A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50 resistor. Calculate (i) Q-factor of the circuit (ii) the new value of capacitance when the value of inductance is doubled and (iii) the new Q- factor.

A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF capacitor and 50 resistor. Calculate (i) Q-factor of the circuit (ii) the new value of capacitance when the value of inductance is doubled and (iii) the new Q- factor.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: The magnetic field intensity outside the ? coaxial cable is H = 00 H = NV/DO H = 1p/2 pi a^20 H =…

A: Given The magnetic field intensity outside the coaxial cable is.....

Q: Output data ratio of a 8-bit PCM-TDM system sampling 24 voice channels, comparing these using u-law…

A: Given- Number of voice channels = 24 , Frequency , f =8 kHz , To find- Output data of 8 bit PCM…

Q: FInd the Value of V2 in the given circuit

Q: The fields circuit of a 200kW, 230 Volts shunt generator is 8 amperes when running full load at…

Q: We define this equation a/ax ax+d/ay ay+d/ ? Əz az as Del operator O Maxwell equation O Gauss's law…

Q: Draw a circuit that uses only one AND gate and one OR gate to realize the following function: (b)…

A: Given Boolean expression is F = WXYZ + VXYZ + UXYZ Asked to draw the circuit using only one AND…

Q: Does the following discrete system have the parameter of memory, y[n] = x[n-1] + x[n] ? O Maybe O…

A: Q.1) Memory system:- A system is said to be memory system if its output is depends on past or…

Q: Given is the buck-boost(Cuk) converter with the following data: Input voltage Vg = 42 V Output…

A: Given Vg=42 V V0=24 V fs=200 kHz R =10 Ω

Q: Solve the following. Show complete solution, complete equation, resistor combination and circuit…

A: Apply Kvl in loop and using ohms law write equation in terms of supply voltage and unknown voltage…

Q: How many bits are approximately required in PCM for a SNqR of 72 dB? 16 08 12 24

Q: 2. A four-pole shunt generator has a wave connected armature with 728 conductors. The flux per pole…

Q: DP 4-3 A wiring circuit for a special lamp in a home is shown in Figure DP 4-3. The lamp has a…

A: Given: Lamp Resistance = 2ΩLamp will light when I≥50mALAmp will Burn out when I≤75mA Find:…

Q: The Insulator has a very small energy gap ? True O False O

Q: Construct a gate circuit using AND, OR, and NOT gates that corresponds one to one with the following…

A: Given expression is F = (WX'+Y)[(W+Z)'+(XYZ')] Logic circuit using AND ,OR & NOT gates =?

Q: Find how many LEDs must be combined to give a total of 1.6 W of visible light output and with the…

Q: 4...

A: Given: Consider the following Simulink diagram: To find: Determine the equation implemented by the…

Q: The motion of a single degree of freedom (SDOF) system is described by 1.50(t) + 30 (t) + 150U (t) =…

A: The 2nd order differential equation is given as 1.5U..t+3U.t+150Ut=51-2.5tHere input.rt=51-2.5t,So,…

Q: The output voltage from an amplifier is 4V. If the voltage gain is 27 dB, calculate the value of the…

A: Output voltge = 4V Voltage Gain = 27 dB We have to determine the value of Vin

Q: A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the…

A: In this question, We need to determine final value of current, current after 4ms and 6ms. We know,…

Q: For two series capacitors, the total ? capacitance is C=C1+C2 True O False O

Q: 2. The current passing through a resistor in a circuit is 0.01 A when the voltage across the same…

A: Given data, I1=0.01 A.V1=5 V.V2=7.5 V.

Q: Complete the following text with words Pt100 sensors are a specific type of _____(1) detector. The…

A: RTDs, also known as resistance temperature detectors, are a family of sensors whose resistance…

Q: Q2] for the following circuit fill in the blanks (answer in phasor form): Vc = 5 sin 10t i 4Ω www…

Q: 2. Find 1₁, 12, 13, and 14. 6A 4₁ 20 (2 10 (2 3A 4052 4022 14 2A

A: Given,

Q: The expression of equivalent impedance (ZN) in the circuit shown below is? 21 ww N

A: Solution !! Explanation: The impedance between the points a and b with the source replaced by a…

Q: E 120 Vrms 60 Hz 30° R1 1002 L1 150m H L OAD R 5002 L 250m H R3 2502 C1 HH 30μF E1 150 Vrms 60 Hz…

A: Given, We need to simulate the given circuit using multisim. circuit is

Q: 1. Using one of the relationships for resistors connected in parallel, solve for the total…

Q: Layer. are assigned to each packet to form a frame in the Data Link IP addresses MAC addresses…

A: As per the honor code we are supposed to answer only the first question. Hence please upload the…

Q: e) The phaser form of v=123cos(50t-30)= 123/-30

Q: 128. A sine wave has a frequency of 50 Hz. Its angular frequency will be A. 50 radians/sec B. 50 n…

A: Given data, Frequency is given as, f=50 Hz.

