplexing is impotant for maximum throughput
Q: The input power to a 3-phase star connected load is measured as 19kW. If the line current and power…
A: Given, A 3-phase a.c. circuit star connected load with, Input power, Pin=19 kW Line current, IL=21 A…
Q: Review V: 120 coS Li000) R- 6R RLC circuits L = 2 mH C: 5000 uF W= 1000 : 21€ Find I V: Vmax cos…
A:
Q: A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz).…
A:
Q: 15. A 100µF capacitor in series with a 402 323 1o3 resistance is connected to a 110V. 60 Hz supply.…
A: Solution:-Given thatCapacitance (C)=100 μF=100×10-6 F=10-4 FResistance (R)=40 ΩBoth are connected in…
Q: A guitarist has an amplifier with an output resistance of 8Ω. There are two speakers available, one…
A:
Q: A 34.1μF capacitor is connected to a 9.7 V, 187 Hz source. What is the capacitive reactance (in…
A:
Q: Consider the RLC circuit shown below, where the initial current flowing through the circuit at time…
A: Given that the RLC circuit where the initial current flowing through the circuit at time t = 0 is…
Q: The reactance of a capacitor is 65 Ω at a frequency of 87 Hz.What is its capacitance?
A:
Q: e total inductance at the terminals a-b, for the circuit showH II 25 μΗ 18 μΗ a 20 μΗ 312 µH 60 μΗ…
A:
Q: Q1\ For the circuit shown in Figure (1) below, plot the output waveform (V,). (6M) 10 uF (ideal) V=…
A:
Q: "(a) What is the resistance of a lightbulb that uses an average power of 75.0 W when connected to a…
A:
Q: FM radio stations are assigned frequencies every 0.2 MHz, but two nearby stations cannot use…
A:
Q: A 120-V ,60Hz power source is connected across an 800ohms noninductive resistance and an unknown…
A:
Q: "In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. QUESTION 19…
A:
Q: In the RC-Time Constant Experiment, if the capacitance is 80 f and the resistance is 2.0 ka, then…
A: Given Resistance is given as R=2.0 kΩ=2.0×103 Ω Capacitance is given as C=80 μF=80×10-6 F…
Q: A 300-volt electromotive force is applied to an LR-series circuit in which the resistance is 500…
A:
Q: The two frequencies wi-fi uses a current 2.4 GHz and 5.0 GHz. What are the angular frequency for…
A:
Q: An LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a capacitance…
A:
Q: An RCL circuit connected in series with a resistance of 4 ohms, a capacitor of 1/26 farad, and an…
A: The circuit in which a resistance, a inductance and a capacitance are connected together in series…
Q: Part A) What is the reactance of a 8.2×10−2 μF capacitor connected to a 17 kV (rms), 610 Hz line?…
A: A) xc =1/2πfc =1/2*3.14*610*8.2*10-2μ =3.1818*103 =3181.8ohm…
Q: A resistor of resistance 7 ohm is connected in series with a capacitor of capacitance 50 micro F…
A: Since you have posted a question with a multiple sub parts, we will solve first three sub - parts…
Q: What is the impedance of a series combination of a50-Ω resistor, a 5.0-µF capacitor, and a 10-µF…
A: Given Data: The resistance is, R = 50 Ω. The first capacitance is, C1 = 5 μF. The second…
Q: What is the capacitance of a capacitor with capacitive reactance of 2000 ohm t a frequency of 60 Hz?…
A:
Q: An RLC circuit has an indoctance of 5 M H and a capacitance of 5 micro F. What is the resonany…
A: Given,
Q: The capacitance of biological membranes is about 1.0 μF per cm2 of membrane area, so investigators…
A: The only useful information in this problem is given below: The capacitance of biological membranes…
Q: Vms is always equal to maximum voltage (Vo)
A: RMS value is basically the square root of the mean of the square of the sinusoidal or any other…
Q: In the series circuit R = 200 Q, L = 450 mH, and C = 5.0 µF. The power supply voltage is given by...…
A:
Q: A microcontroller ADC uses a 3.3 volt reference and 10 bit resolution. What is the amount of the…
A:
Q: 26. (a)Design a band stop filter using RC components that will only allow a range of frequencies to…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: The capacitor of 50 µF is connected across 100 V, 50 Hz supply. Calculate 541 (1) reactance, (2)…
A: To find-(1) Reactance (2) Current Given-Capacity os capacitor (C)=50 μFVoltage applied (E)=100…
Q: Calculate the reactance of a 1.0 µF capacitor at: a) 10 Hz Xc = b) 100 Hz Xc = c) 1, 000 Hz Xc = %3D
A: Reactance of a capacitor of capacitance C at frequency f is given by given relation Xc = 1 / (2πf…
Q: output lines according to whether the first number is greater than, equal to, or less than the other…
A: Given: A 4-input, 3-output circuit that compares 2-bit unsigned numbers and output a ‘1’ on one of…
Q: At what frequency will a 4.80-μF capacitor have a reactance of 7.50 kΩ?
A: Resistance,
Q: 2. An insulated cord is made of 2.5 meters long aluminum rod with a diameter of 3.0 mm. what is the…
A: Given, Length L = 2.5 m Diameter d = 3.0 mm Radius r = d/2 = 1.5 mm = 1.5 × 10-3…
Q: The automation of a light is designed by interfacing it with the output port having the address 01H…
A: Solution: First to load the port address to an Accumulator and then move the content to the register…
Q: Let I, r, c and v represent inductance, resistance, capacitance and voltage, 1. respectively. The…
A:
Q: Capacitive reactance is more when O Capacitance is less and frequency of supply is less O…
A:
Q: Determine the following values. (a) The digital equivalent obtained for VA = 3.580V. (b) The total…
A: VA=3.580VFull-scale output 10.23VFrequency =100kHz
Q: A 45.8 F capacitor is connected to a 6.2 V, 208 Hz source. What is the capacitive reactance (in…
A: Capacitor = C= 45.6 FRms value of voltage Vrms=220 vFrequency of sources f=208 Hz
Q: If an incandescent lightbulb is connected to a 120 V, 60 Hz electric outlet, how many times a second…
A: Current has sinusoidal wave form. So, in one wave there are two peaks (one maximum and one minimum).…
Q: Part A gue shows a zeo nce ding to theghon retance sala pedby he deance L-040 The as are connected…
A: It is required to determine the current, the magnetic force.
why multiplexing is impotant for maximum throughput?
Step by step
Solved in 2 steps