A single-phase full bridge inverter is fed for a dc source such that fundamental component of output voltage is 230 V. The input frequency is 50 Hz. Find the rms value of MOSFET and diode currents if load is RLC: R=2 Q, L=19 mH, and C=400 µF.

A commercially available IN4002 diode used in power supplies has the following typical data: (VDI, IDI) = (0.6V, 1mA) (VD2, ID2) = (0.8V, 100mA) Find its reverse saturation current Is and ideality factor n.

A silicon controlled rectifier (SCR) has a forward breakdown voltage of 230 V. When a gate current of 2 mA flows in the gate circuit. If a sinusoidal voltage of 400 V peak is applied, find the following: Firing angle. Average output voltage. Average current for a load resistance of 180 Ohms. Power output

Show the downward shift of the output signal with the series capacitor and diode.Clampers or DC restorers are clamp a peak of a waveform to a specific DC level comparedwith a capacitively coupled signal which swings about its average DC level (usually 0V).If the diode is removed from the clamper, it defaults to a simple coupling capacitor– noWhat is the clamp voltage? And, which peak gets clamped? Why is this so? Voltage values: Capasitor value: 1000 pFDC offset: 0 VAmplitude: 5 VFreq: 1 KHz