A source generates a pulse of width 100ns and amplitude 3V when it is open circuit. Its output impedance is 50 ohms. The source is connected to a transmission line with a capacitance of 200pF/m and inductance of 125nH/m. What is the amplitude of the pulse when the transmission line is connected to the source, how long (in metres) is the pulse as it travels along the transmission line, and how much energy is stored in the travelling pulse? O The pulse is 1V in amplitude, 20m long, and carries 4n) of energy. O The pulse is 1V in amplitude, 20m long, and carries 2nJ of energy. O The pulse is 3V in amplitude, 30m long, and carries 36n) of energy. The pulse is 1V in amplitude, 30m long, and carries 2nJ of energy.

A source generates a pulse of width 100ns and amplitude 3V when it is open circuit. Its output impedance is 50 ohms. The source is connected to a transmission line with a capacitance of 200pF/m and inductance of 125nH/m. What is the amplitude of the pulse when the transmission line is connected to the source, how long (in metres) is the pulse as it travels along the transmission line, and how much energy is stored in the travelling pulse? O The pulse is 1V in amplitude, 20m long, and carries 4n) of energy. O The pulse is 1V in amplitude, 20m long, and carries 2nJ of energy. O The pulse is 3V in amplitude, 30m long, and carries 36n) of energy. The pulse is 1V in amplitude, 30m long, and carries 2nJ of energy.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
Solve this question using the explanation
R 1. Measure the internal resistance of the 1mH inductor. Set up the given circuit with R = 270n and L = 1mH. Apply a sinusoidal voltage as input. Adjust V, = 4Vpp and set the frequency as 20kHz. Observe the input voltage and the V, L voltage across the inductor simultaneously using an ocilloscope and plot both signals. Find the phase difference between these signals and comment on the results.
Please show the step by step solution. Thank you so much
Previous solution was incorrect...
a) Using your own words, describe how triangular waveforms are produced from sinusoidal waveforms. b) Write a sinusoidal formula that will produce a triangular wavefor y c) Demonstrate your understanding by plotting the formula shown in b using any of the plotting software.
find The average power delivered to * .the circuit
Determine the Inductance that has a Reactance of 2 KOhms, at a frequency of 14.47 KHz. show all the steps
A 1uF capacitor, a 150mH ideal inductor, and a 1.2k ohm resistor are connected in series with a function generator. Find the apparent power of the circuit if the supply voltage is 120V RMS 750HZ. O 1.55 VA O 11.1 VA O 8.75 VA O 25.9 VA
Please help. I need the answer for #2 thank you