Q: 1. At 250 K, the activation energy for a gas-phase reaction was determined to be 6.500 kJ mol ¹.…

A: Solution !! The expression in terms of moles for the distribution of molecular energies, nE =…

Q: Determine the Laplace transforms of (a) 2 cosh 3t (b) e−2t sin 3t

A: In this question We need to determine the Laplace transform of the given signals. We know

Q: Q.4 A signal_x(t)= K sinc²(t) + L sinc(2t) is used to form another signal y(t)= K ·[1+x(−Lt+M)]…

A: Please find below the answer.

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

Q: Given the electric flux density (D=0.7 r)^2 ar nC/m^2 in free space, find the total ;charge within…

A: It is given that: D=0.7r2ar nCm2 r=15

Q: 2. If I is equal to 2A, find l en fanden. 202 422 $82 M to 1652

Q: 3. Determine 1₁ and 12 using current division. 12 2010 ent from our this 152 2002

A: Given: Required: I1 and I2

Q: PLEASE ANSWER IT NOW, I NEED THE ANSWER Find the total external armature current of a dc machine…

A: Specification of DC machine is given as No. of Armature slot = 120,ConductorSlot=6,Diameter of…

Q: circuit comprises a 50 resistor, a 5 mH inductor and a 0.04µF capacitor. Determine, in the s-domain…

Q: Determine the bit rate and quantization step of the ADC in the sampling of analog signal with x[n]…

A: We need to find out data rate and step size for given problems , we know direct formula for data…

Q: VS 20 V 햏 Perform mesh analysis and node analysis in the circuit. IT N1 N2 R1 2 ΚΩ R4 3.3 ΚΩ R3 1 ΚΩ…

Q: 9 = B(-1-j2.829) (-1-j2.829 + 1-j2.829) 9 = B(-1-j2.829) (-j5.658) 9 = B(-16 + j0.1768) B =…

A: This is a basic problem of complex equation. The detailed explanation is given in the next step.

Q: For the op-amp shown in the following figure, if R1 = 100 and Rf 1 k2, the overall voltage gain is…

A: The op-amp circuit diagram is shown below, Where,R1=100 ΩRf= 1 kΩ

Q: Consider a hardware timer supplied by a synchronous clock source with a frequency of 250 kHz. How…

A: Given: The frequency of synchronous clock source, f=250 kHz. Number of counts in clock source,…

Q: analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz. The…

A: We need to find out number of bits per sample , first we will find out the number of level then we…

Q: In the circuit shown in the given figure, a current of 5A flows from the supply source. Switch S is…

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: We need to find out the total bandwidth for given signal .

Q: 2. Design a clamper circuit to perform the function indicated. + herh DESIGN Si diodes Vin 10 V -10…

Q: The collector current is 1.5 mA. If the current gain is 50, the base current is

A: Given, Collector current, IC=1.5 mA. Current gain, β=50.

Q: Determine the total resistance at points a and b of the circuit shown below. a www 60Ω 12Ω 30Ω 26Ω…

Question

fast asap

A series RLC circuit which resonates at 400 kHz has 80 μH inductor, 2000 pF
capacitor and 50 resistor. Calculate (i) Q-factor of the circuit (ii) the new value
of capacitance when the value of inductance is doubled and (iii) the new Q-
factor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

List the five capacitor replacement rules.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF)
4. Find Idc, Vdc and the capacitance that will force the Vr(pp) to 2mV. Draw the output waveform across the capacitor. Fin=60HZ. TX1 D1 Ge Vac Lst 230V Lp 1 RL 12-0-12 Center tapped CL 1k D2 Ge 2
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz
Multicolour LED Mono LED Dimensional LED The capacitor in a clamper circuit is in parallel with the voltage source * None True False For the following circuit, the vo waveform is wwwww
Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF) were connected in parallel with the load
From circuit below , what is the impedance value of the inductor if frequency f is 1 kHz?
In the following figure, RLC circuit, add a blue LED to show the process of charging the component, and the red LED to show the process of discharging the energy trapped in the component.
This isn't apart of a test it is a homework question I added an image that contains the figure for this problem An RLC�� circuit with a 15 μF�F capacitor is connected to a variable-frequency power supply with an rms output voltage of 6.8 VV . The rms current in the circuit as a function of the driving frequency appears as in (Figure 1) . Part A What is the value of the resistor? Express your answer to two significant figures and include the appropriate units. figure 1 image for this question. Question 2 John is changing a lightbulb in a lamp. It's a warm summer evening, and the resistance of his damp skin is only 3300 ΩΩ . While one hand is holding the grounded metal frame of the lamp, the other hand accidentally touches the hot electrode in the base of the socket. The voltage of the socket is 120 VV . Use the data shown in (Figure 1) . Part A What is the current through his torso? Express your answer with the appropriate units.
For a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac voltage source of 60V, 2500 Hz, then the magnitude of current through the circuit is Select one: Oa. 3.45A Cb.0915A Oc.None of these O d. 5.45A Next pag umn tr ere to search
By connecting a capacitor parallel to the source in the figure, bring it to resonance. What is the capacitance of this capacitor?