A standard penetration test conducted in a saturated coarse silty soil with a Ysat=1.8 g/cc, at a depth of 5 m has yielded a N-value of 12. Find the corrected N-value for design of foundation, if the depth of water table at the time of test was 2 m.

A standard penetration test conducted in a saturated coarse silty soil with a Ysat=1.8 g/cc, at a depth of 5 m has yielded a N-value of 12. Find the corrected N-value for design of foundation, if the depth of water table at the time of test was 2 m.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter17: Subsoil Exploration

Section: Chapter Questions

Problem 17.12P

See similar textbooks

Similar questions

A net contact pressure equals 160 kN/m2 is applied to a stiff clay layer 15 m thick. The footing is 6 m square founded at 2 m depth below ground surface. A layer of silty sand, 2 m thick, overlies the clay and a firm stratum lies immediately below the clay. Oedometer tests on specimens of the clay gave the value of mv =0 13 m2/MN, and triaxial tests gave the value of pore pressure parameter A = 0 35. The undrained Young’s modulus for the clay Eu was estimated equal 55 MN/m2. Determine the total settlement under the footing centre.
Question 3 a) In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Ce= 0.2, C, -0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A shallow foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 50 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.
A triaxial test conducted on cohesionless soil gives the following results: Deviator stress at failure = 410kPa The angle of shearing resistance = 32 degrees Determine the following: a. Confining pressure in kPa b. Shear stress at failure plane in kPa c. Angle that the failure plane makes with the principal plane (degrees)
In a geotechnical laboratory an oedometer test on a saturated clay soil was conducted. The results in the laboratory report stated that the Cc = 0.2, Cr = 0.04 and OCR = 4.5. The existing vertical effective stress in the field was 130 kPa. A building foundation was designed to construct above the soil condition. This will increase the vertical stress at the center of the clay by 150 kPa. The thickness of the clay layer is 2 m and its water content is 28%. Solve the primary consolidation settlement and determine the difference in the settlement if OCR value were 1.5 instead 4.5.
Laboratory tests to determine shear strength parameters generally consists of direct shear and triaxial tests. Table 1 present data obtained from consolidated-undrained tests on a soft clay. Table 1: Triaxial test results At failure Pore water pressure (kN/m²) Cell pressure (kN/m²) Cu 200 400 800 Deviator stress (kN/m²) 117 242 468 110 227 455 Determine the shear strength parameters in terms of effective stress 3 90 ap uu im Cu to 207 415
Give the correct option In a drained triaxial test on consolidated clay the stress and angle are as follows: Deviator stress is 20 lb/in2 and friction angle is 21°. Calculate the effective confining pressure at failure?a) 21 lb/in2 b) 22.2 lb/in2 c) 25.4 lb/in 2 d) 17.9 lb/in2
A consolidated drained tri-axial test was conducted on a normally consolidated clay. The results are as follows: Chamber confining presssure = 138 kPa Deviator stress = 258 kPa a. Compute the friction angle of the soil b. Compute the normal stress at failure c. Compute the shear stress at failure
A triaxial test was performed on a dry. cohesionless sand. The sample fails when the confining stress (minor principal) is 45 kPa and the axial stress (major principal) is 89 kPa. Determine the angle of internal friction Φ for the soil. Adjust your answer to TWO decimal places.
24.A series of consolidated, undrained triaxial tests were carried out on specimens of asaturated clay under no backpressure. The test data at failure are summarized:Confiningpressure (kPa) Deviator stress(kPa) Pore waterpressure (kPa) 150 192 80300 341 154450 504 222 a. Draw the Mohr circles and find the cohesion and friction angles in terms of effectivestresses.b. Compute Skempton’s A- parameter at failure for all three specimens.c. Is the soil normally consolidated or over consolidated? Why?d. Another specimen of the same day that was consolidated under a cell pressure of 250 kPa wassubjected to a consolidated, drained tri axial test. What would be the deviator stress at failure?
In the above figure, the standard penetration test was carried out at a depth of z = 2 m on the sand ground under the foundation base and the obtained SPT N60 value was determined as 21. Calculate the corrected (N1) 60 value at z = 2m depth under the foundation base.At the same time, calculate the elastic settlement in the center of the foundation, the value of Se, using the elastic theory and Hooke's rule on the sand ground in the figure.Take the average Es value for the whole sand layer as 12000 kN / m2. Take the value of the depth factor If as 0.85. According to the results you have calculated, which of the following (N1) gives the values of 60 and elastic settlement, Se.
The figure below shows a surface foundation subjected to a vertical load Q 200 kN and a moment M 50 kN-m. Please answer the following questions: (1) Soil samples from this site are mainly cohesionless sand (e'= 0). A consolidated undrained triaxial test was conducted on one of the samples at a confining pressure o, = 100 kN/m. Failure occurred when the major principal stress a = 200 kN/m with a pore water pressure u = 50 kN/m². Deternine the effective stress angle of friction, ' of the soil accordingly. (10%) (2) Calculate the equivalent load eccentrieity (5%), and cheek if it causes a separation between the foundation and the soil (5%). (3) Use general bearing capacity equation and gffective area method proposed by Meyerhof to estimate the ultimate bearing capacity of the foundation (15%), and check if it meets the required factor of safety for short-term loading (5%). %3D 10-1900EN Lonku IM-4004N-m SokUm Im B-2m.L-2m 7 17 KN m B-
Separate triaxial compression tests are performed on identical soil samples. The soil is a saturated mixed soil. Both tests follow the procedure for consolidated–undrained conditions. At failure, the respective minor and major principal stress values are 20 kPa and 46 kPa for sample one and 40 kPa and 80 kPa for sample two. From these data, determine the value for fCU and the cohesion intercept c on the Mohr’s circle shear stress coordinate. (This problem can be solved graphically using the Mohr’s circle.)