A single phase bridge inverter has an RLC load with R= 20 ohms, L= 32 mH and C=0.115 mF. The inverter frequency is fo 60 Hz and DC input voltage is Vs 110 V. If.the RMS magnitude of the output current is 4.46A and the average input current is 3.61A, then the average and RMS current of each transistor are equal to: !! Select one: O a. 1.8A and 2.55A O b. 2.23A and 3.15A e C. None of these d. 1.8A and 3.15A

A single phase bridge inverter has an RLC load with R= 20 ohms, L= 32 mH and C=0.115 mF. The inverter frequency is fo 60 Hz and DC input voltage is Vs 110 V. If.the RMS magnitude of the output current is 4.46A and the average input current is 3.61A, then the average and RMS current of each transistor are equal to: !! Select one: O a. 1.8A and 2.55A O b. 2.23A and 3.15A e C. None of these d. 1.8A and 3.15A

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A single-phase full bridge inverter is fed for a dc source such that fundamental component of output voltage is 230 V. The input frequency is 50 Hz. Find the rms value of MOSFET and diode currents if load is RLC: R=2 Q, L=19 mH, and C=400 µF. *
2) A single-phase full-bridge inverter has a DC voltage source V = 230 V. The rms value of the fundamental component of the output voltage is a- 90 V. b- 207 V. C- 350 V. d- 196 V.
With a single phase full bridge square wave inverter connected to a 24V DC power supply, 50H output frequency AC output is aimed. The load resistance is 10 ohms and the inductor is 250mH. Calculate the maximum value (in milliamps) of the load current. a) 546 b) 474 c) -546 d) -474 e) 323
A single-phase full bridge inverter is fed for a dc source such that fundamental component of output voltage is 230 V. The input frequency is 50 Hz. Find the rms value of MOSFET and diode currents if load is RLC: R=2 0, L=19 mH, and C=400 µF.
A three phase inverter has a Y-connected load. The inverter frequency is fo= 60 Hz and the DC input voltage Vi = 220V. The applied control signal is a 120 deg conduction mode. The RMS magnitude of the fundamental VL1 is equal to 171.53V, then the HF and DF of the Lowest Order Harmonic LOH are equal to: Select one: Oa. 12% and 0.48% b. 20% and 0.8% O c. None of these O d. 20% and 4%
A single phase bridge inverter has an RLC load with R-20 ohm, L32 mit and C-0115 m The inverter frequency is to 60 H and DC input voltage is Vs 110V The average current of each transistor is equal to fontider up to the fifth harmonics in calculation Select on O None of these b 18A Oc 223A Od 6.JA
A single-phase full-bridge inverter feeds a resistive load of 6.4 KW. When the input voltage V,/2 is 200 V, determine: 1) Draw the diagram of the inverter. 2) Rms value of the fundamental component of output voltage. 3) Rms value of the fundamental component of output current. 4) The average and peak current of transistors which are used in inverter. 5) The peak inverse voltage (PIV) of transistors. 6) The waveforms of V, io, and S, (Switch), and vo-
A single-phase full-bridge inverter feeds a resistive load of 6.4 KW. When the input voltage V,/2 is 200 V, determine: 1) Draw the diagram of the inverter. 2) Rms value of the fundamental component of output voltage. 3) Rms value of the fundamental component of K output current. 4) The average and peak current of transistors which are used in inverter. 5) The peak inverse voltage (PIV) of transistors. 6) The waveforms of V, io, and S (Switch), and vo.
Q1. The single phase half bridge inverter has a resistive load of R-24 9 and the de input voltage is Vs 48V. Draw the output voltage and drop voltage across the each switch, then, calculate (a) the rms output voltage at the fundamental frequency Vol (b) The output power Po (c) the average and peak currents of each transistor (d) the THD and (e) the HF and DF of the LOH 02 A) Drau
The load voltage waveform of a single phase full bridge inverter supplied from 30OV DC voltage source is shown in below figure. Output frequency is 50HZ and the load consists of series R-L components. The load vahues are 22 and 0.04H, respectively. (Conduction interval for half period is 120°) 150 100 50 T -50 3 -100 -150 .002 .004 .006 008 .01 .012 .014 .016 .018 .02 Time (sec) a. Calculate and draw the load current for the first two-period interval b. Calculate and draw the load current for the steady-state condition c. Find the RMS values of the load voltage and the load current d Calculate and draw the voltage across the load inductance e. Calculate and draw the source current and find its average vahue
The load voltage waveform of a single phase full bridge inverter supplied from 300V DC voltage source is shown in below figure. Output frequency is 50HZ and the load consists of series R-L components. The load values are 22 and 0.04H, respectively. (Conduction interval for half period is 120°) 150 100 50 T -50 3 -100 -150 .002 .004 .006 .008 .01 .012 .014 .016 .018 .02 Time (sec) a. Calculate and draw the load current for the first two-period interval b. Calculate and draw the load current for the steady-state condition
Show that the THD of the phase voltage of the three-phase inverter square-wave mode is 0.31